RECALLS — MAKE · MODEL · YEAR
2016 Peterbilt 320 recalls
9 safety recall campaigns have been filed for the 2016 Peterbilt 320 with Transport Canada and the U.S. NHTSA. Here is what both agencies say.
- Canadian recalls
- 04
- U.S. recalls
- 05
- Total campaigns
- 09
Transport Canada recalls
04- Suspension#2022725
375 units affected
Issue: On certain refuse trucks, the tracking rod brackets on the drive axles could break. If this happens, the tracking rod could detach and cause sudden loss of vehicle stability. Safety Risk: A sudden loss of stability could increase the risk of a crash. Corrective Actions: Paccar will notify owners by mail and instruct you to take your truck to a dealership to install reinforcements on the tracking rod brackets.
- Steering#2021006
34 units affected
Issue: On certain trucks equipped with a right-hand stand-up driving position, the steering column may not be properly supported and could come loose from the mounting structure. If this happens, the driver may have difficulty steering the truck. Safety Risk: A loose steering column could cause a loss of control and create the risk of a crash. Corrective Actions: The company will notify owners by mail and instruct you to take your truck to a Peterbilt dealer to inspect, and if necessary, replace the steering column structure. Additional support brackets will also be installed.
- Steering#2017461
281 units affected
On certain vehicles, the castellated nut and cotter pin on the steer axle may not have been tightened to specification. This could cause the tie rod to become loose in the steer axle, which would result in audible noise and/or looseness in steering. If the vehicle were continued to be operated in this condition, the tie rod could disconnect from the knuckle, resulting in a complete loss of control of a vehicle wheel, which would increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will inspect the torque of the castellated nuts on the tie rod, and replace the tie rod stud and knuckle as necessary.
- Engine#2015211
169 units affected
On certain vehicles equipped with Cummins Westport ISL-G engines, excessive engine crankcase pressure could cause the vent tube assembly elbow to detach from the breather. This could allow engine oil to come in contact with hot surfaces, increasing the risk of fire resulting in injury and/or damage to property. Correction: Dealers will install clamps at both ends of the elbow of the breather tube assembly and reprogram the Electronic Control Module (ECM) to improve diagnostic capabilities.
Canadian data updated August 24, 2026
U.S. NHTSA recalls
05- SUSPENSION:MULTIPLE AXLE#22V939000
PACCAR Incorporated (PACCAR) is recalling certain 2015-2023 Peterbilt 320 and 520 refuse trucks equipped with Haulmaax/EX suspensions. The suspension tracking rod brackets may fail and detach from the forward drive axle, causing the axle to become unstable.
Risk: An unstable axle can decrease vehicle stability and control, increasing the risk of a crash.
Remedy: Dealers will inspect the welds and add an additional bracket between the tracking rod bracket and axle housing, as necessary, free of charge. Owner notification letters are expected to be mailed February 14, 2023. Owners may contact Peterbilt's customer service at 1-940-591-4220. PACCAR's number for this recall is 22PBL.
- STEERING:COLUMN#21V004000
PACCAR Incorporated (PACCAR) is recalling certain 2015-2021 Peterbilt 320 and 520 vehicles. The steering column support structure may crack or break in certain right-hand, stand-up drive models.
Risk: If the steering column loosens from the mounting structure, steering control can become affected, increasing the risk of a crash.
Remedy: PACCAR will notify owners, and dealers will inspect the 520 models right hand stand-pp steering column structure and replace it if cracks are present, as well as add additional support brackets to the new (if replaced) or existing structure, free of charge. Additionally, for the 520 models, dealers will install a large gusset with triangulating support for the column bracket, free of charge. Owner notification letters were mailed July 30, 2021. Owners may contact Peterbilt customer service at 1-940-591-4220. PACCAR's number for this recall is 21PBA.
- SERVICE BRAKES, AIR#20V132000
PACCAR Incorporated (PACCAR) is recalling certain 2016-2020 Peterbilt 320 and 520 vehicles with dual foot valves and a liftable tag or tri-drive rear axles. The rear brake signal hose may be missing a quick release valve, possibly causing a delay in their brake release timing. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 121, "Air Disc Brakes."
Risk: A delayed brake release may increase the risk of crash.
Remedy: PACCAR will notify owners, and dealers will check the vehicles for a quick release valve, installing one as necessary, free of charge. The recall began March 24, 2020. Owners may contact PACCAR customer service at 1-940-591-4220. PACCAR's number for this recall is 20PBB.
- EXTERIOR LIGHTING:TURN SIGNAL#19V452000
PACCAR Incorporated (PACCAR) is recalling certain 1990-2020 Peterbilt 320 and 520 vehicles built with specific amber rear turn signals. The turn signals may also light up with the stop/tail lights when the brakes are applied. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 108, "Lamps, Reflective Devices, and Associated Equipment."
Risk: Rear Turn signals that illuminate at the same time as the brake lights may create confusion and impair the effectiveness of the brake lights, increasing the risk of a crash.
Remedy: PACCAR will notify owners, and for trucks with rear amber lights, dealers will add a jumper harness between the chassis electrical harness and amber tail lights, free of charge. The recall began August 1, 2019. Owners may contact PACCAR customer service at 1-940-591-4220. PACCAR's number for this recall is 19PBC.
- STEERING:LINKAGES:TIE ROD ASSEMBLY#17V593000
PACCAR Incorporated (PACCAR) is recalling certain 2016 Peterbilt 220, 320, 325, 330, 337, 348, 365, 367, 382, 384, 386, 389, 389G, 567, 579 and 587 trucks and Kenworth K170, T170, T270, T370, T440, T470,T660, T680, T800, T880, and W900 trucks equipped with certain Spicer D or E series steer axles. The castellated nut on the steer axles may not be properly torqued, allowing the tie rod to loosen.
Risk: If the tie rod loosens, it may disconnect from the steering knuckle, causing a complete loss of steering and increasing the risk of a crash.
Remedy: PACCAR will notify owners, and dealers will inspect the torque of the castellated nut and tie rod, tightening it as necessary. If the tie rod stud and knuckle on units cannot be sufficiently torqued, the dealer will replace the knuckle and tie rod end assembly, free of charge. The recall began on November 13, 2017. Owners may contact Peterbilt customer service at 1-940-591-4000 or Kenworth customer service at 1-425-828-5000. PACCAR's number for this recall is P817-C.
Does this recall apply to my vehicle?
Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.
What to do
Recall repairs are free at a franchised dealer in both countries. To confirm a recall applies to your specific vehicle, or to book the work, contact your manufacturer or dealer with your full VIN, or use the official channel:
- NHTSA recall lookup (search by VIN) — U.S. National Highway Traffic Safety Administration
- Defects and recalls database — Transport Canada
Check a 2016 Peterbilt 320 VIN
A VIN decode confirms your vehicle's exact model year, trim and assembly plant, then runs this same recall check against it.