RECALLS — PETERBILT 587
Peterbilt 587 recalls
Peterbilt 587 model years 2010–2019 covered by at least one recall campaign. Pick a year to see the Canadian and U.S. campaigns side by side.
Choose a model year
U.S. NHTSA campaigns are listed on each year page, where they are queried live by model year. The Canadian list below covers every year together.
Transport Canada recalls
21- Lights And Instruments#2020148
65,284 units affected
Issue: On certain trucks, the warning light for the tractor anti-lock brake system (ABS) may not turn on if the system loses power. If this happens, the driver will not get warning that the ABS is not working properly. Note: This problem would also cause the traction control (TC) and electronic stability control (ESC) lights not to turn on. Safety Risk: If a driver is not warned that the ABS is not working properly, there could be an increased risk of a crash. Corrective Actions: PACCAR will notify owners by mail and instruct you to take your truck to a dealer to update the software for the cab control module (CECU).
- Powertrain#2018739
2,634 units affected
On certain vehicles equipped with an Eaton automated manual transmission and electronic clutch actuator (ECA), the clutch may have been manufactured improperly and could fail. If this occurs, the broken clutch components could prevent the transmission from disengaging or shifting to neutral. This could result in unintended vehicle movement, even if the parking brake is applied, increasing the risk of a crash causing injury and/or damage to property. Correction: Dealers will recalibrate the Transmission Control Module (TCM).
- Fuel System#2018527
2,974 units affected
On certain trucks built with a Cummins X15 or ISX15 engine equipped with nylon fuel lines and a banjo bolt on the fuel pump, a blockage in the fuel cooling system may cause a fuel line to burst. This could result in a significant fuel leak onto the roadway, which would create a road hazard for other motorists. Additionally, this condition could also cause an engine stall without warning, without the ability to restart the engine. Both of these conditions may increase the risk of a crash causing injury and/or damage to property. Correction: Cummins-authorized dealers will replace the affected nylon line with a steel line.
- Steering#2017461
281 units affected
On certain vehicles, the castellated nut and cotter pin on the steer axle may not have been tightened to specification. This could cause the tie rod to become loose in the steer axle, which would result in audible noise and/or looseness in steering. If the vehicle were continued to be operated in this condition, the tie rod could disconnect from the knuckle, resulting in a complete loss of control of a vehicle wheel, which would increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will inspect the torque of the castellated nuts on the tie rod, and replace the tie rod stud and knuckle as necessary.
- Fuel System#2017361
533 units affected
On certain vehicles equipped with Cummins ISX 15 engines and certain fuel pumps, the drive gear on the fuel pump may spin loose on the drive shaft. This could result in a loss of pumping function, which could result in an engine stall without warning and not being able to be restarted, which could increase the risk of a crash causing injury and/or damage to property. Correction: Cummins-authorized dealers will replace the fuel pump.
- Brakes#2016603
184 units affected
On certain vehicles, the stop lamps may fail to activate due to a defective weld and incomplete circuit within the stop lamp switch. If the stop lamp switch fails during the application of the service brakes, the brake lights on the vehicle and trailer will not illuminate, thereby increasing the possibility of a crash causing injury and/or damage to property. Correction: Dealers will inspect and replace any 08-01760 stop lamp switches with a suspect date code (1056, 1026, 0821, 1386 and 1456).
- Engine#2016289
178 units affected
On certain vehicles, the Engine Control Module (ECM) may develop an internal electrical short circuit that could blow a fuse in the ECM's electrical supply circuit. This could cause the engine to stall without warning and prevent the vehicle from being restarted. Engine stalling without warning would result in lost propulsion which, in conjunction with traffic and road conditions, and the driver's reactions, could increase the risk of a crash causing property damage and/or personal injury. Correction: Dealers will replace the ECM.
- Engine#2015418
9 units affected
On certain vehicles equipped with a Cummins engine, the Engine Control Module (ECM) could develop an internal electrical short circuit that could blow a fuse in the ECM’s electrical supply circuit. This could result in an unexpected engine stall without the ability to restart the engine, which could increase the risk of a crash. Correction: Dealers will replacing the existing, affected ECM with a new ECM.
- Electrical#2015317
86 units affected
On certain vehicles equipped with PACCAR MX-13 engines and Leece Neville alternators, the alternator charge cable may chafe against an air conditioning discharge line. This chafing could lead to damage of the alternator cable's insulation and could lead to an electrical short, increasing the risk of fire, which could result in injury and/or damage to property. Correction: Dealers will rotate the alternator cable end 180 degrees to provide necessary clearance and reattach the cable to the alternator.
- Electrical#2015189
140 units affected
On certain vehicles equipped with PACCAR MX-13 engines and Delco-Remy 40SI alternators, the alternator charge cable may chafe against an air conditioning discharge line. This chafing could lead to damage of the alternator cable's insulation and could lead to an electrical short, increasing the risk of fire, which could result in injury and/or damage to property. Correction: Dealers will rotate the alternator cable end 180 degrees to provide necessary clearance and reattach the cable to the alternator.
- Label#2015095
30,064 units affected
Certain vehicles fail to comply with the requirements of Canada Motor Vehicle Safety Standard 120 - Tire Selection and Rims. The tire information label may indicate incorrect tire pressure, understated by 5 PSI, or a tire/rim/inflation pressure combination for which the maximum GAWR is slightly below the GAWR of the vehicle. Underinflated tires may not be capable of supporting the maximum load as reflected by the GAWR and GVWR specified on the certification label, which could cause tire failure resulting in injury and/or damage to property. Correction: Manufacturer will mail new tire and rims certification label.
- Brakes#2014590
218 units affected
On certain vehicles, brake chamber diaphragm(s) may not be properly seated. This could lead to brake drag, causing brake overheating or unintended spring brake application. These issues could increase the risk of a crash causing injury and/or property damage. Correction: Dealers will replace the brake chambers.
- Lights And Instruments#2014120
12 units affected
On certain vehicles, due to a software malfunction, activation of the high beam headlamps when the fog lamps are illuminated would cause the fog lamps to turn off for 10 seconds then turn back on automatically. This could produce unexpected fog lamp behaviour, excessive glare and/or impair the visibility of drivers in oncoming traffic, which could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will update vehicle software.
- Other#2014022
38 units affected
On certain vehicles, interior door pull handle fasteners may have been improperly tightened at time of assembly and could become loose or detached during use, increasing the risk of injury while entering or exiting the vehicle. Correction: Dealers will inspect door pull handle fasteners and tighten if necessary.
- Seats And Restraints#2014020
1,646 units affected
On certain vehicles, the seat belts may not comply with Canada Motor Vehicle Safety Standard 209 - Seat Belt Assemblies. Due to a defect in manufacturing, the seat belt buckle may not release as required by the standard. This could hinder egress from the vehicle in an emergency, increasing the risk of injury. Correction: Dealers will inspect and, if necessary, replace affected seatbelt buckles.
- Electrical#2013178
255 units affected
On certain trucks, an internal defect in the ignition switch can cause the starter to engage when the key is partially inserted. This would allow the engine to start unexpectedly, which could injure someone working in the engine compartment. Also, manual transmission vehicles without the neutral start option may move unexpectedly if the transmission is in gear at the time the key is inserted. This could result in a crash causing property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, replace the ignition switch assembly.
- Seats And Restraints#2013077
322 units affected
On certain trucks, the cables which anchor the seatbelt buckle assemblies could fail. Failure of the seatbelt to restrain the seat occupant would increase the risk of personal injury during a crash. Correction: Dealers will replace the driver and passenger seatbelt buckle assemblies.
- Brakes#2012027
1,434 units affected
On certain trucks equipped with Bendix ATR-6 Antilock Traction Relay valves, in extremely cold conditions (at or below -18 degrees Celsius), internal ATR valve leakage can occur. This could cause unintended brake application, which could overheat the affected brakes and cause a fire. Also, in certain low traction conditions, unexpected brake application can cause a loss of vehicle control and a crash. These issues could result in property damage and/or personal injury. Correction: Dealers will update the cover assembly on the ATR valves.
- Powertrain#2011263
23 units affected
On certain trucks equipped with a PACCAR MX engine and Eaton Ultrashift DM or Allison automatic transmission (without auto-neutral), the Fast Idle Control (also known as high idle) may be activated by the operator while the transmission is in gear. This could override the parking brake, allowing the vehicle to move unexpectedly. Unintended vehicle movement could result in a crash causing property damage and/or personal injury. Correction: Dealers will update the engine control software.
- Engine#2011087
589 units affected
On certain vehicles equipped with a PACCAR MX engine, the oil module centrifugal spinner filter cap may become loose, possibly allowing the cap to come off and engine oil to partially discharge from the oil module onto nearby exhaust components. The discharge of engine oil onto hot exhaust components could result in a fire causing property damage and/or personal injury. Correction: Dealers will re-torque the oil module filter cap and install a secondary retention device on the secondary centrifugal spinner filter cap.
- Engine#2010329
59 units affected
On certain vehicles, the exhaust gas recirculation (EGR) oil seal installed on the output shaft of the valve actuator may delaminate, possibly allowing engine oil to leak from the EGR valve onto exhaust components. Engine oil leaking onto hot exhaust components, such as when the engine is under significant load, may create the possibility of a fire which can result in personal injury or property damage. Correction: Dealers will replace the EGR valve.
Canadian data updated August 24, 2026
Does this recall apply to my vehicle?
Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.
What to do
Recall repairs are free at a franchised dealer in both countries. To confirm a recall applies to your specific vehicle, contact your manufacturer or dealer with your full VIN, or use the official channel:
- NHTSA recall lookup (search by VIN) — U.S. National Highway Traffic Safety Administration
- Defects and recalls database — Transport Canada