RECALLS — MAKE · MODEL · YEAR
2014 International Workstar recalls
8 safety recall campaigns have been filed for the 2014 International Workstar with Transport Canada and the U.S. NHTSA. Here is what both agencies say.
- Canadian recalls
- 04
- U.S. recalls
- 04
- Total campaigns
- 08
Transport Canada recalls
04- Engine#2015546
1,466 units affected
On certain vehicles equipped with Navistar engines, the accelerator pedal position sensor could move on its mounting bracket if the pedal is depressed with excessive force. If the sensor stator were to move out of position, it could change the sensor signal output, resulting in a high idle. On vehicles equipped with manual transmissions, if the clutch were to be depressed during operation, the engine could rise to governed RPMs resulting in difficulty selecting gears while shifting. In the condition of a loaded vehicle going down a long grade, the inability to down shift could cause difficulty in maintaining or reducing vehicle speed with just the service brakes, which could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will recalibrate the engine Electronic Control Module (ECM) to eliminate the high idle condition.
- Electrical#2015171
8,552 units affected
On certain vehicles, a double battery (24 volt) jump start or electrical load dump could result in an overvoltage condition of the linear power module (LPM) which is used to control the heater/air conditioning blower motor speed. If this were to occur, this overvoltage condition could lead to the LPM overheating, causing smoke, and increase the risk of fire, which could result in injury and/or damage to property. Correction: Dealers will replace the LPM with an upgraded design.
- Lights And Instruments#2014574
11 units affected
Certain vehicles may not comply with the requirements of Canada Motor Vehicle Safety Standard 108 - Lighting System and Retroreflective Devices. Headlight electrical connections may have been reversed at time of assembly, causing reduced headlight photometric output. This could cause the vehicle to fail to comply with the requirements of the standard, decreasing driver visibility and increasing the risk of a crash causing injury and/or property damage. Correction: Dealers will correct the wiring.
- Brakes#2014141
169 units affected
On certain vehicles equipped with air disc brakes, the brake caliper bolts may have been insufficiently tightened, or an insufficient number of bolts may have been installed at time of vehicle assembly. Loose or missing bolts could allow a caliper to detach from its mount, resulting in partial loss of brake function, which could increase stopping distance and increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will replace missing bolts, if any, and tighten all caliper bolts to the specified torque.
Canadian data updated August 24, 2026
U.S. NHTSA recalls
04- VEHICLE SPEED CONTROL:ACCELERATOR PEDAL#15V776000
Navistar, Inc. is recalling certain model year 2013-2014 International ProStar and DuraStar trucks manufactured April 26, 2012, to April 4, 2013, WorkStar trucks manufactured April 27, 2012, to March 29, 2013, LoneStar trucks manufactured May 21, 2012, to April 2, 2013, and TranStar trucks manufactured April 30, 2012, to March 25, 2013. In the affected vehicles, the accelerator pedal position sensor can move and result in a high engine idle.
Risk: A high engine idle may make downshifting the transmission difficult and the engine brake may be disabled. These factors may hinder slowing down the truck when descending a long grade, thereby increasing the risk of a crash.
Remedy: Navistar will notify owners, and dealers will recalibrate the electronic control module (ECM) to allow it to recognize that the pedal is at the idle position, free of charge. The recall began on January 19, 2016. Owners may contact Navistar customer service at 1-800-448-7825. Navistar's number for this recall is 15517.
- VISIBILITY:DEFROSTER/DEFOGGER/HVAC SYSTEM:FAN/MOTOR#15V241000
Navistar, Inc. (Navistar) is recalling certain model year 2011-2015 International DuraStar, ProStar, TranStar and WorkStar, 2012-2015 International TerraStar, 2013-2015 International LoneStar and IC Bus HC, and 2014-2015 IC Bus AC vehicles. A vehicle double battery jump start or electrical load dump event could result in an overvoltage condition of a component within the HVAC system linear power module (LPM) which is used to control the blower speed. The overvoltage condition could result in the overheating and failure of the LPM.
Risk: If the LPM overheats and fails, there is an increased risk of a fire.
Remedy: Navistar will notify owners, and dealers will replace the LPM with an upgraded one, free of charge. An interim letter was mailed to owners on June 18, 2015. A second notification will mailed when parts become available. The recall began on August 6, 2015. Owners may contact Navistar customer service at 1-800-448-7825. Navistar's number for this recall is 15509.
- EXTERIOR LIGHTING:HEADLIGHTS#14V807000
Navistar, Inc. (Navistar) is recalling certain model year 2013-2015 International WorkStar vehicles manufactured March 16, 2012, to October 1, 2014. In the affected vehicles, the headlight low beam and ground circuits may have been reversed at the headlight connector resulting in reduced light output. As such, these vehicles fail to comply with Federal Motor Vehicle Safety Standard (FMVSS) No. 108, "Lamps, Reflective Devices, and Associated Equipment."
Risk: Reduced light output may impair the driver's vision, increasing the risk of a crash.
Remedy: Navistar will notify owners, and dealers will correct the wiring in headlight harness connector, free of charge. The recall began on December 29, 2014. Owners may contact Navistar customer service at 1-800-448-7825. Navistar's number for this recall is 14525.
- SERVICE BRAKES, AIR:DISC:CALIPER#14V201000
Navistar, Inc. (Navistar) is recalling certain model year 2013-2015 International DuraStar vehicles manufactured November 2012 through December 2013, International WorkStar vehicles manufactured December 2012 through January 2014, and 2014-2015 International TranStar and International ProStar vehicles manufactured January 2013 through February 2014. The affected vehicles are built with air disc brake feature codes 04WEY, 04WEZ, or 04WZK. These vehicles may have an incorrect number of bolts mounting the brake caliper to the caliper mounting plate and some of the bolts may be improperly torqued.
Risk: If the air disk brake caliper has loose or missing bolts, the air disk brake caliper may come loose from the mounting plate causing the vehicle to pull left or right while braking and lengthening the distance needed to stop, increasing the risk of a crash.
Remedy: Navistar will notify owners, and dealers will replace any missing bolts and check the torque of all of the air disk brake caliper bolts, free of charge. The recall began on May 7, 2014. Owners may contact Navistar customer service at 1-800-448-7825. Navistar's number for this recall is 14508.
Does this recall apply to my vehicle?
Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.
What to do
Recall repairs are free at a franchised dealer in both countries. To confirm a recall applies to your specific vehicle, or to book the work, contact your manufacturer or dealer with your full VIN, or use the official channel:
- NHTSA recall lookup (search by VIN) — U.S. National Highway Traffic Safety Administration
- Defects and recalls database — Transport Canada
Check a 2014 International Workstar VIN
A VIN decode confirms your vehicle's exact model year, trim and assembly plant, then runs this same recall check against it.