Does the 2013 Mack CXU have any recalls?

Transport Canada lists 13 campaigns and the U.S. NHTSA lists 0 for the 2013 Mack CXU. Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.

How do I know if a recall applies to my 2013 Mack CXU?

Recalls are matched by make, model and model year, but many cover only certain VIN ranges. Confirm with your manufacturer or dealer using your full VIN, or use the official Transport Canada or NHTSA lookup.

Are recall repairs free?

Yes. In both Canada and the United States the manufacturer must fix a recalled defect at no charge, through a franchised dealer.

RECALLS — MAKE · MODEL · YEAR

2013 Mack CXU recalls

13 safety recall campaigns have been filed for the 2013 Mack CXU with Transport Canada and the U.S. NHTSA. Here is what both agencies say.

Canadian recalls: 13
U.S. recalls: 00
Total campaigns: 13

Transport Canada recalls

Steering#2016642December 20, 2016
43 units affected
On certain vehicles, the front hubs do not support the gross axle weight rating of the front axle. Specifically, 5,987 Kg (13,200 lbs.) rated front hubs were used on trucks requiring a 6,622 Kg (14,600 lbs.) rated front axle. If the axle load exceeds the maximum weight capacity of the hub, there is an increased risk of hub and bearing failure, which could cause a complete separation of the wheel(s) and a loss of vehicle control, increasing the risk of a crash causing injury and/or damage to property. Correction: Dealers will replace the front hub assemblies with hub assemblies rated for 6,622 Kg (14,600 lbs). Note: If damage occurs due to overloading, the ABS Malfunction light may illuminate as the distance between the ABS tone ring and the sensor increases (i.e. sensor loses contact with the tone ring).
Powertrain#2016495October 11, 2016
1,690 units affected
On certain vehicles, the cap nut that retains the interaxle driveshaft yoke to the rear axle input shaft may prematurely loosen. If the nut were to loosen and come off, the yoke could separate from the axle input shaft and cause the drive shaft to disconnect. A disconnected drive shaft would result in a loss of motive power, and create a road hazard, both of which could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will inspect the torque on the cap nut, and the nut will be replaced if the torque is found under specification. Note: This is an expansion of recall 2016-079.
Powertrain#2016320June 23, 2016
19 units affected
On certain vehicles, the front axle beam may have been improperly heat treated, affecting material properties. This could lead to fracture of the axle beam at the kingpin, potentially causing lead to a loss of vehicle control and a vehicle crash causing injury and/or damage to property. Correction: Dealers will inspect the axle beam for batch code and serial number markings and replace affected axles. Note: There may be evidence of the beam deforming before the knuckle and king pin loosens from the beam.
Powertrain#2016079February 18, 2016
1,068 units affected
On certain vehicles, the cap nut that retains the interaxle driveshaft yoke to the rear axle input shaft may prematurely loosen. If the nut were to loosen and come off, the yoke could separate from the axle input shaft and cause the drive shaft to disconnect. A disconnected drive shaft would result in a loss of motive power, and create a road hazard, both of which could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will replace the cap nut, and inspect the threads on the input shaft. If the threads are damaged, the input shaft will be replaced.
Structure#2015457October 8, 2015
4 units affected
On certain vehicles, the fifth wheel locking mechanisms could be susceptible to damage and/or wear. This could cause the locking mechanism to fail properly engage, potentially resulting in a towed trailer unit separating from the truck tractor. As a result, the trailer could strike another vehicle, stationary object, or bystander, causing injury and/or damage to property. Correction: Fontaine dealers will replace all Ultra LT fifth wheel units with Ultra NT model fifth wheel units.
Brakes#2015372August 17, 2015
241 units affected
On certain vehicles, The chassis electrical harness and air brake lines may not have been properly secured at the crossmember. This could cause the electrical cables and air lines to fall down and get twisted in the driveline. This could affect safety systems such as brakes, increasing stopping distances or causing unintended parking brake application. This could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will inspect and repair the vehicle as needed.
Accessories#2015100March 10, 2015
71 units affected
On certain vehicles, the fifth wheel remote unlocking switch may not work as designed. As a result, the driver may inadvertently release the 5th wheel latch when the park brake is applied if he/she presses or bumps the switch. This could cause the trailer to decouple from the truck increasing the risk of injury and/or damage to property. Correction: Dealers will add a redundant measure such as an additional switch or adding a thumb lock that requires 2 actions to push the switch.
Electrical#2014527November 20, 2014
11,668 units affected
On certain model vehicles, water around the windshield can migrate into the Electronic Power Distribution Module and contaminate it. As a result, circuits may be bridged creating an electrical short. This could potentially result in a fire, increasing the risk of injury and/or damage to property. Correction: Dealers will inspect the module, and if found contaminated, will replace it. Additional measures will be taken to address the leak if contamination is found. Note: This is an expansion of recall 2014-053.
Lights And Instruments#2014147April 22, 2014
46 units affected
Certain vehicles may not comply with the requirements of Canada Motor Vehicle Safety Standard 108 - Lighting System and Retroreflective Devices. Conspicuity tape applied to the back of the cab may be obscured by exhaust system components to a greater degree than what is allowed by the standard. This could reduce vehicle conspicuity during hours of darkness, potentially increasing the risk of a crash causing injury and/or damage to property. Correction: Dealers will add reflectors if necessary.
Lights And Instruments#2014146April 22, 2014
5,990 units affected
On certain vehicles, the directional/hazard signal flasher may fail. Actuation of the turn signal or hazard lights in this condition would cause them to remain illuminated and not flash as intended. As a result, drivers may not be able to clearly signal their intentions to turn, change lanes or warn others in an emergency situation. Correction: Dealers will replace the turn signal/hazard flasher module.
Powertrain#2013346October 7, 2013
61 units affected
On certain vehicles, spindle nuts may have been installed incorrectly and could loosen, possibly resulting in the hub, wheel and tire assembly separating from the vehicle. This could increase the risk of a crash causing injury and/or property damage. Also, should a wheel separate from the vehicle, it could pose a danger to nearby motorists or bystanders, which could result in injury and/or property damage. Correction: Dealers will inspect and repair vehicles as required.
Brakes#2013161May 10, 2013
906 units affected
On certain trucks, the cotter pin which retains the brake slack adjuster’s clevis pin may have been omitted during vehicle assembly. As a result, the clevis pin could loosen and fall out, causing a loss of brake function at the affected wheel. This could cause the vehicle to pull to one side under braking, or increase stopping distance, which could result in a crash causing property damage and/or personal injury. Correction: Dealers will verify cotter pin installation on each brake slack adjuster. Replacement cotter pins and/or clevis pins will be installed as needed.
Wheels#2012346October 11, 2012
On certain vehicles, the wheel rims may have been manufactured incorrectly and could fail. A wheel separating from the vehicle could cause a loss of control and a crash. In addition, the errant wheel assembly could strike a vehicle, stationary object, or a bystander. These issues could result in property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, replace the wheel rims. Note: Further evaluation revealed that no Canadian vehicles are involved.

Canadian data updated August 24, 2026

U.S. NHTSA recalls

No recalls found for this make, model, and year.

Does this recall apply to my vehicle?

Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.

What to do

Recall repairs are free at a franchised dealer in both countries. To confirm a recall applies to your specific vehicle, or to book the work, contact your manufacturer or dealer with your full VIN, or use the official channel:

NHTSA recall lookup (search by VIN) — U.S. National Highway Traffic Safety Administration
Defects and recalls database — Transport Canada

Check a 2013 Mack CXU VIN

A VIN decode confirms your vehicle's exact model year, trim and assembly plant, then runs this same recall check against it.

Data sources and coverage limits →