Skip to content
VINscan

RECALLS — MAKE · MODEL · YEAR

2017 Kenworth C500 recalls

8 safety recall campaigns have been filed for the 2017 Kenworth C500 with Transport Canada and the U.S. NHTSA. Here is what both agencies say.

Canadian recalls
04
U.S. recalls
04
Total campaigns
08

Transport Canada recalls

04
  • Fuel System#2018527

    2,974 units affected

    On certain trucks built with a Cummins X15 or ISX15 engine equipped with nylon fuel lines and a banjo bolt on the fuel pump, a blockage in the fuel cooling system may cause a fuel line to burst. This could result in a significant fuel leak onto the roadway, which would create a road hazard for other motorists. Additionally, this condition could also cause an engine stall without warning, without the ability to restart the engine. Both of these conditions may increase the risk of a crash causing injury and/or damage to property. Correction: Cummins-authorized dealers will replace the affected nylon line with a steel line.

  • Electrical#2018442

    4,186 units affected

    On certain trucks with an ISX15 engine and a 1.9 M cab, the engine wiring harness is missing circuits to allow the illumination of Check (CEL) and Stop (SEL) Engine Lamps and sounding of the Stop Engine Alarm. A failure to notify the operator of a serious engine problem may result in an engine failure without warning, and loss of motive power while the vehicle is in motion, which could increase the risk of a crash causing injury and/or property damage. Correction: Dealers will inspect and/or test the engine harness for the missing circuits, and if found missing, an overlay jumper harness will be installed.

  • Brakes#2017267

    13 units affected

    Certain vehicles equipped with Neway ADZ Tridem rear suspension may not comply with the brake timing requirements of Canada Motor Vehicle Safety Standard (CMVSS) 121 - Air Brake Systems. The brake control airline between the two relay valves is plumbed with a 3/8" airline but should be plumbed with a 1/4" line to balance the service brake application timing and meet the requirement of the standard. An oversized airline could cause a delay in brake activation and increase stopping distances, which could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will update and modify the brake piping of the air brake system.

  • Engine#2016289

    178 units affected

    On certain vehicles, the Engine Control Module (ECM) may develop an internal electrical short circuit that could blow a fuse in the ECM's electrical supply circuit. This could cause the engine to stall without warning and prevent the vehicle from being restarted. Engine stalling without warning would result in lost propulsion which, in conjunction with traffic and road conditions, and the driver's reactions, could increase the risk of a crash causing property damage and/or personal injury. Correction: Dealers will replace the ECM.

Canadian data updated August 24, 2026

U.S. NHTSA recalls

04
  • SERVICE BRAKES, AIR:SUPPLY:RESERVOIR/TANK#24V145000

    PACCAR Incorporated (PACCAR) is recalling certain 2009-2021 Kenworth C500, 2012-2021 Kenworth T440, 2009-2015 Kenworth T660, 2015-2024 Kenworth T680, 2009-2024 Kenworth T800, 2009-2020 Kenworth T370, 2014-2023 Kenworth T880, 2011-2016 Kenworth T470, 2023 Kenworth T480, and 2009-2019 Kenworth W900 vehicles. The air tanks have an insufficient volume of air for the brake system. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 121, "Air Brake Systems."

    Risk: Insufficient air volume can reduce braking performance and increase the risk of a crash.

    Remedy: Dealers will install the correct volume air tanks, free of charge. Owner notification letters were mailed August 12, 2024. Additional owner notification letters were mailed October 27, 2025. Owners may contact PACCAR customer service at 1-425-828-5888. PACCAR's number for this recall is 24KWD.

  • ENGINE AND ENGINE COOLING:ENGINE:DIESEL#18V657000

    PACCAR Incorporated (PACCAR) is recalling certain 2017-2019 Kenworth C500, T600, T660, T680, T800, T880 and W900 trucks, as well as Peterbilt 367, 386, 389, 567, 579 and 587 trucks, equipped with Cummins ISX15 or X15 diesel engines. In certain driving conditions, such as on a long down-hill grade, the fuel line may burst if the fuel pump cooling circuit screen becomes restricted.

    Risk: If the fuel line bursts, fuel may leak onto the road resulting in a roadway hazard for other motorists. The engine may also stall without warning, resulting in the vehicle's inability to restart, increasing the risk of a crash.

    Remedy: Cummins will notify owners, and dealers will replace the suspect fuel pump cooling circuit screen, free of charge. The recall began November 21, 2018. Owners may contact PACCAR customer service at 1-940-591-4220. PACCAR's number for this recall is 18E081.

  • ENGINE AND ENGINE COOLING:ENGINE:DIESEL#18V555000

    PACCAR Incorporated (PACCAR) is recalling certain 2016-2019 Kenworth C500, T660, T800, and W900 vehicles, equipped with 1.9M ISX15 engines. The engine harnesses may have been manufactured without check engine light (CEL) and stop engine light (SEL) circuits, preventing the driver from being warned of a serious engine problem.

    Risk: If the driver is not warned of a serious engine problem, the engine may unexpectedly fail, increasing the risk of a crash.

    Remedy: PACCAR will notify owners, and dealers will inspect or test the ISX15 engine harness, and install an overlay jumper harness to supply the missing CEL and SEL circuits, free of charge. The recall began November 30, 2018. Owners may contact PACCAR customer service at 1-918-259-3258. PACCAR's number for this recall is 18KWE.

  • ELECTRICAL SYSTEM:IGNITION:MODULE#16V426000

    PACCAR Incorporated (PACCAR) is recalling certain model year 2017 Kenworth C500, T660, T680, T800, T880, and W900 vehicles manufactured March 9, 2016, to April 26, 2016 and 2017 Peterbilt 320, 365, 367, 389, 567, 579, and 587 vehicles manufactured March 10, 2016, to May 6, 2016. The affected vehicles are equipped with Cummins ISX12 or ISX15 engines and have an engine control module (ECM) that may short circuit, causing the engine to stall without warning without the ability to restart it.

    Risk: An engine stall can increase the risk of a crash.

    Remedy: Cummins will notify owners, and Cummins dealers will replace the defective engine control modules, free of charge. The began on July 8, 2016. Owners may contact Cummins customer service at 1-800-343-7357, Kenworth customer service at 1-425-828-5000 or Peterbilt customer service at 1-940-591-4000. PACCAR's numbers for this recall are 16KWB (Kenworth) and 616-C (Peterbilt).

Does this recall apply to my vehicle?

Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.

What to do

Recall repairs are free at a franchised dealer in both countries. To confirm a recall applies to your specific vehicle, or to book the work, contact your manufacturer or dealer with your full VIN, or use the official channel:

Check a 2017 Kenworth C500 VIN

A VIN decode confirms your vehicle's exact model year, trim and assembly plant, then runs this same recall check against it.

Data sources and coverage limits