2015 Ford F-150 Super Crew recalls

• Powertrain#2026189April 15, 2026

  144,475 units affected

  Issue: On certain trucks, a software problem could cause the transmission to downshift suddenly to second gear. If this happens, there could be a loss of control. Note: This recall only affects trucks equipped with a 6-speed transmission. Safety Risk: A loss of control could increase the risk of a crash. Corrective Actions: Ford will notify owners by mail and advise you to take your truck to a dealership to update the powertrain control module software.

• Visual System#2024779December 20, 2024

  218,614 units affected

  Issue: On certain trucks, the windshield wiper linkage could corrode and seize. If this happens, the windshield wipers may not work. Safety Risk: Windshield wipers that don't work could reduce visibility and increase the risk of a crash. Corrective Actions: Ford will notify owners by mail and advise you to take your truck to a dealership to replace the windshield wiper linkage.

• Brakes#2020252June 8, 2020

  42,309 units affected

  Issue: On certain trucks, brake fluid could leak from the brake master cylinder front wheel circuit into the brake booster. If this happens, the driver may experience increased brake pedal travel and increased pedal effort. This can cause reduced front brake performance. Full braking function remains in the rear wheel circuit. Note: Depending on the amount of brake fluid loss, the driver may hear a warning chime and see a red brake warning indicator in the instrument cluster. Safety Risk: Reduced front brake performance can cause extended stopping distances and increase the risk of a crash. Corrective Actions: Ford will notify owners by mail and instruct you to take your truck to a Ford or Lincoln dealer to replace the brake master cylinder.

• Electrical#2020069February 21, 2020

  19,679 units affected

  Issue: On certain trucks with a 3.5-L engine, there could be a problem with the engine block heater cable. The wrong cable may have been installed when your vehicle was repaired under a previous recall. The cable that was installed may not have enough heat protection and could be damaged by high engine temperatures. When plugged in, this could cause a short circuit to occur, resulting in overheated or melted wiring. It could also cause the block heater not to work, and/or it could cause a household circuit breaker to trip. For details of the previous recall, please see Transport Canada recall no. 2019-174 (Ford no. 19S11/19G01). Safety Risk: Overheated or melted wiring could create the risk of a fire. Corrective Actions: Do not use your block heater until the recall inspection and repairs are completed. Ford will notify owners by mail and instruct you to take your vehicle to a dealer to inspect the block heater and cable. Depending on the results of the inspection, the heater element and/or block heater cable will be replaced, as necessary. If the replacement parts are not available, the dealer will disable the engine block heater. Ford will send you another notice when the replacement parts are available, and will ask you to take your vehicle to a dealer to have them installed.

• Electrical#2020023January 23, 2020

  89,472 units affected

  Issue: On certain trucks, the electric tailgate latch could malfunction. This may cause the tailgate to unlatch on its own. If the tailgate opens while driving, cargo that is not secured could fall out of the truck bed and onto the road. Safety Risk: Cargo that falls from the truck bed could create a road hazard for others. Corrective Actions: Ford will notify owners by mail and instruct you to take your vehicle to a Ford or Lincoln dealer to modify the tailgate/frame wiring harnesses and will install a new tailgate handle release switch.

• Other#2019420August 21, 2019

  5,327 units affected

  Issue: This recall is for aftermarket replacement rear window glass produced by Vitro Automotriz. Certain rear window glass may not have been properly tempered. If the window breaks, the glass may separate into large pieces instead of very small ones. Note: This is a voluntary recall that is not being conducted under the requirements of the Motor Vehicle Safety Act. Safety Risk: Glass that breaks in to large pieces could create a risk of injury. Corrective Actions: The company will notify consumers by mail and instruct them to inspect the designation code marked on the rear window glass. Products affected by this recall have the designation “DOT 287” along with the lettering “VMR” (Replacement Market) and a date code that is before July 2019. This information is printed on the bottom corner of the glass. Consumers should contact Vitro's customer service at 1-412-995-6457 or argbacklites@vitro.com to arrange for replacement of the glass.

• Electrical#2019174April 10, 2019

  230,182 units affected

  Issue: The connectors on the engine block heater cable may have been damaged when your truck was serviced for recall campaign 2018-718 (Ford #18S45). This could cause a short-circuit, which may result in overheated or melted wiring. Safety Risk: Overheated or melted wiring could create the risk of a fire. Corrective Actions: Stop use of your engine block heater immediately. Ford will notify owners by mail and instruct you to take your vehicle to a dealer to disable the engine block heater. Ford will send you another notice when replacement parts are available, and will ask you to take your vehicle to a dealer to install them. Do not use your engine block heater until the replacement parts are installed.

• Electrical#2018718December 20, 2018

  446,041 units affected

  Issue: Water and contaminants may damage and corrode the block heater cable connectors. This could cause a short-circuit, which may result in overheated or melted wiring. Safety Risk: Overheated or melted wiring could create the risk of a fire. Corrective Actions: Stop use of your engine block heater immediately. Ford will notify owners by mail and instruct you to take your vehicle to a dealer to disable the engine block heater. Ford will send you another notice when replacement parts are available, and will ask you to take your vehicle to a dealer to install them. Do not use your engine block heater until the replacement parts are installed.

• Seats And Restraints#2018470September 4, 2018

  339,884 units affected

  On certain vehicles, the activation of the front seat belt pretensioners in a crash may result in momentary ignition of pretensioner exhaust gases. This could ignite materials in the B-pillar area, leading to a fire causing injury and/or damage to property. Correction: Dealers will inspect the B-pillar area, modify the floor covering and sound insulation, and apply heat-resistant tape.

• Structure#2017502October 18, 2017

  222,408 units affected

  On certain vehicles, door latch shielding may not be sufficient. As a result, water could enter into the side door latch and freeze, causing the latch mechanism to bind after opening. In addition, latch actuation cables may have been bent or kinked during installation, and could result in latch binding. A frozen door latch, or bent or kinked actuation cable may result in a door that will not open or will not close. If a latch does not fully engage the door striker, there is a potential for a door to open while the vehicle is in motion, which could increase the risk of injury. Correction: Dealers will install water shields over the door latches and the door latch actuation cables will be inspected and repaired if needed.

• Seats And Restraints#2017413August 30, 2017

  14,682 units affected

  Certain vehicles equipped with rear inflatable seat belts may fail to conform to Canada Motor Vehicle Safety Standard (CMVSS) 210 – Seat Belt Assembly Anchorages. The left rear inflatable seat belt buckle may have been assembled with a rivet that was improperly staked. As a result, the left rear seat belt assembly could separate from its mounting bracket during a crash, which could increase the risk of injury and would fail to meet the anchorage strength requirements of the standard. Correction: Dealers will inspect the left rear seat belt buckle rivet, and replace the seat belt buckle assembly if necessary.

• Seats And Restraints#2015607December 21, 2015

  555 units affected

  Certain vehicles may not comply with the requirements of Canada Motor Vehicle Safety Standards (CMVSS) 210 - Seat Belt Anchorages and (CMVSS) 209 – Seat Belt Assemblies. Front seat belt anchorages may have pretensioner cables that were not properly crimped and may fail to conform to CMVSS 209 assembly performance standards, and the strength requirements of the CMVSS 210 standard. These issues could result in the belts not adequately restraining occupants in a crash, increasing the risk of injury. Correction: Dealers will replace front driver and/or passenger seat belt retractors and pretensioners.

• Electrical#2015440September 30, 2015

  3,376 units affected

  On certain vehicles equipped with Adaptive Cruise Control (ACC), when the ACC is engaged, the driver may experience unexpected braking while passing a large, highly reflective vehicle. An unexpected ACC braking event could increase the risk of a crash involving a trailing vehicle. During this unexpected braking event, the Collision Warning System red warning light may also flash and an audible tone may be heard. Correction: Dealers will reprogram the cruise control module with updated ACC radar software. Note: The brake lights would illuminate while the brakes are applied by the ACC system, and the driver could still override the ACC system at any time using the accelerator pedal, brake pedal or by cancelling ACC through the steering wheel switches.

• Steering#2015196May 12, 2015

  3,349 units affected

  On certain vehicles, the intermediate shaft may have been improperly riveted during manufacturing. An improperly riveted intermediate shaft could separate from the intermediate shaft flex coupling, which could result in a loss of steering control without warning, increasing the risk of a crash causing injury and/or damage to property. Correction: Dealers will inspect the intermediate shaft, and replace if required.

• Structure#2015178April 28, 2015

  18 units affected

  Certain vehicles may have loose or missing underbody heat shields. Missing underbody heat shields on vehicles could lead to degradation or possibly melting of the fuel or vapor lines, increasing the risk of a fire, which could result in injury and/or damage to property. Correction: Dealers will inspect for missing underbody heat shields and fasteners, and install missing components as required.

Canadian data updated August 24, 2026

No recalls found for this make, model, and year.