Lexus IS 350C recalls

• Electrical#2021723November 24, 2021

  55,683 units affected

  Issue: This recall is for certain block heater kits installed on certain vehicles or sold as accessories at Toyota or Lexus dealerships. On certain vehicles, the engine block heater cable may not have enough heat protection and could be damaged by high temperatures. If this happens, the cable could short circuit while plugged in, and cause the wiring to overheat or melt. Note: This recall only affects the following block heater/cord part numbers: C014003034 PK5A408J09 PU14000904 C014003151 PK5A408J13 PU14000905 C014000885 PK5A489J11 PU14000907 C014000888 PK5A489J22 PU14000909 C014000907 PK5A410H00 PU14000911 C014100904 PU14000900 PU14000913 C014100907 PU14000901 PU14003571 C014100911 PU14000902 PK5A489J14 PK5A408J05 PU14000903 Safety Risk: Engine block heater wiring that overheats or melts could create the risk of a fire. Corrective Actions: Toyota recommends that you should stop using the engine block heater immediately. Toyota will notify owners by mail and instruct you to take your vehicle to a dealer to disable the engine block heater. For some vehicles, the corrective actions for this recall are under development. For others, a new engine block heater cannot be installed, and the owner will receive a refund of the purchase price of the engine block heater.

• Airbag#2019008January 9, 2019

  376,282 units affected

  Issue: On certain vehicles, long-term exposure to high absolute humidity and temperature, combined with high temperature cycling, may eventually degrade the propellant contained in the passenger-front airbag. This could cause the airbag to deploy with more force than normal. If the airbag inflator ruptures, fragments could be propelled toward vehicle occupants or cause damage to the airbag assembly, preventing its proper function. Safety Risk: If the vehicle is involved in a crash requiring an airbag deployment, the airbag inflator could rupture and create a risk of injury. Corrective Action: Owners will be notified by mail and instructed to take their vehicle to a dealer to have the passenger-front airbag inflator or airbag module replaced. Note: The Canadian climate results in the propellant degrading slowly. This recall is being conducted as a precaution to address future risk. It is expected that all airbag inflators will be replaced before their function would be affected.

• Engine#2013297September 4, 2013

  3,922 units affected

  On certain vehicles, the bolts used to secure the housing and sprocket of the intake-side Variable-Valve Timing (VVT) gear assembly could loosen. If this occurs, the VVT gear will not control the intake valves correctly. In some instances, the VVT gear housing and sprocket could separate, causing the engine to stall. Engine stalling would result in a loss of vehicle propulsion which, in conjunction with traffic and road conditions, and the driver’s reactions, could increase the risk of a crash causing property damage and/or personal injury. Correction: Dealers will replace the VVT unit with an improved version.

• Visual System#2013031January 30, 2013

  16,756 units affected

  On certain vehicles, the wiper arm securing nuts could have been insufficiently tightened during assembly. If the movement of the wipers is restricted by an external load, such as heavy snow on the windshield, the wiper arms could slip and one or both wipers could become inoperative. If this occurs, driver visibility could be reduced, which could increase the risk of a crash causing injury and/or property damage. Correction: Dealers will clean the mating surface of the wiper arm and motor shaft and install improved wiper arm nuts.

Canadian data updated August 24, 2026