Does the 2010 International 4200 have any recalls?

Transport Canada lists 1 campaign and the U.S. NHTSA lists 1 for the 2010 International 4200. Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.

How do I know if a recall applies to my 2010 International 4200?

Recalls are matched by make, model and model year, but many cover only certain VIN ranges. Confirm with your manufacturer or dealer using your full VIN, or use the official Transport Canada or NHTSA lookup.

Are recall repairs free?

Yes. In both Canada and the United States the manufacturer must fix a recalled defect at no charge, through a franchised dealer.

RECALLS — MAKE · MODEL · YEAR

2010 International 4200 recalls

2 safety recall campaigns have been filed for the 2010 International 4200 with Transport Canada and the U.S. NHTSA. Here is what both agencies say.

Canadian recalls: 01
U.S. recalls: 01
Total campaigns: 02

Transport Canada recalls

Powertrain#2010202June 15, 2010
409 units affected
On certain vehicles equipped with an INTERNATIONAL® VT365 engine, the engine calibration normally responds to a failed open accelerator position sensor circuit fault by returning the engine to low idle speed of 800 rpm and disabling the driver's ability to increase the engine speed. However, If the open circuit condition corrects itself within 30 seconds of its initiation the engine calibration misinterprets this event by going into a "limp home mode" where the engine speed is increased from low idle speed to the high idle speed of 1200 rpm. This increase to high idle speed may occur without warning causing a sudden and unexpected shift in vehicle position possibly resulting in property damage, personal injury or death. Correction: Dealers will install an updated engine calibration.

Canadian data updated August 24, 2026

U.S. NHTSA recalls

VEHICLE SPEED CONTROL#10V267000June 15, 2010
NAVISTAR IS RECALLING CERTAIN MODEL YEAR 2003 THROUGH 2010 INTERNATIONAL TRUCKS AND IC COMMERCIAL BUSES MANUFACTURED FROM DECEMBER 4, 2001 THROUGH DECEMBER 14, 2009 EQUIPPED WITH INTERNATIONAL VT365 ENGINES HAVING ENGINE CALIBRATION PAN2PVR0, PAN2PVR1, OR PAN2PWR. THE ENGINE NORMALLY RESPONDS TO A FAILED OPEN ACCELERATOR POSITION SENSOR CIRCUIT FAULT BY RETURNING THE ENGINE TO LOW IDLE SPEED OF 800 RPM AND DISABLING THE DRIVER'S ABILITY TO INCREASE THE ENGINE SPEED. HOWEVER IF THE OPEN CIRCUIT CORRECTS ITSELF WITHIN 30 SECONDS OF INITIATION, ENGINE SPEED COULD SUDDENLY INCREASE TO A HIGH IDLE SPEED OF 1200 RPM.
Risk: THIS INCREASE TO HIGH IDLE SPEED MAY OCCUR WITHOUT WARNING CAUSING A SUDDEN AND UNEXPECTED SHIFT IN VEHICLE POSITION POSSIBLY RESULTING IN PROPERTY DAMAGE, PERSONAL INJURY, OR DEATH.
Remedy: NAVISTAR WILL NOTIFY OWNERS AND DEALERS WILL REPAIR THE VEHICLES FREE OF CHARGE. THE SAFETY RECALL BEGAN ON JULY 1, 2010. OWNERS MAY CONTACT NAVISTAR AT 1-800-448-7825.

Does this recall apply to my vehicle?

Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.

What to do

Recall repairs are free at a franchised dealer in both countries. To confirm a recall applies to your specific vehicle, or to book the work, contact your manufacturer or dealer with your full VIN, or use the official channel:

NHTSA recall lookup (search by VIN) — U.S. National Highway Traffic Safety Administration
Defects and recalls database — Transport Canada

Check a 2010 International 4200 VIN

A VIN decode confirms your vehicle's exact model year, trim and assembly plant, then runs this same recall check against it.

Data sources and coverage limits →