RECALLS — MAKE · MODEL · YEAR
2012 Winnebago Tour recalls
3 safety recall campaigns have been filed for the 2012 Winnebago Tour with Transport Canada and the U.S. NHTSA. Here is what both agencies say.
- Canadian recalls
- 02
- U.S. recalls
- 01
- Total campaigns
- 03
Transport Canada recalls
02- Steering#2019286
215 units affected
Issue: On certain motorhomes built on a Freightliner XBR chassis, a power steering hose may touch the power stud on the starter motor. This could cause a short circuit and may also cause a power steering fluid leak. This may result in loss of power steering assist. Safety Risk: A power steering fluid leak in the presence of an electrical arc could create the risk of a fire. Additionally, a sudden loss of power assist could make the vehicle difficult to steer and increase the risk of a crash. Corrective Actions: Daimler Trucks North America (DTNA) will notify owners by mail and instruct them to take their motorhome to a DTNA authorized service facility to reroute the power steering hose to ensure it has proper clearance.
- Electrical#2012409
150 units affected
On certain vehicles, the connector for the brake and cruise control signal diode jumper assembly may come loose, resulting in a possible intermittent or continuously open circuit. Two circuits are potentially affected. One circuit disengages the cruise control with brake pedal application, and the other circuit illuminates the brake lights with brake application. Failure of the cruise control to disengage, or of the brake lights to illuminate when the brake pedal is depressed, could result in a crash causing property damage and/or personal injury. Correction: Dealers will verify that the locking tabs on the diode jumper assembly connector are fully engaged and locked into place.
Canadian data updated August 24, 2026
U.S. NHTSA recalls
01- ELECTRICAL SYSTEM#12V566000
Winnebago Industries is recalling certain model year 2010-2013 Winnebago Journey and Tour motorhomes, and certain model year 2010-2013 Itasca Meridian and Ellipse motorhomes, manufactured June 18, 2010, through November 17, 2011. The chassis are equipped with connectors for diode jumpers that may come loose, resulting in an open circuit. Two circuits are affected: The one that disengages the cruise control with brake pedal use, and the one that illuminates the brake lights with brake pedal use.
Risk: Failure of the cruise control to disengage when the brakes are applied may increase the risk of a vehicle crash. Without the brake lights illuminating when the brakes are applied, the driver's intent is not communicated, increasing the risk of a crash.
Remedy: Daimler Trucks North America will be conducting the recall on behalf of Winnebago Industries. Daimler will notify owners, and dealers will inspect the the diode jumpers to make sure they are fully locked in place and will correct the vehicles as needed. The recall began December 26, 2012. Owners should contact Winnebago at 1-641-585-3535 or Daimler Trucks at 1-503-745-6910.
Does this recall apply to my vehicle?
Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.
What to do
Recall repairs are free at a franchised dealer in both countries. To confirm a recall applies to your specific vehicle, or to book the work, contact your manufacturer or dealer with your full VIN, or use the official channel:
- NHTSA recall lookup (search by VIN) — U.S. National Highway Traffic Safety Administration
- Defects and recalls database — Transport Canada
Check a 2012 Winnebago Tour VIN
A VIN decode confirms your vehicle's exact model year, trim and assembly plant, then runs this same recall check against it.