2015 Mitsubishi RVR recalls

• Label#2024554September 19, 2024

  258,000 units affected

  Issue: On certain vehicles, the compliance label may be missing information in French. The words and abbreviations listed on the label for "TIRES", "RIMS", "WITH", "FR" and "RR" and appear in English only, when they should be listed as "TIRES/PNEUS", "RIMS/JANTES", "WITH/AVEC", "FR/AVT" and "RR/ARR". Canadian regulations require this information to be listed on the label in both English and French. Safety Risk: These small errors do not affect vehicle safety. Corrective Actions: This is not a recall. Mitsubishi has corrected the compliance label for all new vehicles.

• Structure#2020216May 15, 2020

  81,449 units affected

  Issue: On certain vehicles, road salt can corrode the front cross-member (subframe). As a result, a lower control arm could eventually detach from the cross-member. This could cause a loss of vehicle control. Safety Risk: A loss of control can create the risk of a crash. Corrective Actions: Mitsubishi will notify owners by mail and instruct you to take your vehicle to a dealer to inspect the front cross-member (subframe). If no significant corrosion is found, the dealer will spray a sealing and anti-corrosion coating both inside and on the cross-member. If significant corrosion is found, the dealer will replace the cross-member.

• Visual System#2018083February 12, 2018

  37,654 units affected

  On certain vehicles, water may drain from the windshield cowl area onto the front wiper link ball joint. Over time, this could result in corrosion and/or wear to the joint, which could result in the separation of the wiper link ball. If separation were to occur, the windshield wipers could become inoperative, which could limit the driver’s visibility under certain operating conditions which may increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will replace the wiper link rod with a countermeasure one, and will inspect the wiper motor crank arm and replace as necessary.

• Brakes#2018053January 26, 2018

  39,131 units affected

  On certain vehicles, insufficient rust prevention to the parking brake shaft and insufficient sealing performance of the rear brake caliper boot could allow water to penetrate inside these components causing corrosion. As a result, the parking brake shaft may become stuck causing brake dragging and/or decreased parking brake performance. Additionally, the automatic adjuster for the brake pad clearance of the rear brake caliper with the built-in parking brake may not work correctly. These conditions could lead to a vehicle rollaway, which would increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will inspect and repair the rear brakes as necessary.

• Engine#2017475September 29, 2017

  28,615 units affected

  On certain vehicles, defective electrical relays may have been installed in the power distribution center. This could cause various electrical circuits to fail, potentially resulting in engine stalling, reduced engine power, or loss of engine cooling fan function potentially resulting in engine overheating. These issues could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will replace affected relay(s) with updated parts.

• Visual System#2016530October 27, 2016

  27,982 units affected

  On certain vehicles, water may drain from the windshield cowl area and potentially collect in the area of the wiper motor breathing hole. If the wiper motor is not operating, water could potentially enter the wiper motor through the breathing hole. If this occurs, over time, it could result in corrosion and/or an electrical conduction failure, both of which could result in the wiper motor not operating. If the wiper motor were to stop operating, the windshield wipers would become inoperative, which could limit the driver’s visibility under certain operating conditions which may increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will replace the wiper motor with an upgraded wiper motor that will prevent water intrusion.

• Other#2016371July 22, 2016

  4,917 units affected

  On certain vehicles equipped with a continuously variable transmission (CVT), the clamp(s) on the transmission fluid hoses may not have been properly closed during the assembly process. If operated under this condition, this could cause a hose to disconnect from the transmission fitting, leading to a transmission fluid leak. A transmission fluid leak could result in a loss of motive power which may increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will inspect and close any open transmission fluid hose clamps.

• Label#2015410September 17, 2015

  23 units affected

  Certain vehicles fail to comply with the requirements of Canada Motor Vehicle Safety Standard 205 - Glazing Materials. The quarter panel glass windows are labeled with the manufacturer’s model number “M-66” and “AS2” instead of the correct number “M-131” and “AS3”. Correction: A production change has been undertaken to remedy these technical non-compliance conditions. No corrective recall action is required as the technical non-compliance conditions are deemed to be non-safety related.

• Seats And Restraints#2014525November 20, 2014

  13,058 units affected

  On certain vehicles, the lap end attachment fastener on the front passenger seat belt may not have been torqued to proper specification. If the tightening torque of the fastener is too low, road vibrations could cause the fastener to loosen further. If this were to occur, the fastener may not properly restrain the front passenger occupant in the event of a crash, which could increase the risk of injury to the seat occupant in a crash. Correction: Dealers will inspect the torque value of the front passenger seat belt lap end attachment, and correct as necessary.

Canadian data updated August 24, 2026

No recalls found for this make, model, and year.