Skip to content
VINscan

RECALLS — MAKE · MODEL · YEAR

2010 Jaguar XK recalls

4 safety recall campaigns have been filed for the 2010 Jaguar XK with Transport Canada and the U.S. NHTSA. Here is what both agencies say.

Canadian recalls
02
U.S. recalls
02
Total campaigns
04

Transport Canada recalls

02
  • Steering#2011115

    400 units affected

    On certain vehicles, the Power Assisted Steering (PAS) pipes may have been manufactured using a zinc-nickel plating that does not meet the corrosion protection requirements of Jaguar's engineering specification. Over time, the PAS pipes may corrode, which could allow power steering fluid leakage. Loss of PAS fluid could cause a loss of steering power assist, which may result in a crash causing property damage and/or personal injury. Also, power steering fluid leakage may contact a hot engine or exhaust component, which could result in a fire. Correction: Dealers will replaced the PAS pipes.

  • Fuel System#2010237

    351 units affected

    On certain vehicles equipped with a 5.0L engine, the in-tank electric fuel pump may not be correctly activated following a vehicle start-up cycle. The engine may start and continue to operate as normal until the engine fuel demand exceeds the ability for the pump to supply sufficient fuel. The engine can then cut out without warning. Loss of propulsion, in conjunction with traffic and road conditions, and the driver's reactions, could increase the risk of a crash causing property damage and/or personal injury. Correction: Dealers will reprogram the Engine Control Module.

Canadian data updated August 24, 2026

U.S. NHTSA recalls

02
  • STEERING:HYDRAULIC POWER ASSIST:HOSE, PIPING, AND CONNECTIONS#11V168000

    JAGUAR IS RECALLING CERTAIN MODEL YEAR 2010 XK AND XF VEHICLES MANUFACTURED FROM JUNE 27, 2009, THROUGH MARCH 10, 2010. THE POWER ASSIST STEERING (PAS) PIPES HAVE BEEN SUPPLIED WITH ZINC-NICKEL PLATING THAT DOES NOT MEET FULLY THE CORROSION PROTECTION REQUIREMENTS OF JAGUAR'S ENGINEERING SPECIFICATION. AFTER AN EXTENDED PERIOD OF TIME IN SERVICE, CORROSION OF THE PAS PIPES WILL OCCUR THAT MAY LEAD TO PIN-HOLING OF THE PIPE.

    Risk: PIN-HOLING OF THE PAS PIPES COULD ALLOW PRESSURIZED POWER STEERING FLUID TO LEAK INTO THE UNDER-HOOD AND ENGINE BAY AREA. A LOSS OF POWER STEERING FLUID WILL RESULT IN A LOSS OF POWER ASSIST STEERING. ALSO, THAT FLUID MAY IGNITE IF IT COMES INTO CONTACT WITH AN IGNITION SOURCE OR A SURFACE AT SUFFICIENTLY HIGH ENOUGH TEMPERATURE, CAUSING A VEHICLE FIRE.

    Remedy: DEALERS WILL REPLACE THE POWER STEERING FLUID PIPES WITH PARTS MANUFACTURED TO THE REQUIRED CORROSION PROTECTION SPECIFICATION. THIS SERVICE WILL BE PERFORMED FREE OF CHARGED. THE SAFETY RECALL IS EXPECTED TO BEGIN ON OR BEFORE JUNE 6, 2011. OWNERS MAY CONTACT JAGUAR AT 1-800-452-4827.

  • ENGINE AND ENGINE COOLING#10V332000

    JAGUAR IS RECALLING CERTAIN MODEL YEAR 2010-2011 JAGUAR XK AND MODEL YEAR 2010 XF V8 5.OL GASOLINE ENGINE VEHICLES. THE IN-TANK ELECTRIC FUEL PUMP MAY NOT BE CORRECTLY ACTIVATED AS THE FUEL PUMP RELAY IS NOT ENERGIZED FOLLOWING A VEHICLE START UP CYCLE. AN INADEQUATE SUPPLY OF FUEL TO THE ENGINE COULD RESULT.

    Risk: FUEL STARVATION TO THE ENGINE LEADS TO ENGINE STUMBLE FOLLOWED BY ENGINE CUT OUT WITH MINIMAL WARNING AND COULD POTENTIALLY CAUSE A CRASH.

    Remedy: DEALERS WILL DOWNLOAD REVISED SOFTWARE FREE OF CHARGE. THE SAFETY RECALL IS EXPECTED TO BEGIN ON OR BEFORE AUGUST 30, 2010. OWNERS MAY CONTACT JAGUAR AT 1-800-452-4827.

Does this recall apply to my vehicle?

Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.

What to do

Recall repairs are free at a franchised dealer in both countries. To confirm a recall applies to your specific vehicle, or to book the work, contact your manufacturer or dealer with your full VIN, or use the official channel:

Check a 2010 Jaguar XK VIN

A VIN decode confirms your vehicle's exact model year, trim and assembly plant, then runs this same recall check against it.

Data sources and coverage limits