Freightliner Coronado recalls

• Steering#2023083February 20, 2023

  3,460 units affected

  Issue: On certain trucks, the joint connecting the steering arm to the drag link may not have been properly tightened. As a result, the joint could loosen and separate, causing a loss of steering control. Safety Risk: A loss of steering control could create the risk of a crash. Corrective Actions: Daimler Truck North America (DTNA) will notify owners by mail and instruct you to take your truck to a DTNA authorized service facility to inspect the castle nut on the drag link taper joint. The nut will be checked for the correct torque, and tightened or repaired, as necessary.

• Accessories#2023046February 9, 2023

  27 units affected

  Issue: On certain trucks, the pivot bolt for the foldable upper bunk may not have been properly tightened. As a result, the upper bunk could collapse and drop down on top of a person using the bottom bunk. Safety Risk: An upper bunk that falls could create a risk of injury. Corrective Actions: Daimler Truck North America (DTNA) will notify owners by mail and instruct you to take your truck to a DTNA authorized service facility to replace and tighten the pivot bolts for the foldable upper bunk.

• Lights And Instruments#2020158April 14, 2020

  873 units affected

  Issue: On certain trucks equipped with "Fleet Engineer" mud flaps, the bracket for the mud flaps may partially cover the rear reflective tape. Canadian regulations require that reflective tape must be visible on the rear of the truck. Safety Risk: Reflective tape that is covered may make the truck less visible to others and could create an increased risk of a crash. Corrective Actions: Daimler Trucks of North America (DTNA) will notify owners by mail and instruct you to take your truck to an authorized DTNA Service Facility to inspect the reflective tape. It will be moved as necessary to meet the regulations.

• Fuel System#2018469August 31, 2018

  259 units affected

  On certain trucks built with a Cummins X15 or ISX15 engine equipped with nylon fuel lines and a banjo bolt on the fuel pump, a blockage in the fuel cooling system may cause a fuel line to burst. This could result in a significant fuel leak onto the roadway, which would create a road hazard for other motorists. Additionally, this condition could also cause an engine stall without warning, without the ability to restart the engine. Both of these conditions may increase the risk of a crash causing injury and/or damage to property. Correction: Cummins-authorized dealers will replace the affected nylon line with a steel line.

• Brakes#2018418August 9, 2018

  448 units affected

  On certain vehicles equipped with air disc brakes, the brake caliper mounting bolts may be incorrectly torqued. This could result in the caliper bolts loosening, which could lead to the caliper detaching. Insufficiently torqued fasteners may not provide adequate clamping force between the brake caliper and brake anchor plate potentially resulting in reduced brake effectiveness, which would result in increased stopping distances, increasing the risk of a crash causing injury and/or damage to property. Correction: Daimler Trucks of North America Service Facilities will inspect the bolts, and repair as necessary.

• Suspension#2018395July 30, 2018

  32 units affected

  On certain trucks, a combination of brake vibrations and corrosion could cause the tie-rod tube to fatigue and break. This may lead to a disconnect between the front wheels and reduce the ability to steer the vehicle, which could increase the risk of a crash causing injury and/or damage to property. Correction: Daimler Trucks of North America Service Facilities will replace brake linings, brake spiders and tie rods as necessary.

• Wheels#2016419August 30, 2016

  149 units affected

  On certain vehicles, the specified front axle weight limit may be greater than the hub capacity. If the axle load exceeds the maximum weight capacity of the hub, there is an increased risk of hub fatigue, which could cause a complete separation of the wheel(s) and a loss of vehicle control, increasing the risk of a crash causing injury and/or damage to property. Correction: Dealers will replace the incorrectly specified front axle hubs.

• Brakes#2014548December 3, 2014

  714 units affected

  On certain vehicles, brake chamber diaphragm(s) may not be properly seated. This could lead to brake drag, causing brake overheating or unintended spring brake application. These issues could increase the risk of a crash causing injury and/or property damage. Correction: Dealers will affect repairs as necessary.

• Seats And Restraints#2013427November 27, 2013

  2,888 units affected

  On certain trucks, the seat belts may not comply with Canada Motor Vehicle Safety Standard 209 - Seat Belt Assemblies. Due to a defect in manufacturing, the seat belt buckle may not release as required by the standard. This could hinder egress from the vehicle in an emergency, increasing the risk of injury. Correction: Dealers will inspect and, if necessary, replace affected seatbelt buckles.

• Lights And Instruments#2013110April 8, 2013

  15 units affected

  On certain vehicles, the instrument panel may show an incorrect park brake message. If the ignition is switched OFF and the driver’s door opened (before the park brake is applied), the message “Park Brake On” may be incorrectly displayed instead of “Park Brake off Door Open”. Should the vehicle be parked on a sufficient slope, failure to apply the park brake could allow unintended vehicle movement, which could cause a crash resulting in property damage and/or personal injury. Correction: Dealers will update the Instrument Cluster Module software.

• Other#2012442December 21, 2012

  7 units affected

  On certain trucks, the bottom access panel may dislodge and separate from the Thermo King Tripac Auxiliary Power Unit (APU). A panel separating from the vehicle could strike another vehicle, a stationary object, or bystander, causing property damage and/or personal injury. Correction: Thermo King authorized service facilities will inspect and, if necessary, replace the APU’s access panel.

• Wheels#2012357October 19, 2012

  On certain vehicles, the wheel rims may have been manufactured incorrectly and could fail. A wheel separating from the vehicle could cause a loss of control and a crash. In addition, the errant wheel assembly could strike a vehicle, stationary object, or a bystander. These issues could result in property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, replace the wheel rims. Note: Further evaluation revealed that no Canadian vehicles are involved.

• Brakes#2012281August 15, 2012

  147 units affected

  On certain trucks, the air tank mounting brackets may crack, which could allow the tank to detach from the vehicle. An air tank separating from the vehicle could strike another vehicle, a stationary object, or a bystander. As well, loss of an air tank would cause a loss of service brakes, which could increase stopping distances, possibly causing a crash. These issues could result in property damage and/or personal injury. Correction: Dealers will replace the air tank mounting brackets.

• Steering#2012193June 29, 2012

  44 units affected

  On certain trucks, the front axle knuckles may have been manufactured incorrectly, which could lead to shorter than expected bearing and knuckle life. In some instances, this could result in separation of the wheel from the axle. A wheel separating from the vehicle could cause a loss of control and a crash. In addition, the errant wheel assembly could strike a vehicle, stationary object or a bystander. These issues could result in property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, replace the front axle knuckles.

• Brakes#2012139April 23, 2012

  179 units affected

  On certain trucks, the quick release valve (QRV) cover may not have been welded correctly during manufacturing process and may become loose or separate from the valve body. If this occurs, air pressure may not be supplied to the front brakes during brake application. The rear brakes will continue to function. Reduction in braking efficiency could increase stopping distances, possibly resulting in a crash causing property damage and/or personal injury. Correction: Daimler authorized repair facilities will inspect and if necessary replace the quick release valve.

• Fuel System#2012080February 27, 2012

  11,923 units affected

  On certain trucks equipped with a Detroit Diesel DD13, DD15 or DD16 engine, the support system for the high pressure fuel line (between the fuel pump and the fuel delivery rail) may be damaged during a service repair procedure. Incorrect torque applied to the dampener "P" clip fasteners may damage the fasteners, which could allow the clips to loosen. This could result in a cracked fuel line and a diesel fuel leak. Diesel fuel leakage may ignite on a hot engine surface and cause a fire. As well, diesel fuel spilt on the roadway could endanger other road users by making the roadway unexpectedly slippery. These issues could result in property damage and/or personal injury. Correction: Dealers will replace the high pressure fuel line and install a more robust fuel line support system.

• Other#2011346September 19, 2011

  1,027 units affected

  On certain vehicles, specific operating conditions (such as tight, successive, highly banked curves in opposite directions), could trigger unintended Electronic Stability Control (ESC) system intervention. As a result, the ESC may unnecessarily apply one of the front brakes in order to correct the perceived oversteer condition. This may cause the vehicle to deviate from the intended path, thereby increasing the risk of a crash causing property damage and/or personal injury. Correction: Dealers will replace the ESC module.

• Other#2011290August 9, 2011

  31 units affected

  On certain trucks, the front bumper mounting brackets may crack and fail. This could allow the front bumper fall off while the vehicle is in motion. A bumper separating from the vehicle could strike another vehicle, stationary object, or a bystander, causing property damage and/or personal injury. Correction: Dealers will replace the bumper mounting brackets.

• Electrical#2011236June 22, 2011

  5,924 units affected

  On certain trucks equipped with a DD15 or DD16 engine, the bolt attaching a rubber isolator to a support bracket may become loose, back out, and contact the starter cable. This could cause an electrical short, which could result in a fire causing property damage and/or personal injury. Correction: Dealers will install a new bolt and isolator, and apply thread-locking fluid to the fastener.

• Brakes#2011163April 20, 2011

  297 units affected

  On certain vehicles, the slack adjuster housings may have been manufactured incorrectly, which could allow the housings to fracture and fail. As a result, the wheel brake to which the slack adjuster is attached would no longer function, which could increase vehicle stopping distances. Should a steer axle slack adjuster fail, it could also cause the vehicle to pull to one side during braking. Either problem could result in a crash causing property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, replace the slack adjusters.

• Label#2010390November 4, 2010

  1,280 units affected

  On certain vehicles, the recommended cold tire inflation information, as required by the Technical Standards Document No. 120S5.3.1, was inadvertently omitted during vehicle assembly. Missing recommended cold tire inflation information may lead to incorrect tire pressures, potentially resulting in tire failure. Correction: Dealers will replace the incorrect labels.

• Fuel System#2010250July 26, 2010

  1,008 units affected

  On certain vehicles equipped with a DD13 and DD15 engines, over time, the barrel of the Bosch high pressure fuel pump element may develop a crack due to hydrogen induced stress corrosion, which could result in a diesel fuel leak. Diesel fuel spilt on the roadway could endanger other road users by making the roadway unexpectedly slippery. Correction: Dealers will replace the high pressure fuel pump element with a more robust version.

• Fuel System#2010144May 3, 2010

  3,194 units affected

  On certain vehicles, should the fuel filter become restricted, the low pressure fuel flange may develop a crack resulting in a fuel leak. Fuel leakage, in the presence of an ignition source, could result in a fire causing property damage, personal injury or death. Correction: Dealers will replace the low pressure fuel flange with a more robust component.

• Engine#2009270September 22, 2009

  5,647 units affected

  On certain vehicles equipped with a Caterpillar C15 engine, the Variable Valve Actuation (VVA) oil line may wear against the P-clip retaining the oil line. An oil leak could result in a vehicle fire causing property damage and/or personal injury. Correction: Caterpillar dealers will replace the VVA oil line with an updated version.

Canadian data updated August 24, 2026