Skip to content
VINscan

RECALLS — MAKE · MODEL · YEAR

2016 Polaris General 1000 recalls

4 safety recall campaigns have been filed for the 2016 Polaris General 1000 with Transport Canada and the U.S. NHTSA. Here is what both agencies say.

Canadian recalls
04
U.S. recalls
00
Total campaigns
04

Transport Canada recalls

04
  • Fuel System#2020496

    2,284 units affected

    Issue: On certain side-by-side UTVs, the fuel pump flange could crack or the nozzle could separate. If this happens, there could be a fuel leak. Safety Risk: A fuel leak can create the risk of a fire. Corrective Actions: Polaris will notify owners by mail and instruct you to take your vehicle to a dealer to install a protective cover over the fuel pump flange. To reduce the safety risk, Polaris recommends that you should avoid riding your UTV until the recall repairs have been completed.

  • Steering#2017523

    1,634 units affected

    On certain side-by-side UTV’s, the steering shaft may move along the power steering splines, and in some circumstances, the shaft may move far enough to separate from the splines. If the shaft were to separate from the splines during vehicle operation, it would result in a loss of steering control, which could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will replace and increase the torque of the fastener used to attach the steering shaft to the spline. Note: In the interim, owners are advised to stop riding their UTV until the recall repair has been performed.

  • Fuel System#2017101

    914 units affected

    On certain side-by-side UTV’s, the engine may misfire and cause unburned fuel to be routed into the exhaust system. This could result in excessive exhaust heat that may pose a fire hazard which could cause injury and/or damage to property. Correction: Dealers will update the ECU with software that includes misfire detection. Note: In the interim, owners are advised to not operate their vehicle until the defect has been repaired.

  • Brakes#2017100

    1,771 units affected

    On certain side-by-side UTVs, the front brake circuit seal may be swollen due to an error in manufacturing. This could result in unintended brake drag, which could affect vehicle acceleration and cause undesired deceleration, produce excessive brake heat, and premature wear to brake components and could increase the risk of a fire causing injury and/or property damage. Correction: Dealers will check the date code of the master cylinder, and if it falls within the suspect date range, dealers will inspect the master cylinder for contamination and will replace the brake master cylinder as necessary. Note: In the interim, owners are advised to not operate their vehicle until the defect has been repaired.

Canadian data updated August 24, 2026

U.S. NHTSA recalls

00

No recalls found for this make, model, and year.

Does this recall apply to my vehicle?

Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.

What to do

Recall repairs are free at a franchised dealer in both countries. To confirm a recall applies to your specific vehicle, or to book the work, contact your manufacturer or dealer with your full VIN, or use the official channel:

Check a 2016 Polaris General 1000 VIN

A VIN decode confirms your vehicle's exact model year, trim and assembly plant, then runs this same recall check against it.

Data sources and coverage limits