2016 Toyota Camry recalls

• Electrical#2021723November 24, 2021

  55,683 units affected

  Issue: This recall is for certain block heater kits installed on certain vehicles or sold as accessories at Toyota or Lexus dealerships. On certain vehicles, the engine block heater cable may not have enough heat protection and could be damaged by high temperatures. If this happens, the cable could short circuit while plugged in, and cause the wiring to overheat or melt. Note: This recall only affects the following block heater/cord part numbers: C014003034 PK5A408J09 PU14000904 C014003151 PK5A408J13 PU14000905 C014000885 PK5A489J11 PU14000907 C014000888 PK5A489J22 PU14000909 C014000907 PK5A410H00 PU14000911 C014100904 PU14000900 PU14000913 C014100907 PU14000901 PU14003571 C014100911 PU14000902 PK5A489J14 PK5A408J05 PU14000903 Safety Risk: Engine block heater wiring that overheats or melts could create the risk of a fire. Corrective Actions: Toyota recommends that you should stop using the engine block heater immediately. Toyota will notify owners by mail and instruct you to take your vehicle to a dealer to disable the engine block heater. For some vehicles, the corrective actions for this recall are under development. For others, a new engine block heater cannot be installed, and the owner will receive a refund of the purchase price of the engine block heater.

• Electrical#2017363July 20, 2017

  39,189 units affected

  On certain vehicles, the electrical power cords of some dealer installed block heaters may have been improperly manufactured, causing the wires to contact each other, resulting in a short circuit. A short circuit could lead to a fire which would increase the risk of injury and/or damage to property. Correction: For vehicles where the subject block heater was approved for installation, the dealer will replace the block heater assembly with a new one of an improved design. For vehicles where the subject block heater was not approved for installation, dealers will remove the block heater assembly. In the interim, until the remedy can be performed, dealers will cut the plug end from the block heater cord to disable the block heater's operation.

• Powertrain#2017362July 20, 2017

  240 units affected

  On certain vehicles, the tripod joint of the front drive shaft may have been improperly assembled. This could result in the snap ring that holds the tripod joint to dislocate, which could result in vibration and possible separation of the tripod joint, causing a loss of propulsion while driving and an inoperative transmission park system. The loss of propulsion could increase the risk of a crash. Additionally, if the driver exits the vehicle without applying the parking brake, the vehicle could roll away with the transmission in Park, increasing the risk of a crash causing injury and/or damage to property. Correction: Dealers will check the serial number of the drive shafts, and replace as necessary.

• Airbag#2016160April 13, 2016

  1,205 units affected

  Certain vehicles may not comply with the requirements of Canada Motor Vehicle Safety Standard (CMVSS) 208 - Occupant Protection in Frontal Impacts. The front passenger seat's occupant classification system (OCS) may not have been calibrated properly during the manufacturing process. This could result in the non-deployment of the front passenger air bag and the front passenger knee airbag, which would increase the risk of injury to the seat occupant in a crash where airbag deployment is warranted. Correction: Dealers will re-calibrate the occupant classification system.

Canadian data updated August 24, 2026

• EQUIPMENT:OTHER:LABELS#16V420000June 9, 2016

  Southeast Toyota Distributors, LLC (SET) is recalling certain model year 2016 Toyota Camry and Highlander, 2015-2016 Toyota Tundra, Scion FR-S, and tC vehicles. The Load Carrying Capacity Modification Label may not reflect the correct added weight of the installed accessories. As a result, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 110, "Tire Selection and Rims for Passenger Cars."

  Risk: An incorrect label may lead an owner to overload the vehicle, increasing the risk of a crash.

  Remedy: SET will notify owners, and provide a corrected label for placement over the inaccurate label, free of charge. The recall began on July 14, 2016. Owners may contact SET customer service at 1-866-405-4226.

• AIR BAGS:SENSOR:OCCUPANT CLASSIFICATION#16V215000April 14, 2016

  Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain model year 2016 Avalon and Camry vehicles manufactured November 30, 2015 to March 4, 2016. The occupant classification system (OCS) that activates or deactivates the front passenger seat air bag system may have been improperly calibrated. As a result, the front passenger air bag and the front passenger knee air bag may not deploy as intended in certain crash scenarios. As such, these vehicles fail to comply with Federal Motor Vehicle Safety Standard (FMVSS) number 208, "Occupant Crash Protection."

  Risk: Air bags that do not deploy as intended during a crash increase the risk of injury.

  Remedy: Toyota will notify owners, and dealers will recalibrate the OCS, free of charge. The recall began by May 13, 2016. Owners may contact Toyota customer service at 1-888-270-9371. Toyota's number for this recall is G0J.