Does the 2021 Altec AT200A have any recalls?

Transport Canada lists 1 campaign and the U.S. NHTSA lists 2 for the 2021 Altec AT200A. Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.

How do I know if a recall applies to my 2021 Altec AT200A?

Recalls are matched by make, model and model year, but many cover only certain VIN ranges. Confirm with your manufacturer or dealer using your full VIN, or use the official Transport Canada or NHTSA lookup.

Are recall repairs free?

Yes. In both Canada and the United States the manufacturer must fix a recalled defect at no charge, through a franchised dealer.

RECALLS — MAKE · MODEL · YEAR

2021 Altec AT200A recalls

3 safety recall campaigns have been filed for the 2021 Altec AT200A with Transport Canada and the U.S. NHTSA. Here is what both agencies say.

Canadian recalls: 01
U.S. recalls: 02
Total campaigns: 03

Transport Canada recalls

Suspension#2025001January 3, 2025
47 units affected
Issue: On certain aerial devices, the front axle capacity may be too low. As a result, the vehicle could be overloaded. This could cause poor handling and lead to a loss of control. Note: This recall only affects certain Ford E350 van chassis with gross axle weight rating (GAWR) of 1837 kg (4050 lb.) or 1905 kg (4200 lb.). Safety Risk: A loss of control could create the risk of a crash. Corrective Actions: Altec Industries will notify owners by mail and advise you to contact a Ford dealership or an authorized service facility to install upgraded front coil springs and hardware. Additionally, Altec Industries will provide you with a new compliance label with updated information.

Canadian data updated August 24, 2026

U.S. NHTSA recalls

SUSPENSION:FRONT:SPRINGS:COIL SPRINGS#24V952000December 20, 2024
Altec Industries, Inc. (Altec) is recalling certain 2017-2024 Ford E350 van chassis equipped with a AT200A devices. The units mounted on certain Ford E350 van chassis with Gross Axle Weight Rating (GAWR) of 4050 and 4200 pounds, may fail at high loads due to a defect in the front axle.
Risk: Overload of the front axle capacity could cause it to fail and instability, increasing the risk of injury.
Remedy: Ford dealers will install front springs, insulators, and nuts, free of charge. Additionally, a new label will be provided to indicate the upgraded gross axle weight rating. Owner notification letters were mailed February 14, 2025. Owners may contact Altec customer service at 1-877-462-5832. Altec's number for this recall is CSN-3206.
ELECTRICAL SYSTEM#22V469000June 30, 2022
Altec Industries Inc. (Altec) is recalling certain 2016-2022 van mounted AT200A and AT30G vehicles. The ground-fault circuit interrupter (GFCI) outlet may not provide adequate circuit protection against an electrical overload condition.
Risk: An overloaded electrical circuit can increase the risk of a fire.
Remedy: Altec will install a new GFCI outlet with a circuit-breaker and new wiring, free of charge. Owner notification letters are expected to be mailed August 29, 2022. Owners may contact Altec's customer service at 205-991-7733. Altec's number for this recall is CSN 3008.

Does this recall apply to my vehicle?

Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.

What to do

Recall repairs are free at a franchised dealer in both countries. To confirm a recall applies to your specific vehicle, or to book the work, contact your manufacturer or dealer with your full VIN, or use the official channel:

NHTSA recall lookup (search by VIN) — U.S. National Highway Traffic Safety Administration
Defects and recalls database — Transport Canada

Check a 2021 Altec AT200A VIN

A VIN decode confirms your vehicle's exact model year, trim and assembly plant, then runs this same recall check against it.

Data sources and coverage limits →