RECALLS — MITSUBISHI LANCER EVOLUTION
Mitsubishi Lancer Evolution recalls
Mitsubishi Lancer Evolution model years 2010–2015 covered by at least one recall campaign. Pick a year to see the Canadian and U.S. campaigns side by side.
Choose a model year
U.S. NHTSA campaigns are listed on each year page, where they are queried live by model year. The Canadian list below covers every year together.
Transport Canada recalls
11- Visual System#2018588
80,610 units affected
On certain vehicles, water may drain from the windshield cowl area onto the front wiper link ball joint. Over time, this could result in corrosion and/or wear to the joint, which could result in the separation of the wiper link ball. If separation were to occur, the windshield wipers could become inoperative, which could limit the driver’s visibility under certain operating conditions which may increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will replace the wiper link rod with a countermeasure one, and will replace the wiper motor crank arm with a new one.
- Accessories#2018054
18,795 units affected
On certain vehicles, the sunroof may not have been bonded properly and could separate from the vehicle. This could pose a risk to other road users, increasing the risk of injury and/or damage to property. Correction: Dealers will replace the sunroof glass assembly.
- Engine#2017475
28,615 units affected
On certain vehicles, defective electrical relays may have been installed in the power distribution center. This could cause various electrical circuits to fail, potentially resulting in engine stalling, reduced engine power, or loss of engine cooling fan function potentially resulting in engine overheating. These issues could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will replace affected relay(s) with updated parts.
- Airbag#2016382
66,076 units affected
On certain vehicles operated in areas of heavy road salt usage, a mixture of snow, water and road-salt solution may infiltrate between the front impact sensor and the bracket that attaches it to the vehicle. Over time, repeated freezing/thawing cycles could cause a crack to develop in the sensor case allowing water intrusion and short circuit of the sensor. In the event of a crash, this could result in delayed deployment of the driver and passenger front airbags which would increase the risk of injury. Correction: Dealers will inspect the front impact sensor and replace it if it is found to be cracked. An updated designed bracket and cover will also be installed.
- Brakes#2015386
340 units affected
On certain vehicles, the right parking brake cable may have been incorrectly installed resulting in insufficient clearance with the fuel tank, causing abrasive contact between the two components. This contact could result in the coating on the fuel tank deteriorating and allowing rust to form, which could result in fuel leakage. Fuel leakage, in the presence of an ignition source, could result in a fire causing injury and/or damage to property. Correction: Dealers will replace the right parking brake cable and inspect the fuel tank. If the fuel tank’s exterior coating is damaged from contact with the parking brake cable, the fuel tank will also be replaced.
- Heater And Defroster#2015166
32,810 units affected
On certain vehicles, the blower motor may have been incorrectly manufactured. This could result in a premature failure of the blower motor which could affect the defroster performance resulting in reduced visibility, increasing the risk of a crash causing injury and/or damage to property. Correction: Dealers will replace blower motor and the power transistor as needed.
- Lights And Instruments#2015165
27,277 units affected
On certain vehicles, the ECU which controls the head lights, tail lights and windshield wipers may have been improperly manufactured. This could cause the voltage in the ECU to become unstable and cause the head lights and/or tail lights to turn off and/or the windshield wipers to become inoperable. This could affect driver visibility and decrease vehicle conspicuity, increasing the risk of a crash causing injury and/or damage to property. Correction: Dealers will inspect and replace the affected ECU with an updated version.
- Engine#2014397
49,227 units affected
On certain vehicles, the drive belt material may cause abnormal pulley wear. If the vehicle is driven under this condition, the drive belt may become damaged from the worn pulley and detach, affecting electrical charging system and cooling system function and would illuminate the engine warning lamp(s) on the instrument panel. This could result in battery depletion and an overheated engine, resulting in a loss of motive power. Vehicles equipped with a hydraulic power steering system could also experience loss of power steering assist. These issues could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will replace the drive belt, and the pulley will be replaced if it is found worn beyond a certain level.
- Steering#2014192
51 units affected
Certain vehicles may have been manufactured with insufficient clearance between the power steering pressure tube and the cross-member brace, possibly causing the power steering pressure tube to rust from abrasive contact. This could cause a power steering fluid leak, resulting in increased steering effort and potential for a fire in the presence of an ignition source. This could increase the risk of injury and/or damage to property. Correction: Dealers will inspect line routing and replace the pressure line as required.
- Powertrain#2013316
1,009 units affected
On certain vehicles, the clutch master cylinder may fail, resulting in an inability to disengage the clutch or to shift gears. This could result in unintended vehicle movement, increased stopping distances and engine stalling. Such an occurrence could increase the risk of a crash causing injury or property damage. Correction: Dealers will replace the clutch master cylinder.
- Lights And Instruments#2012001
2,301 units affected
Certain vehicles fail to comply with the requirements of Canada Motor Vehicle Safety Standard 108 - Lighting System and Retroreflective Devices. An incorrectly manufactured turn signal lever could cause the auto-cancel function to become inoperative. The vehicle operator will, however, continue to be able to manually cancel the turn signals. Correction: Dealers will inspect and, if necessary, replace the turn signal lever.
Canadian data updated August 24, 2026
Does this recall apply to my vehicle?
Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.
What to do
Recall repairs are free at a franchised dealer in both countries. To confirm a recall applies to your specific vehicle, contact your manufacturer or dealer with your full VIN, or use the official channel:
- NHTSA recall lookup (search by VIN) — U.S. National Highway Traffic Safety Administration
- Defects and recalls database — Transport Canada