Skip to content
VINscan

RECALLS — MAKE · MODEL · YEAR

2010 Mack CXU recalls

16 safety recall campaigns have been filed for the 2010 Mack CXU with Transport Canada and the U.S. NHTSA. Here is what both agencies say.

Canadian recalls
09
U.S. recalls
07
Total campaigns
16

Transport Canada recalls

09
  • Brakes#2015372

    241 units affected

    On certain vehicles, The chassis electrical harness and air brake lines may not have been properly secured at the crossmember. This could cause the electrical cables and air lines to fall down and get twisted in the driveline. This could affect safety systems such as brakes, increasing stopping distances or causing unintended parking brake application. This could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will inspect and repair the vehicle as needed.

  • Electrical#2014527

    11,668 units affected

    On certain model vehicles, water around the windshield can migrate into the Electronic Power Distribution Module and contaminate it. As a result, circuits may be bridged creating an electrical short. This could potentially result in a fire, increasing the risk of injury and/or damage to property. Correction: Dealers will inspect the module, and if found contaminated, will replace it. Additional measures will be taken to address the leak if contamination is found. Note: This is an expansion of recall 2014-053.

  • Lights And Instruments#2014147

    46 units affected

    Certain vehicles may not comply with the requirements of Canada Motor Vehicle Safety Standard 108 - Lighting System and Retroreflective Devices. Conspicuity tape applied to the back of the cab may be obscured by exhaust system components to a greater degree than what is allowed by the standard. This could reduce vehicle conspicuity during hours of darkness, potentially increasing the risk of a crash causing injury and/or damage to property. Correction: Dealers will add reflectors if necessary.

  • Lights And Instruments#2014146

    5,990 units affected

    On certain vehicles, the directional/hazard signal flasher may fail. Actuation of the turn signal or hazard lights in this condition would cause them to remain illuminated and not flash as intended. As a result, drivers may not be able to clearly signal their intentions to turn, change lanes or warn others in an emergency situation. Correction: Dealers will replace the turn signal/hazard flasher module.

  • Electrical#2014053

    2,462 units affected

    On certain model vehicles, water around the windshield can migrate into the Electronic Power Distribution Module and contaminate it. As a result, circuits may be bridged creating an electrical short. This could potentially result in a fire, increasing the risk of injury and/or damage to property. Correction: Dealers will inspect the module, and if found contaminated, will replace it. Additional measures will be taken to address the leak if contamination is found.

  • Lights And Instruments#2012300

    1,168 units affected

    On certain trucks, an electrical short circuit in the fog light circuitry could result in a loss of low beam headlamp function. Loss of headlamp illumination, should it occur during a rainy/snowy day, or during hours of darkness, could compromise the driver’s ability to see the road and its users, which could result in a crash causing property damage and/or personal injury. Correction: Dealers will add an extra wiring harness between the cab harness and the Daytime Running Lamp (DRL) module, in order to isolate the fog light circuit.

  • Other#2011261

    76 units affected

    On certain trucks, the clutch pedal assembly may have been manufactured incorrectly and could fail. This could allow the clutch pedal to fall to the floor, prohibiting clutch operation, and causing a reduction in braking efficiency. Increased stopping distances could result in a crash causing property damage and/or personal injury. Correction: Dealers will replace the clutch pedal assembly.

  • Other#2011146

    42 units affected

    On certain trucks, the bolts used to secure the fifth wheel hitch assembly to the frame may not have received adequate tightening torque during vehicle assembly. This could allow the mounting bolts to fail and the fifth wheel assembly, as well as the trailer, to separate from the tractor. A towed unit separating from the towing vehicle could strike another vehicle, stationary object, or bystander, causing property damage and/or personal injury. Correction: Dealers will inspect the mounting bolts and replace as required.

  • Other#2010370

    368 units affected

    On certain trucks, the rear hold-down brackets that secure the battery box lid may be rotated too far forward, which may restrict the battery box lid from properly locking into place. If this occurs, the battery box lid may come off when stepping on the step, which may cause a person to fall from the vehicle resulting in personal injury. Correction: Dealers will inspect and adjust the rear hold-down brackets as required.

Canadian data updated August 24, 2026

U.S. NHTSA recalls

07
  • EXTERIOR LIGHTING:TURN SIGNAL:FLASHER UNIT#14V208000

    Mack Trucks Inc. (Mack) is recalling certain model year 2010-2014 CHU, CXU, and MRU, 2007 CT and CV, 2008-2014 GU, and 2011-2014 LEU, and TD trucks manufactured February 28, 2006, through November 8, 2013, and equipped Hamsar Electronic Flasher. The hazard warning lights may fail.

    Risk: A failure of the hazard warning lights could reduce the trucks visibility, increasing the risk of a crash.

    Remedy: Mack will notify owners, and dealers will replace the electronic flasher unit, free of charge. The recall will begin by mid-June 2014. Interim letters went out to owners on June 23, 2014. The recall began on July 25, 2014. Owners may contact Mack customer service at 1-866-298-6586. Mack's number for this recall is SC0379.

  • EXTERIOR LIGHTING#14V205000

    Mack Trucks Inc. (Mack) is recalling certain model year 2010-2015 CXU trucks manufactured November 20, 2009, through January 27, 2014, and equipped with dual vertical exhaust pipes. The white conspicuity reflectors on the rear of the cab could be blocked by the exhaust pipes. As such, these vehicles do not conform to Federal Motor Vehicle Safety Standard (FMVSS) number 108, "Lamps, Reflective Devices, and Associated Equipment."

    Risk: A blocked reflector makes the truck-tractor less visible when operating the vehicle without a trailer in the dark, increasing the risk of a crash.

    Remedy: Mack will notify owners, and dealers will inspect the trucks and if the reflectors are blocked, they will add two vertical white reflectors to the rear glass , free of charge. The recall began on May 30, 2014. Owners may contact Mack Customer Service at 1-336-393-2000. Mack's number for this recall is SC0378.

  • ELECTRICAL SYSTEM#14V078000

    Mack Trucks, Inc. (Mack) notified the agency on February 20, 2014, that they are recalling certain model year 2010-2012 CHU, CXU, GU and TD vehicles manufactured from June 16, 2009, through July 8, 2011. While continuing to research the scope of the issue, Mack expanded the recall on November 18, 2014 to include certain model year 2008-2009 and 2013-2014 CHU, CXU, GU and TD vehicles manufactured from June 16, 2009, through July 8, 2011. Having completed its investigation, Mack once again expanded the recall during February 2015 to include an additional 53,780 vehicles from model years 2007 and 2015. The recall now covers model year 2007-2015 includes CHU, CXU, GU and TD vehicles produced October 13, 2006, through October 3, 2014. In the affected vehicles, the Electronic Power Distribution Module (EPDM) may be contaminated from water leaks in, and around, the windshield. If exposed to water leaks, contaminants such as road salts may deposit on the EPDM.

    Risk: Deposits of contaminants may result in the circuits being bridged, creating a high resistance short, increasing the risk of a fire.

    Remedy: Mack has notified owners, and dealers will inspect the EPDM. If contamination has occurred, dealers will replace the EPDM and address the leak, free of charge. Owners of model year 2010-2012 CHU, CXU, GU and TD vehicles were initially notified April 24, 2014. Owners affected by the recall expansions were notified in February 2015. Owners may contact Mack Trucks at 1-336-393-2000. Mack's number for this recall is SC0375.

  • ELECTRICAL SYSTEM:WIRING:FUSES AND CIRCUIT BREAKERS#12V434000

    Mack is recalling certain model year 2007-2010 CHU and CXU vehicles, manufactured from October 13, 2006, through December 23, 2009 and equipped with daytime running lights and fog lights. A short in the fog light circuit may cause the low beam headlight circuit to cut out.

    Risk: If the low beam headlights go out, the driver may lose visibility, increasing the risk of a crash.

    Remedy: Mack will notify owners, and install an additional wiring harness on the affected vehicles, free of charge. The safety recall began on November 14, 2012. Owners may contact Mack Trucks at 1-800-866-1177.

  • POWER TRAIN:CLUTCH ASSEMBLY:PEDAL/HAND LEVER(MOTORCYCLE)#11V370000

    MACK TRUCKS IS RECALLING CERTAIN MODEL YEAR 2010-2011 CHU, CXU AND GU HEAVY TRUCKS MANUFACTURED FROM JULY 12, 2010, THROUGH JULY 23, 2010 FOR A POTENTIALLY DEFECTIVE WELD ON THE SHAFT THAT THE CLUTCH PEDAL ATTACHES TO.

    Risk: IF THE WELD FAILS, THE PEDAL SHAFT MAY WORK ITS WAY LOOSE AND POTENTIALLY CAUSE THE CLUTCH PEDAL TO FALL TO THE FLOOR, WHICH WOULD LIMIT THE DRIVER'S CONTROL OF THE VEHICLE INCREASING THE RISK OF A CRASH.

    Remedy: DEALERS WILL REPLACE THE CLUTCH PEDAL SHAFT FREE OF CHARGE. THE SAFETY RECALL BEGAN ON AUGUST 29, 2011. OWNERS MAY CONTACT MACK TRUCKS AT 1-800-866-1177.

  • TRAILER HITCHES:FIFTH WHEEL ASSEMBLY#11V209000

    MACK TRUCKS IS RECALLING CERTAIN MODEL YEAR 2008-2011 CHU AND CXU HEAVY TRUCKS MANUFACTURED FROM JANUARY 2008 THROUGH JULY 2010. THERE MAY BE AN INTERFERENCE WITH THE BOLTS USED TO SECURE THE FIFTH WHEEL TO THE FRAME THAT CAN PREVENT THE BOLTS FROM BEING TORQUED TO SPECIFICATION.

    Risk: THE BOLTS MAY FAIL AND COULD RESULT IN THE FIFTH WHEEL COMING LOOSE CAUSING THE TRAILER TO SEPARATE FROM THE TRACTOR INCREASING THE RISK OF A CRASH.

    Remedy: DEALERS WILL INSPECT AND REPLACE THE BOLTS AS REQUIRED FREE OF CHARGE. THE SAFETY RECALL BEGAN ON MAY 30, 2011. OWNERS MAY CONTACT MACK TRUCKS AT 1-800-866-1177.

  • ELECTRICAL SYSTEM:12V/24V/48V BATTERY#10V536000

    MACK TRUCKS IS RECALLING CERTAIN MODEL YEAR 2010 THROUGH 2011 CXU, HEAVY TRUCKS MANUFACTURED FROM AUGUST 12, 2009, THROUGH AUGUST 31, 2010. THE REAR HOLD-DOWN BRACKETS THAT SECURE THE BATTERY BOX LID MAY BE ROTATED TOO FAR FORWARD, WHICH MAY RESTRICT THE BATTERY BOX LID FROM PROPERLY SEATING.

    Risk: IF THIS OCCURS, THE BATTERY BOX LID MAY COME OFF WHEN STEPPING ON THE STEP, WHICH MAY CAUSE A PERSON TO FALL FROM THE VEHICLE RESULTING IN PERSONAL INJURY.

    Remedy: MACK WILL INSPECT AND ADJUST THE REAR HOLD-DOWN BRACKETS AS REQUIRED FREE OF CHARGE. THE SAFETY RECALL BEGAN ON DECEMBER 1, 2010. OWNERS MAY CONTACT MACK TRUCKS AT 1-800-866-1177.

Does this recall apply to my vehicle?

Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.

What to do

Recall repairs are free at a franchised dealer in both countries. To confirm a recall applies to your specific vehicle, or to book the work, contact your manufacturer or dealer with your full VIN, or use the official channel:

Check a 2010 Mack CXU VIN

A VIN decode confirms your vehicle's exact model year, trim and assembly plant, then runs this same recall check against it.

Data sources and coverage limits