Does the 2011 Freightliner Business Class M2 106 have any recalls?

Transport Canada lists 22 campaigns and the U.S. NHTSA lists 0 for the 2011 Freightliner Business Class M2 106. Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.

How do I know if a recall applies to my 2011 Freightliner Business Class M2 106?

Recalls are matched by make, model and model year, but many cover only certain VIN ranges. Confirm with your manufacturer or dealer using your full VIN, or use the official Transport Canada or NHTSA lookup.

Are recall repairs free?

Yes. In both Canada and the United States the manufacturer must fix a recalled defect at no charge, through a franchised dealer.

RECALLS — MAKE · MODEL · YEAR

2011 Freightliner Business Class M2 106 recalls

22 safety recall campaigns have been filed for the 2011 Freightliner Business Class M2 106 with Transport Canada and the U.S. NHTSA. Here is what both agencies say.

Canadian recalls: 22
U.S. recalls: 00
Total campaigns: 22

Transport Canada recalls

Tires#2021706November 17, 2021
948 units affected
Issue: Certain trucks were built with tires that are not approved for use with the truck's wheels. As a result, the tires may not perform properly, or a tire could fail. Safety Risk: A tire failure could cause a loss of control and increase the risk of a crash. Corrective Actions: Daimler Trucks North America (DTNA) will notify owners by mail. The corrective actions for this recall are under development. You will be instructed to bring your truck to a DTNA authorized service facility when a repair is available.
Lights And Instruments#2020158April 14, 2020
873 units affected
Issue: On certain trucks equipped with "Fleet Engineer" mud flaps, the bracket for the mud flaps may partially cover the rear reflective tape. Canadian regulations require that reflective tape must be visible on the rear of the truck. Safety Risk: Reflective tape that is covered may make the truck less visible to others and could create an increased risk of a crash. Corrective Actions: Daimler Trucks of North America (DTNA) will notify owners by mail and instruct you to take your truck to an authorized DTNA Service Facility to inspect the reflective tape. It will be moved as necessary to meet the regulations.
Lights And Instruments#2019336July 4, 2019
1,280 units affected
Issue: On certain trucks equipped with electronic stability control (ESC), the brake lights may turn on when the automatic traction control (ATC) activates. Canadian regulations do not allow brake lights to turn on when the automatic traction control activates. Safety Risk: Brake lights that turn on when a vehicle is not slowing could confuse other drivers. Corrective Actions: The company will notify owners by mail and instruct them to take their truck to a Daimler Trucks North America authorized service facility. The truck will either be reprogrammed or retrofitted so the brake lights do not turn on when the automatic traction control (ATC) activates.
Brakes#2019237May 17, 2019
110 units affected
Issue: Certain trucks were built with air reservoir tanks that are too small in relation to the size of the air brake chambers. Canadian regulations require enough air reservoir capacity to ensure the brakes work even with heavy use or when there is a partial loss of the air system. Safety Risk: Reduced braking could cause extended stopping distances and increase the risk of a crash. Corrective Actions: The company will notify owners by mail and instruct them to take their truck to a Daimler Trucks North America authorized service facility to modify the truck to ensure it meets Canadian regulations.
Accessories#2017636December 18, 2017
16,510 units affected
On certain vehicles equipped with Kidde fire extinguishers with black plastic handles and valves, the fire extinguishers may become clogged or require excessive force to activate. Also, the nozzle may detach from the valve assembly with enough force that it could cause injury, and fail to discharge. In case of fire, failure of the extinguisher to function could result in injury and/or property damage. Correction: Owners will be provided with instructions on how to inspect the fire extinguisher to see if it is recalled. Replacement fire extinguishers will be supplied by Kidde directly. Note: For more information about recalled fire extinguishers, please visit <a href="https://inmarmarketaction.com/kidde/Kidde284CA/">www.kidde.com</a>.
Engine#2015336July 24, 2015
172 units affected
On certain vehicles equipped with Cummins Westport ISL-G engines, excessive engine crankcase pressure could cause the vent tube assembly molded rubber adapter to detach from the breather. This could allow engine oil to come in contact with hot surfaces, increasing the risk of fire resulting in injury and/or damage to property. Correction: Dealers will install clamps at both ends of the adapter of the breather tube assembly and reprogram the Electronic Control Module (ECM) to improve diagnostic capabilities.
Accessories#2015276June 19, 2015
8 units affected
On certain mobile document shredder vehicles, installation of the shredding equipment combined with the increased weight of additional emissions components may have caused the vehicle weight to exceed the front gross axle weight rating (GAWR). This would result in vehicle being overloaded, potentially affecting vehicle handling characteristics, which could result in a crash causing injury and/or property damage. Correction: For vehicles built on the Freightliner M2 106 chassis, dealers will provide a new compliance label to reflect an increased GAWR (to 9000 lbs from 8000 lbs), and upgrade the front axle as necessary. For vehicles built on the Hino 258LP chassis, dealers will provide a new compliance label to reflect an increased GAWR (to 8500 lbs from 8000 lbs).
Engine#2014050February 21, 2014
113 units affected
On certain vehicles equipped with Cummins ISL G or ISX12 G engines, incorrect engine ECU programming could cause the exhaust system temperature to become elevated during cold weather operation. This could also cause flames to be emitted from the exhaust. As a result, nearby combustible material could be ignited, increasing the risk of a fire, injury and/or damage to property. Correction: Authorized Cummins service facilities will update software programming.
Brakes#2012281August 15, 2012
147 units affected
On certain trucks, the air tank mounting brackets may crack, which could allow the tank to detach from the vehicle. An air tank separating from the vehicle could strike another vehicle, a stationary object, or a bystander. As well, loss of an air tank would cause a loss of service brakes, which could increase stopping distances, possibly causing a crash. These issues could result in property damage and/or personal injury. Correction: Dealers will replace the air tank mounting brackets.
Fuel System#2012080February 27, 2012
11,923 units affected
On certain trucks equipped with a Detroit Diesel DD13, DD15 or DD16 engine, the support system for the high pressure fuel line (between the fuel pump and the fuel delivery rail) may be damaged during a service repair procedure. Incorrect torque applied to the dampener "P" clip fasteners may damage the fasteners, which could allow the clips to loosen. This could result in a cracked fuel line and a diesel fuel leak. Diesel fuel leakage may ignite on a hot engine surface and cause a fire. As well, diesel fuel spilt on the roadway could endanger other road users by making the roadway unexpectedly slippery. These issues could result in property damage and/or personal injury. Correction: Dealers will replace the high pressure fuel line and install a more robust fuel line support system.
Engine#2011439December 22, 2011
50 units affected
On certain emergency vehicles, the engine shutdown system (normally provided to protect the engine in case of malfunction) may not have been disabled during vehicle assembly. Unexpected emergency vehicle engine shutdown, under certain conditions, could hamper rescue operations and place the public at risk. Correction: Authorized service facilities will disable the engine shutdown system.
Other#2011411November 21, 2011
1,412 units affected
On certain vehicles equipped with an MBE4000 (EPA07) engine, the intake air grid heater may short circuit and fail. This could result in a vehicle fire causing property damage and/or personal injury. Correction: Dealers will install an additional external relay to prevent battery connection to the grid heater when the vehicle is not running and when grid heater control signal is absent.
Other#2011346September 19, 2011
1,027 units affected
On certain vehicles, specific operating conditions (such as tight, successive, highly banked curves in opposite directions), could trigger unintended Electronic Stability Control (ESC) system intervention. As a result, the ESC may unnecessarily apply one of the front brakes in order to correct the perceived oversteer condition. This may cause the vehicle to deviate from the intended path, thereby increasing the risk of a crash causing property damage and/or personal injury. Correction: Dealers will replace the ESC module.
Engine#2011337September 13, 2011
580 units affected
On certain vehicles equipped with a Cummins engine, the V-band clamps used to connect the inlet and outlet cone sections to the Diesel Oxidation Catalyst (DOC) / Diesel Particulate Filter (DPF) include a T-bolt which can fracture and fail when subjected to stress or load. A fracture or failure of the T-bolt may cause the clamp to loosen and the inlet or outlet sections attached to the DOC/DPF housing to disconnect. Should this occur, hot exhaust gases can vent prior to exiting the tailpipe, creating a risk of combustion or damage to adjacent materials, which could result in a vehicle fire. If both clamps fail, the DOC/DPF housing could detach completely, separate from the vehicle, and strike another vehicle, stationary object, or bystander. These issues could result in property damage and/or personal injury. Correction: Cummins will install updated V-band clamps.
Powertrain#2011172April 27, 2011
81 units affected
On certain trucks, the driveshaft may not have been welded correctly during the manufacturing process. This could allow the driveshaft to fracture along the length of the tube seam weld when torque is applied. The fractured tube can twist or sever, which could result in additional damage to the driveline, the vehicle to which it is attached, and any additional nearby components. Should the brake air lines become damaged, it could allow spring brake application, causing immediate brake lock-up. If this occurs while the vehicle is in motion, it could result in a crash. Also, failure of the driveshaft would result in lost vehicle propulsion which, in conjunction with traffic and road conditions, and the driver's reactions, could increase the risk of a crash. Either condition could result in property damage and/or personal injury. Correction: Dealers will replace the driveshaft assembly.
Brakes#2011163April 20, 2011
297 units affected
On certain vehicles, the slack adjuster housings may have been manufactured incorrectly, which could allow the housings to fracture and fail. As a result, the wheel brake to which the slack adjuster is attached would no longer function, which could increase vehicle stopping distances. Should a steer axle slack adjuster fail, it could also cause the vehicle to pull to one side during braking. Either problem could result in a crash causing property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, replace the slack adjusters.
Lights And Instruments#2011112March 10, 2011
32 units affected
Certain trucks were equipped with headlights that fail to comply with the requirements of Canada Motor Vehicle Safety Standard 108 - Lighting System and Retroreflective Devices. The Standard requires headlights not be mounted lower than 559 mm and not higher than 1372 mm above the road surface. Improper headlamp height may result in incomplete illumination of the road surface, or may inhibit the ability of seeing pedestrians and other road users. This could result in a crash causing property damage and/or personal injury. Correction: Dealers will measure headlamp height and, for vehicles with lamps beyond the limit, will install new headlamps that lower the bulb center.
Label#2010390November 4, 2010
1,280 units affected
On certain vehicles, the recommended cold tire inflation information, as required by the Technical Standards Document No. 120S5.3.1, was inadvertently omitted during vehicle assembly. Missing recommended cold tire inflation information may lead to incorrect tire pressures, potentially resulting in tire failure. Correction: Dealers will replace the incorrect labels.
Lights And Instruments#2010258August 3, 2010
69 units affected
Certain trucks were equipped with headlights that fail to comply with the requirements of Canada Motor Vehicle Safety Standard 108 - Lighting System and Retroreflective Devices. The Standard requires headlights not be mounted lower than 559 mm and not higher than 1372 mm above the road surface. Improper headlamp height may result in incomplete illumination of the road surface, or may inhibit the ability of seeing pedestrians and other road users. This could result in a crash causing property damage and/or personal injury. Correction: Dealers will measure headlamp height and, for vehicles with lamps beyond the limit, will install new headlamps that lower the bulb center.
Other#2010251July 26, 2010
2,318 units affected
On certain vehicles equipped with an MBE900 (EPA04 and EPA07) engine, the intake air grid heater may short circuit and fail. This could result in a vehicle fire causing property damage and/or personal injury. Correction: Dealers will install an additional external relay to prevent battery connection to the grid heater when the vehicle is not running and when grid heater control signal is absent.
Fuel System#2010144May 3, 2010
3,194 units affected
On certain vehicles, should the fuel filter become restricted, the low pressure fuel flange may develop a crack resulting in a fuel leak. Fuel leakage, in the presence of an ignition source, could result in a fire causing property damage, personal injury or death. Correction: Dealers will replace the low pressure fuel flange with a more robust component.
Lights And Instruments#2010130April 22, 2010
2,495 units affected
On certain vehicles, the stop lamps may operate intermittently during light braking applications. Failure of the brake lamps to illuminate when the brakes are applied may result in the following road users being unaware of the driver's intentions, increasing the risk of a crash causing property damage and/or personal injury. Correction: Dealers will replace the hydraulic brake light switch assembly.

Canadian data updated August 24, 2026

U.S. NHTSA recalls

No recalls found for this make, model, and year.

Does this recall apply to my vehicle?

Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.

What to do

Recall repairs are free at a franchised dealer in both countries. To confirm a recall applies to your specific vehicle, or to book the work, contact your manufacturer or dealer with your full VIN, or use the official channel:

NHTSA recall lookup (search by VIN) — U.S. National Highway Traffic Safety Administration
Defects and recalls database — Transport Canada

Check a 2011 Freightliner Business Class M2 106 VIN

A VIN decode confirms your vehicle's exact model year, trim and assembly plant, then runs this same recall check against it.

Data sources and coverage limits →