RECALLS — MAKE · MODEL · YEAR
2012 Triumph Daytona 675 ABS recalls
5 safety recall campaigns have been filed for the 2012 Triumph Daytona 675 ABS with Transport Canada and the U.S. NHTSA. Here is what both agencies say.
- Canadian recalls
- 05
- U.S. recalls
- 00
- Total campaigns
- 05
Transport Canada recalls
05- Brakes#2013257
237 units affected
On certain motorcycles, the Anti-Lock Brake System (ABS) modulator may have been manufactured incorrectly and could fail. Loss of ABS function would allow the front and/or rear wheel to lock under braking which, in conjunction with traffic and road conditions, and the rider’s reactions, could increase the risk of a crash causing property damage and/or personal injury. Correction: Dealers will replace the ABS modulator.
- Other#2013171
61 units affected
On certain motorcycles, the throttle cable guide was omitted during vehicle assembly. As a result, the throttle cables could become trapped in the steering stop, which could prevent the throttle from opening and closing normally. This could result in a loss of vehicle propulsion, or make it difficult to slow or stop the vehicle. Either issue could increase the risk of a crash causing property damage and/or personal injury. Correction: Dealers will install a throttle cable guide. Also, the throttle cables will be inspect and replaced if necessary.
- Lights And Instruments#2013089
413 units affected
On certain motorcycles, supports for the front and rear turn signal lamps were manufactured incorrectly and could break, causing the lamp assemblies to hang from their electrical wires. As a result, the driver’s intentions to turn may not be conveyed clearly to other road users, increasing the risk of a crash causing property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, replace the turn signal lamp assemblies.
- Wheels#2013027
41 units affected
On certain motorcycles, wheel bearings from an unapproved supplier were installed during the manufacturing process. Confidence in the bearing is low since Triumph has no details regarding the bearing supplier, or its quality controls and standards. The durability and performance of these bearings is thereby unknown. Bearing failure could cause a crash resulting in property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, replace the wheel bearings.
- Electrical#2011365
145 units affected
On certain motorcycles, the wiring harness for the evaporative purge valve could contact the exhaust and become damaged. This could result in an electrical short, which could cause the Engine Control Module fuse to fail, and the engine to stall. Engine stalling would result in lost vehicle propulsion which, in conjunction with traffic and road condition, and the rider's reactions, could increase the risk of a crash causing property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, reposition the wire harness.
Canadian data updated August 24, 2026
U.S. NHTSA recalls
00No recalls found for this make, model, and year.
Does this recall apply to my vehicle?
Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.
What to do
Recall repairs are free at a franchised dealer in both countries. To confirm a recall applies to your specific vehicle, or to book the work, contact your manufacturer or dealer with your full VIN, or use the official channel:
- NHTSA recall lookup (search by VIN) — U.S. National Highway Traffic Safety Administration
- Defects and recalls database — Transport Canada
Check a 2012 Triumph Daytona 675 ABS VIN
A VIN decode confirms your vehicle's exact model year, trim and assembly plant, then runs this same recall check against it.