RECALLS — MAKE · MODEL · YEAR
2021 Nissan Altima recalls
4 safety recall campaigns have been filed for the 2021 Nissan Altima with Transport Canada and the U.S. NHTSA. Here is what both agencies say.
- Canadian recalls
- 02
- U.S. recalls
- 02
- Total campaigns
- 04
Transport Canada recalls
02- Visual System#2023504
14,994 units affected
Issue: On certain vehicles, the rearview camera wiring harness could be damaged by movement and vibrations. If this happens, the rearview camera image may not display correctly or may not display at all. Canadian regulations require the rearview image to display when reversing. Safety Risk: A rearview camera image that doesn't display could reduce a driver's ability to see behind the vehicle while backing up. This could increase the risk of a crash. Corrective Actions: Nissan will notify owners by mail and advise you to bring your vehicle to a dealership to inspect the rearview camera wiring harness, apply a protective tape, and reroute it. If the wiring is damaged, the rearview camera and wiring harness will be replaced.
- Steering#2021117
29 units affected
Issue: On certain vehicles, the steering tie rod nut may not have been properly tightened. As a result, the tie rod could become loose and separate from the steering knuckle. This could result in a loss of steering control. Safety Risk: A loss of steering control could create a risk of a crash. Corrective Actions: Nissan will notify owners by mail and instruct you take your vehicle to a dealer to re-tighten the nut on the left and right steering tie rods. If the nut is missing, a new nut and washer will be installed.
Canadian data updated August 24, 2026
U.S. NHTSA recalls
02- BACK OVER PREVENTION: SENSING SYSTEM: CAMERA#23V628000
Nissan North America, Inc. (Nissan) is recalling certain 2019-2021 Altima and 2020-2021 Sentra vehicles. Damage to the camera harness can cause distortion or loss of the rearview camera display image. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 111, "Rear Visibility."
Risk: A rearview camera that does not properly display an image can reduce the driver's rear view, increasing the risk of a crash.
Remedy: Dealers will inspect the rearview camera and harness for damage and replace them as necessary. If no damage is found, the dealer will apply protective tape and reroute the rearview camera harness. Repairs will be performed free of charge. Owner notification letters are expected to be mailed October 19, 2023. Owners may contact Nissan's customer service at 1-800-867-7669. Nissan's number for this recall is R23C3.
- STEERING:LINKAGES:TIE ROD ASSEMBLY#21V138000
Nissan North America, Inc. (Nissan) is recalling certain 2020-2021 Nissan Altima vehicles. The tie rod ball joint fastener was not tightened properly, which could result in the tie rod ball joint detaching from the steering knuckle.
Risk: A detached tie rod ball joint can cause a loss of steering control, and increase the risk of a crash.
Remedy: Nissan will notify owners, and dealers will tighten the left and right-side tie rod ball joint fasteners, or install new fasteners as necessary, free of charge. The began March 31, 2021. Owners may contact Nissan customer service at 1-800-867-7769. Nissan's number for this recall is PC795.
Does this recall apply to my vehicle?
Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.
What to do
Recall repairs are free at a franchised dealer in both countries. To confirm a recall applies to your specific vehicle, or to book the work, contact your manufacturer or dealer with your full VIN, or use the official channel:
- NHTSA recall lookup (search by VIN) — U.S. National Highway Traffic Safety Administration
- Defects and recalls database — Transport Canada
Check a 2021 Nissan Altima VIN
A VIN decode confirms your vehicle's exact model year, trim and assembly plant, then runs this same recall check against it.