RECALLS — FREIGHTLINER 122SD
Freightliner 122SD recalls
Freightliner 122SD model years 2010–2026 covered by at least one recall campaign. Pick a year to see the Canadian and U.S. campaigns side by side.
Choose a model year
U.S. NHTSA campaigns are listed on each year page, where they are queried live by model year. The Canadian list below covers every year together.
Transport Canada recalls
16- Suspension#2025610
2,464 units affected
Issue: On certain trucks, the fasteners for the axle clamp(s) may not have been tightened properly. As a result, the clamps could loosen. If this happens, the axle could move and cause a loss of steering control. Note: This recall only affects certain trucks equipped with a TufTrac Gen 2 suspension. Safety Risk: A loss of steering control could create the risk of a crash. Corrective Actions: Daimler Truck North America (DTNA) will notify the owners by mail and advise you to take your truck to a DTNA authorized service facility to inspect and tighten the axle clamp fasteners. The axle clamp castings will be replaced, as necessary.
- Steering#2023083
3,460 units affected
Issue: On certain trucks, the joint connecting the steering arm to the drag link may not have been properly tightened. As a result, the joint could loosen and separate, causing a loss of steering control. Safety Risk: A loss of steering control could create the risk of a crash. Corrective Actions: Daimler Truck North America (DTNA) will notify owners by mail and instruct you to take your truck to a DTNA authorized service facility to inspect the castle nut on the drag link taper joint. The nut will be checked for the correct torque, and tightened or repaired, as necessary.
- Steering#2021219
658 units affected
Issue: On certain trucks, the tie rod arm and steering arm bolts may be defective and could break. If this happens, there could be a loss of steering control. Note: This recall only affects trucks built with a Detroit front axle. Safety Risk: A loss of steering control could create the risk of a crash. Corrective Actions: Daimler Trucks North America (DTNA) will notify owners by mail and instruct you to take your truck to a DTNA authorized service facility to replace the tie rod arm bolts and the steering arm bolts.
- Powertrain#2020488
966 units affected
Issue: On certain trucks equipped with an Eaton automated manual transmission and electronic clutch actuator (ECA), a component within the clutch assembly could fail. If this happens, the broken clutch components could prevent the transmission from disengaging or shifting to neutral. This could result in unintended vehicle movement, even if the parking brake is applied. Note: This recall replaces FL-803 (Transport Canada recall 2018-714). Trucks that were repaired under that recall also require this repair. Safety Risk: Sudden and unexpected movement of the vehicle could create a risk of injury or a crash. Corrective Actions: Daimler Trucks North America (DTNA) will notify owners by mail and instruct you to take your truck to a DTNA authorized service facility to replace the clutch and update the transmission software.
- Lights And Instruments#2020158
873 units affected
Issue: On certain trucks equipped with "Fleet Engineer" mud flaps, the bracket for the mud flaps may partially cover the rear reflective tape. Canadian regulations require that reflective tape must be visible on the rear of the truck. Safety Risk: Reflective tape that is covered may make the truck less visible to others and could create an increased risk of a crash. Corrective Actions: Daimler Trucks of North America (DTNA) will notify owners by mail and instruct you to take your truck to an authorized DTNA Service Facility to inspect the reflective tape. It will be moved as necessary to meet the regulations.
- Lights And Instruments#2019336
1,280 units affected
Issue: On certain trucks equipped with electronic stability control (ESC), the brake lights may turn on when the automatic traction control (ATC) activates. Canadian regulations do not allow brake lights to turn on when the automatic traction control activates. Safety Risk: Brake lights that turn on when a vehicle is not slowing could confuse other drivers. Corrective Actions: The company will notify owners by mail and instruct them to take their truck to a Daimler Trucks North America authorized service facility. The truck will either be reprogrammed or retrofitted so the brake lights do not turn on when the automatic traction control (ATC) activates.
- Brakes#2019237
110 units affected
Issue: Certain trucks were built with air reservoir tanks that are too small in relation to the size of the air brake chambers. Canadian regulations require enough air reservoir capacity to ensure the brakes work even with heavy use or when there is a partial loss of the air system. Safety Risk: Reduced braking could cause extended stopping distances and increase the risk of a crash. Corrective Actions: The company will notify owners by mail and instruct them to take their truck to a Daimler Trucks North America authorized service facility to modify the truck to ensure it meets Canadian regulations.
- Powertrain#2018714
1,472 units affected
This recall was replaced by Transport Canada Recall No. 2020-488. On certain vehicles equipped with an Eaton automated manual transmission and electronic clutch actuator (ECA), an internal component within the clutch assembly may have been manufactured improperly and could fail. If this occurs, the broken clutch components could prevent the transmission from disengaging or shifting to neutral. This could result in unintended vehicle movement, even if the parking brake is applied, increasing the risk of a crash causing injury and/or damage to property. Correction: Daimler Trucks of North America Authorized Service Facilities will recalibrate the Transmission Control Module (TCM) and replace components as necessary.
- Fuel System#2018469
259 units affected
On certain trucks built with a Cummins X15 or ISX15 engine equipped with nylon fuel lines and a banjo bolt on the fuel pump, a blockage in the fuel cooling system may cause a fuel line to burst. This could result in a significant fuel leak onto the roadway, which would create a road hazard for other motorists. Additionally, this condition could also cause an engine stall without warning, without the ability to restart the engine. Both of these conditions may increase the risk of a crash causing injury and/or damage to property. Correction: Cummins-authorized dealers will replace the affected nylon line with a steel line.
- Brakes#2018418
448 units affected
On certain vehicles equipped with air disc brakes, the brake caliper mounting bolts may be incorrectly torqued. This could result in the caliper bolts loosening, which could lead to the caliper detaching. Insufficiently torqued fasteners may not provide adequate clamping force between the brake caliper and brake anchor plate potentially resulting in reduced brake effectiveness, which would result in increased stopping distances, increasing the risk of a crash causing injury and/or damage to property. Correction: Daimler Trucks of North America Service Facilities will inspect the bolts, and repair as necessary.
- Fuel System#2017358
38 units affected
On certain vehicles equipped with Cummins ISX 15 engines and certain fuel pumps, the drive gear on the fuel pump may spin loose on the drive shaft. This could result in a loss of pumping function, which could result in an engine stall without warning and not being able to be restarted, which could increase the risk of a crash causing injury and/or damage to property. Correction: Cummins-authorized dealers will replace the fuel pump.
- Engine#2016285
9 units affected
On certain vehicles, the Engine Control Module (ECM) may develop an internal electrical short circuit that could blow a fuse in the ECM's electrical supply circuit. This could cause the engine to stall without warning and prevent the vehicle from being restarted. Engine stalling without warning would result in lost propulsion which, in conjunction with traffic and road conditions, and the driver's reactions, could increase the risk of a crash causing property damage and/or personal injury. Correction: Dealers will replace the ECM.
- Steering#2015485
427 units affected
On certain vehicles built with a front axle built by Detroit Axles, the steering arm bolt may not have been sufficiently tightened at time of assembly. This could allow the bolt to loosen and potentially result in the separation of the steering arm from the steering knuckle, which could result in a loss of steering. This could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will inspect the bolt torque and re-tighten or replace as necessary.
- Brakes#2014548
714 units affected
On certain vehicles, brake chamber diaphragm(s) may not be properly seated. This could lead to brake drag, causing brake overheating or unintended spring brake application. These issues could increase the risk of a crash causing injury and/or property damage. Correction: Dealers will affect repairs as necessary.
- Brakes#2014507
16 units affected
On certain vehicles equipped with a Wabco quick release with double check valves, used to control park/spring brake application, the valve may leak internally. This could cause unintended partial or full park/spring brake application, which could affect service brake function and increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will affect repairs.
- Seats And Restraints#2013427
2,888 units affected
On certain trucks, the seat belts may not comply with Canada Motor Vehicle Safety Standard 209 - Seat Belt Assemblies. Due to a defect in manufacturing, the seat belt buckle may not release as required by the standard. This could hinder egress from the vehicle in an emergency, increasing the risk of injury. Correction: Dealers will inspect and, if necessary, replace affected seatbelt buckles.
Canadian data updated August 24, 2026
Does this recall apply to my vehicle?
Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.
What to do
Recall repairs are free at a franchised dealer in both countries. To confirm a recall applies to your specific vehicle, contact your manufacturer or dealer with your full VIN, or use the official channel:
- NHTSA recall lookup (search by VIN) — U.S. National Highway Traffic Safety Administration
- Defects and recalls database — Transport Canada