RECALLS — MAKE · MODEL · YEAR
2016 E-ONE Quest II recalls
7 safety recall campaigns have been filed for the 2016 E-ONE Quest II with Transport Canada and the U.S. NHTSA. Here is what both agencies say.
- Canadian recalls
- 04
- U.S. recalls
- 03
- Total campaigns
- 07
Transport Canada recalls
04- Accessories#2017590
19 units affected
On certain fire trucks, the retaining ring(s) in the relief valve assembly may not have been made using high grade stainless steel, causing it to deteriorate over time due to frequent exposure to water. If the retaining ring fails, the relief valve may break down and prevent the fire pump from building adequate pressure, which would increase the risk of injury during firefighting operations. Correction: Dealers or certified technicians will inspect and replace the retaining ring(s) as necessary.
- Steering#2017495
24 units affected
On certain vehicles, the steering assist cylinder attachment and adjustment points may not have been tightened to specification at time of assembly. This could result in the steering assist cylinder separating from the steering arm, causing a loss of steering assist and increasing the risk of a crash causing injury and/or damage to property. Correction: Vehicles will be inspected and fasteners tightened to specification.
- Suspension#2017213
3 units affected
On certain vehicles equipped with Reyco independent front suspension (IFS), the suspension system may contain loose ball joints. If these are not detected through regular servicing, they may separate, causing suspension failure. This could affect vehicle handling and increase the risk of a crash causing injury and/or damage to property. Correction: Owners will be instructed the have the suspension inspected by an E-One certified dealer or technician. Loose ball joints will be replaced.
- Accessories#2016548
15 units affected
On certain vehicles equipped with aerial devices, the hydraulic filter head for the hydraulic system may be defective. As a result, the filter head may flex under pressure, allowing the sealing O-ring to be pushed out, resulting in a fluid leak. This could cause reduced aerial/ladder performance, increased power requirements and could potentially result in damage to other hydraulically driven components. This could increase the risk of injury/damage to property. Correction: Dealers will inspect the filter head and replace if necessary.
Canadian data updated August 24, 2026
U.S. NHTSA recalls
03- ELECTRICAL SYSTEM:STARTER ASSEMBLY#19V730000
E-One Incorporated (E-One) is recalling certain 2013-2019 Typhoon and Cyclone 2, 2013-2014 Cyclone 3, 2014-2019 Quest 2 and 2017 CHSH emergency vehicles equipped with a Cummins ISL, L9, ISX12, X12, ISX15, or X15 engine. The engines do not have a diode in the starter solenoid circuit to improve the longevity of the lock-out relay, resulting in accumulated damage over time.
Risk: The damaged starter lock-out relay may prevent the vehicle from starting, hindering personnel from responding to emergencies, increasing the risk of an injury.
Remedy: E-One will notify owners, and dealers will install a diode in the starter solenoid circuit and install a new starter lock-out relay, free of charge. The recall began November 15, 2019. Owners may contact E-One customer service at 1-352-861-3612. Note: Vehicles previously repaired under recall 18V-019 also need this recall remedy.
- ELECTRICAL SYSTEM:STARTER ASSEMBLY#18V019000
E-One Incorporated (E-One) is recalling certain 2013-2017 Cyclone II, Typhoon, and Quest II emergency vehicles equipped with a Cummins ISL, L9, ISX15, or X15 engine. The affected engines do not have a diode in the starter solenoid circuit to improve the longevity of the lock-out relay, resulting in accumulated damage over time.
Risk: The damaged starter lock-out relay may prevent the vehicle from starting, hindering personnel from responding to emergencies.
Remedy: E-One will notify owners, and dealers will install a diode in the starter solenoid circuit and install a new starter lock-out relay, free of charge. The recall began on February 19, 2018. Owners may contact E-One customer service at 1-352-861-3612.
- EQUIPMENT#16V293000
E-One Incorporated (E-One) is recalling certain model year 2015-2016 Cyclone II, Quest II and Typhoon emergency vehicles manufactured May 1, 2015, to March 31, 2016, equipped with pumps to provide pressurized water to aid in fighting fires. These pumps have 6" intake strainers that may have been improperly soldered during production and, as a result, the strainers may come apart during use, allowing parts of the strainer and debris to enter the pump, possibly damaging the pump.
Risk: If the strainer and/or debris enters the pump, and the operator is forced to shut down the pump, reducing firefighting effectiveness, there could be an increased risk of injury.
Remedy: E-One will notify owners to check the strainer for missing solder at the joints. Any strainers missing solder will be replaced, free of charge. The recall began on June 6, 2016. Owners may contact E-One customer service at 1-352-861-3612 or Hale customer service at 1-800-533-3569.
Does this recall apply to my vehicle?
Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.
What to do
Recall repairs are free at a franchised dealer in both countries. To confirm a recall applies to your specific vehicle, or to book the work, contact your manufacturer or dealer with your full VIN, or use the official channel:
- NHTSA recall lookup (search by VIN) — U.S. National Highway Traffic Safety Administration
- Defects and recalls database — Transport Canada
Check a 2016 E-ONE Quest II VIN
A VIN decode confirms your vehicle's exact model year, trim and assembly plant, then runs this same recall check against it.