2012 Mack TD recalls

• Powertrain#2016495October 11, 2016

  1,690 units affected

  On certain vehicles, the cap nut that retains the interaxle driveshaft yoke to the rear axle input shaft may prematurely loosen. If the nut were to loosen and come off, the yoke could separate from the axle input shaft and cause the drive shaft to disconnect. A disconnected drive shaft would result in a loss of motive power, and create a road hazard, both of which could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will inspect the torque on the cap nut, and the nut will be replaced if the torque is found under specification. Note: This is an expansion of recall 2016-079.

• Powertrain#2016079February 18, 2016

  1,068 units affected

  On certain vehicles, the cap nut that retains the interaxle driveshaft yoke to the rear axle input shaft may prematurely loosen. If the nut were to loosen and come off, the yoke could separate from the axle input shaft and cause the drive shaft to disconnect. A disconnected drive shaft would result in a loss of motive power, and create a road hazard, both of which could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will replace the cap nut, and inspect the threads on the input shaft. If the threads are damaged, the input shaft will be replaced.

• Brakes#2015372August 17, 2015

  241 units affected

  On certain vehicles, The chassis electrical harness and air brake lines may not have been properly secured at the crossmember. This could cause the electrical cables and air lines to fall down and get twisted in the driveline. This could affect safety systems such as brakes, increasing stopping distances or causing unintended parking brake application. This could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will inspect and repair the vehicle as needed.

• Electrical#2014527November 20, 2014

  11,668 units affected

  On certain model vehicles, water around the windshield can migrate into the Electronic Power Distribution Module and contaminate it. As a result, circuits may be bridged creating an electrical short. This could potentially result in a fire, increasing the risk of injury and/or damage to property. Correction: Dealers will inspect the module, and if found contaminated, will replace it. Additional measures will be taken to address the leak if contamination is found. Note: This is an expansion of recall 2014-053.

• Lights And Instruments#2014146April 22, 2014

  5,990 units affected

  On certain vehicles, the directional/hazard signal flasher may fail. Actuation of the turn signal or hazard lights in this condition would cause them to remain illuminated and not flash as intended. As a result, drivers may not be able to clearly signal their intentions to turn, change lanes or warn others in an emergency situation. Correction: Dealers will replace the turn signal/hazard flasher module.

• Electrical#2014053February 21, 2014

  2,462 units affected

  On certain model vehicles, water around the windshield can migrate into the Electronic Power Distribution Module and contaminate it. As a result, circuits may be bridged creating an electrical short. This could potentially result in a fire, increasing the risk of injury and/or damage to property. Correction: Dealers will inspect the module, and if found contaminated, will replace it. Additional measures will be taken to address the leak if contamination is found.

• Powertrain#2011205May 19, 2011

  584 units affected

  On certain trucks, the driveshaft may not have been welded correctly during the manufacturing process. This could allow the driveshaft to fracture along the length of the tube seam weld when torque is applied. The fractured tube can twist or sever, which could result in additional damage to the driveline, the vehicle to which it is attached, and any additional nearby components. Should the brake air lines become damaged, it could allow spring brake application, causing immediate brake lock-up. If this occurs while the vehicle is in motion, it could result in a crash. Also, failure of the driveshaft would result in lost vehicle propulsion which, in conjunction with traffic and road conditions, and the driver's reactions, could increase the risk of a crash. Either condition could result in property damage and/or personal injury. Correction: Dealers will replace the driveshaft assembly.

Canadian data updated August 24, 2026

• EXTERIOR LIGHTING:TURN SIGNAL:FLASHER UNIT#14V208000April 18, 2014

  Mack Trucks Inc. (Mack) is recalling certain model year 2010-2014 CHU, CXU, and MRU, 2007 CT and CV, 2008-2014 GU, and 2011-2014 LEU, and TD trucks manufactured February 28, 2006, through November 8, 2013, and equipped Hamsar Electronic Flasher. The hazard warning lights may fail.

  Risk: A failure of the hazard warning lights could reduce the trucks visibility, increasing the risk of a crash.

  Remedy: Mack will notify owners, and dealers will replace the electronic flasher unit, free of charge. The recall will begin by mid-June 2014. Interim letters went out to owners on June 23, 2014. The recall began on July 25, 2014. Owners may contact Mack customer service at 1-866-298-6586. Mack's number for this recall is SC0379.

• ELECTRICAL SYSTEM#14V078000February 21, 2014

  Mack Trucks, Inc. (Mack) notified the agency on February 20, 2014, that they are recalling certain model year 2010-2012 CHU, CXU, GU and TD vehicles manufactured from June 16, 2009, through July 8, 2011. While continuing to research the scope of the issue, Mack expanded the recall on November 18, 2014 to include certain model year 2008-2009 and 2013-2014 CHU, CXU, GU and TD vehicles manufactured from June 16, 2009, through July 8, 2011. Having completed its investigation, Mack once again expanded the recall during February 2015 to include an additional 53,780 vehicles from model years 2007 and 2015. The recall now covers model year 2007-2015 includes CHU, CXU, GU and TD vehicles produced October 13, 2006, through October 3, 2014. In the affected vehicles, the Electronic Power Distribution Module (EPDM) may be contaminated from water leaks in, and around, the windshield. If exposed to water leaks, contaminants such as road salts may deposit on the EPDM.

  Risk: Deposits of contaminants may result in the circuits being bridged, creating a high resistance short, increasing the risk of a fire.

  Remedy: Mack has notified owners, and dealers will inspect the EPDM. If contamination has occurred, dealers will replace the EPDM and address the leak, free of charge. Owners of model year 2010-2012 CHU, CXU, GU and TD vehicles were initially notified April 24, 2014. Owners affected by the recall expansions were notified in February 2015. Owners may contact Mack Trucks at 1-336-393-2000. Mack's number for this recall is SC0375.

• POWER TRAIN:DRIVELINE#11V295000May 20, 2011

  MACK TRUCKS IS RECALLING CERTAIN MODEL YEAR 2012, CHU, CXU, GU, MRU, LEU, AND TD TRUCKS EQUIPPED WITH A MERITOR DRIVELINE. THE TUBING USED TO ASSEMBLE THE AFFECTED DRIVELINES HAS A NONCONFORMING SEAM WELD WITH INSUFFICIENT BONDING OF THE MATERIAL.

  Risk: THIS CAN RESULT IN SEAM WELD FRACTURE WHEN TORQUE IS APPLIED. ONCE THE TUBE SEAM WELD IS FRACTURED, THE DRIVELINE MAY BECOME INOPERABLE WHICH MAY RESULT IN A DISABLED VEHICLE OR DEBRIS FROM THE DRIVELINE MAY FALL ON THE ROADWAY, BOTH OF WHICH CAN INCREASE THE RISK OF A CRASH.

  Remedy: DEALERS WILL REPLACE THE DRIVELINES FREE OF CHARGE. THE SAFETY RECALL BEGAN ON JULY 25, 2011. OWNERS MAY CONTACT MACK TRUCKS AT 1-800-528-6586.