Does the 2015 E-ONE Cyclone have any recalls?

Transport Canada lists 8 campaigns and the U.S. NHTSA lists 2 for the 2015 E-ONE Cyclone. Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.

How do I know if a recall applies to my 2015 E-ONE Cyclone?

Recalls are matched by make, model and model year, but many cover only certain VIN ranges. Confirm with your manufacturer or dealer using your full VIN, or use the official Transport Canada or NHTSA lookup.

Are recall repairs free?

Yes. In both Canada and the United States the manufacturer must fix a recalled defect at no charge, through a franchised dealer.

RECALLS — MAKE · MODEL · YEAR

2015 E-ONE Cyclone recalls

10 safety recall campaigns have been filed for the 2015 E-ONE Cyclone with Transport Canada and the U.S. NHTSA. Here is what both agencies say.

Canadian recalls: 08
U.S. recalls: 02
Total campaigns: 10

Transport Canada recalls

Electrical#2019517October 14, 2019
112 units affected
Issue: On certain vehicles, the starter lock-out relay could be damaged over time, causing it to fail. If this happens, it will not be possible to start the engine. Note: A possible symptom of a damaged starter lock-out relay is a truck that requires multiple attempts to start. Safety Risk: An emergency vehicle with an engine that cannot be started could increase the risk of injury in an emergency situation. Corrective Actions: E-One will notify owners by mail and instruct them to take their vehicle to a service center to install a relay and diode kit.
Suspension#2019409August 14, 2019
4 units affected
Issue: On certain fire trucks, the front shock absorbers may separate from their upper mounts. A loose shock absorber may contact and damage the steering gear housing, resulting in a steering fluid leak and loss of power steering assist. Note: A loose shock absorber may cause a rattle or clunk noise from the front suspension or a change in vehicle handling. Safety Risk: A loss of power steering assist could increase the risk of a crash. Corrective Actions: The company will notify owners by mail and instruct them to take their vehicle to a service center to inspect and repair the front shock absorber upper mounts.
Wheels#2018206April 25, 2018
1 units affected
On certain vehicles, a manufacturing problem could lead to the development of a fatigue crack in the front spindles. This could cause a spindle failure and result in the possible separation of a wheel from the vehicle, increasing the risk of a crash causing injury and/or damage to property. Correction: Dealers will replace the defective front spindles.
Electrical#2018044January 22, 2018
58 units affected
Certain vehicles equipped with a Cummins ISL, L9, ISX15 or X15 engines, are fitted with a starter lock-out relay which could fail over time due to high voltage current from the starter solenoid during start up. In an emergency situation the vehicle would not be able to start, which could increase the risk of injury during firefighting operations. Correction: Dealers will inspect and replace the starter lock-out relay. Additionally a diode will be added to the starter solenoid circuit to improve longevity of the lock-out relay.
Accessories#2017590November 30, 2017
19 units affected
On certain fire trucks, the retaining ring(s) in the relief valve assembly may not have been made using high grade stainless steel, causing it to deteriorate over time due to frequent exposure to water. If the retaining ring fails, the relief valve may break down and prevent the fire pump from building adequate pressure, which would increase the risk of injury during firefighting operations. Correction: Dealers or certified technicians will inspect and replace the retaining ring(s) as necessary.
Suspension#2016578November 17, 2016
3 units affected
On certain vehicles equipped with jacklegs and FIREMAAX suspension air bags, the air bags could lose pressure and fail over time. Suspension air bag failure could affect vehicle stability which could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will install a pressure protection valve on the exhaust port of the height control valve.
Accessories#2016548November 7, 2016
15 units affected
On certain vehicles equipped with aerial devices, the hydraulic filter head for the hydraulic system may be defective. As a result, the filter head may flex under pressure, allowing the sealing O-ring to be pushed out, resulting in a fluid leak. This could cause reduced aerial/ladder performance, increased power requirements and could potentially result in damage to other hydraulically driven components. This could increase the risk of injury/damage to property. Correction: Dealers will inspect the filter head and replace if necessary.
Other#2016240May 19, 2016
10 units affected
On certain fire trucks, the components that make up the 6" water intake strainer may have been improperly soldered during the manufacturing process. This could lead to degradation in pump performance which could reduce firefighting effectiveness, and potentially increase the risk of injury. Correction: Hale Products recommends an inspection be performed by pulling caps and any suction adapters off of the intake and check the strainer for faulty soldering. If the strainer is found to be missing solder at the joint, Hale Products will send a replacement strainer directly to affected owners.

Canadian data updated August 24, 2026

U.S. NHTSA recalls

SUSPENSION#16V845000November 22, 2016
E-One Incorporated (E-One) is recalling certain model year 2010-2016 tandem axle Cyclone vehicles manufactured July 15, 2010, to June 12, 2016. The affected vehicles are equipped with FIREMAAX suspension and aerial jack legs. While the vehicle is parked with the jack legs extended, the FIREMAAX suspension air bags may lose pressure. When the jack legs are retracted, the air bags may be wrinkled, resulting in damage and the possible failure of the pressurized suspension air bags.
Risk: Sudden suspension air bag failure can result in a reduction of vehicle stability and handling, increasing the risk of a crash.
Remedy: E-One will notify owners, and dealers will install a pressure protection valve on the exhaust port of the height control valve, free of charge. The recall began December 19, 2017. Owners may contact E-One customer service at 1-352-861-3612.
EQUIPMENT#16V801000November 3, 2016
E-One Incorporated (E-One) is recalling certain model year 2014-2016 Typhoon, Quest, and Cyclone fire trucks manufactured January 1, 2014, to October 11, 2016, and equipped with aerial ladders. Due to a design change, the filter for the aerial ladder may leak hydraulic fluid.
Risk: A hydraulic fluid leak can cause a loss of aerial device function, increasing the risk of injury.
Remedy: E-One will notify owners, and dealers will inspect and replace the filter and head assembly, as necessary, free of charge. The recall began on November 29, 2016. Owners may contact E-One customer service at 1-800-627-5050.

Does this recall apply to my vehicle?

Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.

What to do

Recall repairs are free at a franchised dealer in both countries. To confirm a recall applies to your specific vehicle, or to book the work, contact your manufacturer or dealer with your full VIN, or use the official channel:

NHTSA recall lookup (search by VIN) — U.S. National Highway Traffic Safety Administration
Defects and recalls database — Transport Canada

Check a 2015 E-ONE Cyclone VIN

A VIN decode confirms your vehicle's exact model year, trim and assembly plant, then runs this same recall check against it.

Data sources and coverage limits →