2013 Kenworth T880 recalls

• Lights And Instruments#2020148April 7, 2020

  65,284 units affected

  Issue: On certain trucks, the warning light for the tractor anti-lock brake system (ABS) may not turn on if the system loses power. If this happens, the driver will not get warning that the ABS is not working properly. Note: This problem would also cause the traction control (TC) and electronic stability control (ESC) lights not to turn on. Safety Risk: If a driver is not warned that the ABS is not working properly, there could be an increased risk of a crash. Corrective Actions: PACCAR will notify owners by mail and instruct you to take your truck to a dealer to update the software for the cab control module (CECU).

• Lights And Instruments#2018632November 19, 2018

  72 units affected

  On certain trucks, the intermediate side marker lamp/turn signals do not comply with the requirements of Canada Motor Vehicle Safety Standard (CMVSS) 108 - Lighting System and Retroreflective Devices. The intermediate side marker lamp/turn signals, mounted to the side extenders, do not include the required reflex reflectors. This could decrease vehicle conspicuity and potentially increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will install reflex reflective tape to the side extender near the intermediate side marker lamps.

• Electrical#2017374July 27, 2017

  240 units affected

  On certain vehicles, the polyfuse for the spotlight could develop a short circuit in the cabin fuse box. A short circuit could result in overheating and melting of the fuse box, and could increase the risk of a fire causing injury and/or damage to property. Correction: Dealers will replace the optional polyfuse switch in the spotlight circuit with a standard fuse.

• Brakes#2017267May 18, 2017

  13 units affected

  Certain vehicles equipped with Neway ADZ Tridem rear suspension may not comply with the brake timing requirements of Canada Motor Vehicle Safety Standard (CMVSS) 121 - Air Brake Systems. The brake control airline between the two relay valves is plumbed with a 3/8" airline but should be plumbed with a 1/4" line to balance the service brake application timing and meet the requirement of the standard. An oversized airline could cause a delay in brake activation and increase stopping distances, which could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will update and modify the brake piping of the air brake system.

• Lights And Instruments#2015316July 20, 2015

  4,791 units affected

  Certain vehicles equipped with HID headlamps may not comply with the requirements of Canada Motor Vehicle Safety Standard 108 - Lighting System and Retroreflective Devices. A Daytime Running Lamp (DRL) that is optically combined with a turn signal lamp must switch off when the turn signal lamp is switched on as a hazard warning signal. In the affected vehicles, the DRL overrides the hazard flashing functionality after the service brake is applied for more than 2 seconds, which is contrary to the standard. The hazard functionality returns to normal when the application of the service brake is removed. Turn signal functionality would not impacted. Failure to warn oncoming vehicles with flashing hazard lamps could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will update vehicle software.

• Seats And Restraints#2013077March 12, 2013

  322 units affected

  On certain trucks, the cables which anchor the seatbelt buckle assemblies could fail. Failure of the seatbelt to restrain the seat occupant would increase the risk of personal injury during a crash. Correction: Dealers will replace the driver and passenger seatbelt buckle assemblies.

Canadian data updated August 24, 2026

• ELECTRONIC STABILITY CONTROL (ESC)#20V199000April 6, 2020

  PACCAR Incorporated (PACCAR) is recalling certain 2008-2019 Peterbilt 330, 335, 337, 340, 348, 365, 367, 384, 386, 387, 388, 389, 567, 579 and 587 vehicles and 2008-2020 Kenworth T170, T270, T370, T660, T680, T800, T880, and W900 vehicles equipped with NAMUX Software. In the event that the Anti-lock Brake System (ABS) loses battery and/or ignition power to the controller, the dash warning light for the ABS may not illuminate to warn the driver of the loss of ABS. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 121, "Air Brake Systems," and 136, "Electronic Stability Control System on Heavy Vehicles."

  Risk: If the driver unknowingly operates the vehicle without the ABS functioning, there would be an increased risk of a crash.

  Remedy: PACCAR will notify owners, and dealers will update the NAMUX software within the cab control module, free of charge. PACCAR issued owners an interim notification on June 4, 2020. The recall began May 26, 2020. Owners may contact Kenworth customer service at 1-425-828-5888 or Peterbilt customer service at 1-940-591-4220. PACCAR's number for this recall is 20pbc AND 20KWB.

• EXTERIOR LIGHTING#18V816000November 16, 2018

  PACCAR Incorporated (PACCAR) is recalling certain 2013-2019 Kenworth T680 and T880 and Peterbilt 579 trucks, greater than 30 feet long and equipped with side extender mounted intermediate marker lamp/turn signals that do not include a reflex reflector. Since both intermediate side marker lamps and reflex reflectors are required, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 108, "Lamps, Reflective Devices, and Associated Equipment."

  Risk: Missing reflex reflectors can reduce the vehicle's visibility to other drivers, increasing the risk of a crash.

  Remedy: PACCAR will notify owners and dealers will install reflex reflective tape, free of charge. The recall began January 15, 2019. Owners may contact PACCAR customer service at 1-918-259-3258. PACCAR's number for this recall is 18KWF, and 18PBC.

• EXTERIOR LIGHTING#17V471000July 25, 2017

  PACCAR Incorporated (PACCAR) is recalling certain 2013-2017 Peterbilt 567 and 579 Kenworth T680 and T880 trucks equipped with optional spotlights. The spotlight circuit may not be adequately protected in the event of a short.

  Risk: A short in the spotlight circuitry may increase the risk of a fire at the cab fuse block.

  Remedy: PACCAR will notify owners, and dealers will change the polyfuse switch in the spotlight circuit to a standard fuse, free of charge. The recall began on September 19, 2017. Owners may contact PACCAR customer service at 1-940-591-4220. PACCAR's number for this recall is 17KWC and 717-B.

• SERVICE BRAKES, AIR#17V322000May 16, 2017

  PACCAR Incorporated (PACCAR) is recalling certain 2012-2018 Kenworth T800 and T880 vehicles equipped with Neway ADZ tridem rear suspensions. The brake control airline may be the incorrect size, resulting in an imbalance in the service brake application timing. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 121, "Air brake systems."

  Risk: An incorrectly sized airline may lengthen the distance needed to stop the vehicle, increasing the risk of a crash.

  Remedy: Kenworth will notify owners, and dealers will modify the air brake system with updated brake piping, free of charge. The recall began on June 21, 2017. Owners may contact Kenworth customer service at 1-425-828-5000. PACCAR's number for this recall is 17KWB.

• EXTERIOR LIGHTING:HAZARD FLASHING WARNING LIGHTS#15V458000July 22, 2015

  PACCAR Incorporated (PACCAR) is recalling certain model year 2011-2016 Kenworth T440, T470, T660, T680, and T880 trucks manufactured January 14, 2010, to May 22, 2015, and equipped with HID Headlamps and the option for Daytime Running Lamps (DRL). The DRLs are required to deactivate when the hazard warning lights are activated, however, the DRLs on these vehicles override the hazard flashing functionality after the brake pedal is pushed for more than two seconds. Normal hazard flashing functionality returns once the service brake is released. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) No. 108, "Lamps, Reflective Devices, and Associated Equipment."

  Risk: If the hazard warning lamps are overridden by the DRL, oncoming vehicles may fail to be warned, increasing the risk of a crash.

  Remedy: Kenworth will notify owners, and dealers will update the cab controller software, free of charge. The recall began on September 167, 2015. Owners may contact Kenworth customer service at 1-425-828-5000. Kenworth's number for this recall is 15KWL.

• SEAT BELTS#13V091000March 13, 2013

  PACCAR is recalling certain model year 2013-2014 Kenworth T680 and T880 trucks and model year 2013-2014 Peterbilt 567, 579 and 587 trucks equipped with air ride seats. The cables for anchoring the seat belt buckles of both the driver and passenger seat may fray.

  Risk: In the event of a crash, a frayed seat belt could cause the belt to separate from the seat, increasing the risk of injury to the seat occupant.

  Remedy: PACCAR will notify owners, and dealers will replace both seat belt buckle assemblies, free of charge. The recall began on May 9, 2013. Owners may contact Kenworth at 1-425-828-5000 or Peterbilt at 1-940-591-4000.

• ELECTRICAL SYSTEM#13V048000February 13, 2013

  PACCAR is recalling certain model year 2013-2014 Kenworth T680 and T880 trucks, manufactured from January 18, 2012, through February 1, 2013; and model year 2013-2014 Peterbilt 579 and 567 vehicles, manufactured from January 20, 2012, through January 31, 2013. The Exterior Lights Self-Test switch is intended to be used when the vehicle is parked. If the switch is pressed while the vehicle is in motion, the Exterior Lights Self-Test switch will cause all exterior lighting to be extinguished.

  Risk: An unexpected loss of lighting during vehicle operation may reduce the driver's ability to see other vehicles, pedestrians, or objects, as well as reduce the truck's visibility to other drivers or pedestrians, increasing the risk of crash.

  Remedy: PACCAR will notify owners, and dealers will disable the Exterior Lights Self-Test software parameter and remove the Exterior Lights Self-Test switch and install a switch plug in its place. The services will be offered free of charge. The recall began on February 28, 2013. Owners may contact Kenworth at 1-425-828-5000 or Peterbilt at 1-940-591-4000.