Skip to content
VINscan

RECALLS — PIERCE ENFORCER

Pierce Enforcer recalls

Pierce Enforcer model years 2010–2026 covered by at least one recall campaign. Pick a year to see the Canadian and U.S. campaigns side by side.

Choose a model year

U.S. NHTSA campaigns are listed on each year page, where they are queried live by model year. The Canadian list below covers every year together.

Transport Canada recalls

06
  • Structure#2026173

    57 units affected

    Issue: Under certain conditions after the fire truck has been auto-leveled, a software problem could cause the firm-on-ground system light to remain on after the rear stabilizer loses contact with the ground. As a result, the fire truck could shift when the aerial device is being used. Note: This recall only affects certain fire trucks equipped with a single rear axle. Safety Risk: A fire truck that shifts while the aerial device is being used could create a risk of injury. Corrective Actions: Pierce will notify owners by mail and provide you with instructions for how to update the vehicle software and perform an aerial device functionality check. Alternatively, you may schedule an appointment to have the software update performed at a Pierce dealership.

  • Fuel System#2022066

    10 units affected

    Issue: On certain fire trucks, the fuel tubes between the fuel rail and the injectors may crack and create a fuel leak. Note: This recall only affects fire trucks equipped with a Cummins X12 diesel engine. Safety Risk: A fuel leak can create the risk of a fire. Corrective Actions: Cummins will notify owners by mail and instruct you to take your fire truck to a Cummins authorized service center to replace the fuel tubes for cylinders 4, 5 and 6 and install vibration isolators.

  • Fuel System#2021324

    97 units affected

    Issue: On certain vehicles, the fuel rail assembly could develop a leak. Note: This recall only affects vehicles equipped with a Cummins L9 or ISX12 diesel engine. Safety Risk: A fuel leak can create the risk of a fire. Corrective Actions: Cummins will notify owners by mail and instruct you to take your vehicle to a Cummins authorized service center to inspect the fuel rail. If damage is found, the fuel rail and fuel lines will be replaced. If no damage is found, the fuel rail will be reassembled with new crush washers.

  • Electrical#2016173

    6 units affected

    Certain vehicles may have improperly installed heater core hose clamps which could allow engine coolant to leak into the passenger compartment and come in contact with electrical components. This could result in an electrical short, causing the vehicle to lose power and increasing the risk of a crash causing injury and/or damage to property. Hot coolant could also come in contact with the occupants of the vehicle and cause burn injuries. Correction: Dealers will inspect and reinstall the hose clamps properly.

  • Powertrain#2016172

    2 units affected

    Certain vehicles may have driveshaft universal joint bearing cap fasteners that were not properly tightened at the time of assembly. This could allow bearing caps to detach from the vehicle and become a road hazard. Additionally, this could cause the universal joint to separate causing a loss of motive power which could increase the risk of a crash causing injury and/or damage to property. Correction : Dealers will inspect and retighten the fasteners as necessary.

  • Suspension#2015005

    6 units affected

    On certain vehicles, the lower control arms may have developed cracks at time of manufacture and may fail. This could cause partial suspension failure and could result in a loss of control, increasing the risk of a crash causing injury and/or property damage. Correction: Owners will be provided with inspection instructions to determine if the control arms may be subject to the recall. Those found to be potentially affected will be inspected by the manufacturer and replaced as necessary.

Canadian data updated August 24, 2026

Does this recall apply to my vehicle?

Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.

What to do

Recall repairs are free at a franchised dealer in both countries. To confirm a recall applies to your specific vehicle, contact your manufacturer or dealer with your full VIN, or use the official channel:

Check a Pierce Enforcer VIN

Data sources and coverage limits