RECALLS — ALTEC AT200A
Altec AT200A recalls
Altec AT200A model years 2011–2024 covered by at least one recall campaign. Pick a year to see the Canadian and U.S. campaigns side by side.
Choose a model year
U.S. NHTSA campaigns are listed on each year page, where they are queried live by model year. The Canadian list below covers every year together.
Transport Canada recalls
04- Suspension#2025001
47 units affected
Issue: On certain aerial devices, the front axle capacity may be too low. As a result, the vehicle could be overloaded. This could cause poor handling and lead to a loss of control. Note: This recall only affects certain Ford E350 van chassis with gross axle weight rating (GAWR) of 1837 kg (4050 lb.) or 1905 kg (4200 lb.). Safety Risk: A loss of control could create the risk of a crash. Corrective Actions: Altec Industries will notify owners by mail and advise you to contact a Ford dealership or an authorized service facility to install upgraded front coil springs and hardware. Additionally, Altec Industries will provide you with a new compliance label with updated information.
- Structure#2021660
16 units affected
Issue: On certain aerial devices, the legs of the unit mounting frame can develop cracks. If this happens, the mounting frame side plate could break and the pedestal could separate from the truck frame. Safety Risk: A pedestal that separates from the truck frame could create a risk of injury. Corrective Actions: Altec Industries will notify owners by mail and provide them with instructions for how to inspect the mounting frame side plates. If cracks are found, Altec will repair the side plates or provide a repair kit that a qualified service provider can install.
- Structure#2021387
1 units affected
Issue: On a certain aerial device, the wrong bolts may have used to mount the pedestal to the sub-base. As a result, the bolts may fail. If multiple bolts fail, the pedestal and sub-base could separate from the vehicle. Safety Risk: If the pedestal and sub-base separate from the vehicle, there may be a risk of injury. Corrective Actions: Altec will notify the owner by mail and advise them to perform a visual inspection of the bolts that attach the pedestal to the sub-base. If any grade 5 bolts are installed, an inspection should be completed on a daily basis until the fasteners have been replaced. Within 30 days of the initial inspection, the grade 5 fasteners should be replaced with grade 8 bolts.
- Accessories#2015194
3 units affected
On certain aerial devices installed on utility service vehicles (to elevate personnel in order to facilitate working on overhead service lines, for tree trimming, etc.), unintended boom movement could occur due to defective counterbalance valves. This could allow the aerial device to move unexpectedly, which could result in property damage and/or personal injury. Correction: Altec will supply replacement valves along with installation instructions. Owners may contact Altec at 1-877-462-5832.
Canadian data updated August 24, 2026
Does this recall apply to my vehicle?
Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.
What to do
Recall repairs are free at a franchised dealer in both countries. To confirm a recall applies to your specific vehicle, contact your manufacturer or dealer with your full VIN, or use the official channel:
- NHTSA recall lookup (search by VIN) — U.S. National Highway Traffic Safety Administration
- Defects and recalls database — Transport Canada