Does the 2017 Volvo VNL have any recalls?

Transport Canada lists 6 campaigns and the U.S. NHTSA lists 5 for the 2017 Volvo VNL. Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.

How do I know if a recall applies to my 2017 Volvo VNL?

Recalls are matched by make, model and model year, but many cover only certain VIN ranges. Confirm with your manufacturer or dealer using your full VIN, or use the official Transport Canada or NHTSA lookup.

Are recall repairs free?

Yes. In both Canada and the United States the manufacturer must fix a recalled defect at no charge, through a franchised dealer.

RECALLS — MAKE · MODEL · YEAR

2017 Volvo VNL recalls

11 safety recall campaigns have been filed for the 2017 Volvo VNL with Transport Canada and the U.S. NHTSA. Here is what both agencies say.

Canadian recalls: 06
U.S. recalls: 05
Total campaigns: 11

Transport Canada recalls

Suspension#2020306July 3, 2020
8 units affected
Issue: On certain trucks, the Gross Axle Weight Rating (GAWR) for rear drive axles exceeds the load rating of the wheel hubs. This could cause the hubs to fail prematurely. If this happens, a wheel could separate from the truck. Safety Risk: A wheel separation could increase the risk of a crash. A wheel that detaches from a vehicle could also create a hazard for other drivers and nearby people. Corrective Actions: Volvo will notify owners by mail and provide them with a new compliance label that has a lower GAWR.
Fuel System#2018532September 26, 2018
258 units affected
On certain trucks built with a Cummins X15 or ISX15 engine equipped with nylon fuel lines and a banjo bolt on the fuel pump, a blockage in the fuel cooling system may cause a fuel line to burst. This could result in a significant fuel leak onto the roadway, which would create a road hazard for other motorists. Additionally, this condition could also cause an engine stall without warning, without the ability to restart the engine. Both of these conditions may increase the risk of a crash causing injury and/or damage to property. Correction: Cummins-authorized dealers will replace the affected nylon line with a steel line.
Brakes#2016643December 20, 2016
127 units affected
On certain vehicles equipped with an electronic air dryer, the operating parameters may have been set incorrectly. This could allow condensation into the air brake system, potentially affecting brake system function in cold weather conditions and increasing the risk of a crash causing injury and/or damage to property. Correction: Dealers will reprogram the vehicle control unit.
Steering#2016641December 20, 2016
15 units affected
On certain vehicles, the front hubs do not support the gross axle weight rating of the front axle. Specifically, 5,987 Kg (13,200 lbs.) rated front hubs were used on trucks requiring a 6,622 Kg (14,600 lbs.) rated front axle. If the axle load exceeds the maximum weight capacity of the hub, there is an increased risk of hub and bearing failure, which could cause a complete separation of the wheel(s) and a loss of vehicle control, increasing the risk of a crash causing injury and/or damage to property. Correction: Dealers will replace the front hub assemblies with hub assemblies rated for 6,622 Kg (14,600 lbs). Note: If damage occurs due to overloading, the ABS Malfunction light may illuminate as the distance between the ABS tone ring and the sensor increases (i.e. sensor loses contact with the tone ring).
Engine#2016282June 3, 2016
2 units affected
On certain vehicles, the Engine Control Module (ECM) may develop an internal electrical short circuit that could blow a fuse in the ECM's electrical supply circuit. This could cause the engine to stall without warning and prevent the vehicle from being restarted. Engine stalling would result in lost propulsion which, in conjunction with traffic and road conditions, and the driver's reactions, could increase the risk of a crash causing property damage and/or personal injury. Correction: Dealers will replace the ECM.
Steering#2016077February 18, 2016
2,809 units affected
On certain vehicles manufactured with a 2-piece steering shaft, the lower or upper steering shaft may disconnect from the coupler. Separation would result in complete loss of steering, increasing the risk of a crash causing injury and/or damage to property. Correction: As an interim measure, dealers will drill a hole through the steering shaft and install a roll pin. When parts become available, dealers will replace the 2-piece steering shaft with a one piece shaft. Note: This recall supersedes recall 2015-561. Vehicles repaired under the previous recall will require re-inspection and potential repair.

Canadian data updated August 24, 2026

U.S. NHTSA recalls

ENGINE AND ENGINE COOLING:ENGINE:DIESEL#18V668000September 25, 2018
Volvo Trucks North America (Volvo) is recalling certain 2016-2019 Volvo VNL trucks equipped with Cummins ISX15 diesel engines. In certain driving conditions, such as on a long down-hill grade, the fuel line may burst if the fuel pump cooling circuit screen becomes restricted.
Risk: If the fuel line bursts, fuel may leak onto the road resulting in a roadway hazard for other motorists. The engine may also stall without warning, resulting in the vehicle's inability to restart, increasing the risk of a crash.
Remedy: Cummins will notify owners, and dealers will replace the single screen filter banjo bolt will be replaced with a dual screen filter banjo bolt, free of charge. The recall began November 21, 2018. Owners may contact Volvo customer service at 1-800-528-6586. Volvo's number for this recall is RVXX1802.
SERVICE BRAKES, AIR#16V928000December 22, 2016
Volvo Trucks North America (Volvo) is recalling certain model year 2013-2017 VNL and VNM trucks and certain model year 2017 VNX trucks. In the affected vehicles, incorrect software for controlling the electronic air dryer may result in oil and water contaminating the brake system.
Risk: If the brake system becomes contaminated, braking performance could be affected, increasing the risk of a crash.
Remedy: Volvo will notify owners, and dealers will reprogram the vehicle control module and replace the air dryer filter, free of charge. The recall began on February 16, 2017. Owners may contact Volvo customer service at 1-800-528-6586. Volvo's number for this recall is RVXX1608.
SUSPENSION:FRONT:HUB#16V927000December 22, 2016
Volvo Trucks North America (Volvo) is recalling certain 2017 Volvo VHD, VNL, and VNM trucks manufactured February 19, 2016, to June 21, 2016. The affected vehicles were built with front wheel hubs that cannot support the gross axle weight rating of the front axle.
Risk: Overloaded front wheel hubs can result in premature failure of the hubs, bearings, and the related components, which can cause the front hub assembly to separate from the front axle. Because of this, the driver may lose control of the vehicle or parts may be dropped on the road, increasing the risk of a crash.
Remedy: Volvo will notify owners, and dealers will replace the hub assemblies, free of charge. The recall began on February 16, 2017. Owners may contact Volvo customer service at 1-800-528-6586. Volvo's number for this recall is RVXX1607.
ENGINE AND ENGINE COOLING:ENGINE:DIESEL#16V393000June 1, 2016
Volvo Trucks North America (Trucks) is recalling certain model year 2017 VNL trucks manufactured March 15, 2016, to April 20, 2016, equipped with a Cummins ISX12 or ISX15 engine using certain engine control modules (ECM). These ECM's may experience an internal electrical short that can cause a fuse to blow, resulting in an unexpected engine stall without the ability to restart the engine.
Risk: An engine stall can increase the risk of a crash.
Remedy: Cummins will notify owners, and Cummins dealers will replace the existing ECM with a new ECM, free of charge. The recall began on July 11, 2016. Owners may contact Cummins customer service at 1-800-343-7357 or Volvo customer service at 1-800-528-6586. Volvo's number for this recall is RVXX1604.
STEERING#16V097000February 17, 2016
Volvo Trucks North America (Volvo) is recalling certain model year 2016-2017 VNL, VNX, and VNM trucks manufactured from May 11, 2015, through April 18, 2016. The trucks may have been manufactured without a roll pin on the steering shafts. If the roll pin is missing, the lower steering shaft may disconnect from the junction block. Also, the bolt connecting the upper steering shaft to the lower steering shaft may not have been properly tightened. Either condition can lead to separation of the steering shaft.
Risk: Separation of the steering shaft will result in complete loss of steering which may lead to a vehicle crash.
Remedy: Volvo is strongly recommending that the affected vehicles not be driven until the interim remedy is applied. An interim notice was sent to Volvo owners on March 16, 2016, and an interim repair is available now. A second notice was mailed on May 13, 2016. The final remedy is now available. Both remedies are free of charge. Owners may contact Volvo customer service at 1-877-800-4945 opt #1. Volvo's recall numbers for this campaign are RVXX1602 and RVXX1603. This recall supersedes safety recall 15V-786.

Does this recall apply to my vehicle?

Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.

What to do

Recall repairs are free at a franchised dealer in both countries. To confirm a recall applies to your specific vehicle, or to book the work, contact your manufacturer or dealer with your full VIN, or use the official channel:

NHTSA recall lookup (search by VIN) — U.S. National Highway Traffic Safety Administration
Defects and recalls database — Transport Canada

Check a 2017 Volvo VNL VIN

A VIN decode confirms your vehicle's exact model year, trim and assembly plant, then runs this same recall check against it.

Data sources and coverage limits →