Does the 2016 Peterbilt 325 have any recalls?

Transport Canada lists 1 campaign and the U.S. NHTSA lists 1 for the 2016 Peterbilt 325. Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.

How do I know if a recall applies to my 2016 Peterbilt 325?

Recalls are matched by make, model and model year, but many cover only certain VIN ranges. Confirm with your manufacturer or dealer using your full VIN, or use the official Transport Canada or NHTSA lookup.

Are recall repairs free?

Yes. In both Canada and the United States the manufacturer must fix a recalled defect at no charge, through a franchised dealer.

RECALLS — MAKE · MODEL · YEAR

2016 Peterbilt 325 recalls

2 safety recall campaigns have been filed for the 2016 Peterbilt 325 with Transport Canada and the U.S. NHTSA. Here is what both agencies say.

Canadian recalls: 01
U.S. recalls: 01
Total campaigns: 02

Transport Canada recalls

Steering#2017461September 25, 2017
281 units affected
On certain vehicles, the castellated nut and cotter pin on the steer axle may not have been tightened to specification. This could cause the tie rod to become loose in the steer axle, which would result in audible noise and/or looseness in steering. If the vehicle were continued to be operated in this condition, the tie rod could disconnect from the knuckle, resulting in a complete loss of control of a vehicle wheel, which would increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will inspect the torque of the castellated nuts on the tie rod, and replace the tie rod stud and knuckle as necessary.

Canadian data updated August 24, 2026

U.S. NHTSA recalls

STEERING:LINKAGES:TIE ROD ASSEMBLY#17V593000September 22, 2017
PACCAR Incorporated (PACCAR) is recalling certain 2016 Peterbilt 220, 320, 325, 330, 337, 348, 365, 367, 382, 384, 386, 389, 389G, 567, 579 and 587 trucks and Kenworth K170, T170, T270, T370, T440, T470,T660, T680, T800, T880, and W900 trucks equipped with certain Spicer D or E series steer axles. The castellated nut on the steer axles may not be properly torqued, allowing the tie rod to loosen.
Risk: If the tie rod loosens, it may disconnect from the steering knuckle, causing a complete loss of steering and increasing the risk of a crash.
Remedy: PACCAR will notify owners, and dealers will inspect the torque of the castellated nut and tie rod, tightening it as necessary. If the tie rod stud and knuckle on units cannot be sufficiently torqued, the dealer will replace the knuckle and tie rod end assembly, free of charge. The recall began on November 13, 2017. Owners may contact Peterbilt customer service at 1-940-591-4000 or Kenworth customer service at 1-425-828-5000. PACCAR's number for this recall is P817-C.

Does this recall apply to my vehicle?

Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.

What to do

Recall repairs are free at a franchised dealer in both countries. To confirm a recall applies to your specific vehicle, or to book the work, contact your manufacturer or dealer with your full VIN, or use the official channel:

NHTSA recall lookup (search by VIN) — U.S. National Highway Traffic Safety Administration
Defects and recalls database — Transport Canada

Check a 2016 Peterbilt 325 VIN

A VIN decode confirms your vehicle's exact model year, trim and assembly plant, then runs this same recall check against it.

Data sources and coverage limits →