RECALLS — MAKE · MODEL · YEAR
2011 Itasca Navion recalls
4 safety recall campaigns have been filed for the 2011 Itasca Navion with Transport Canada and the U.S. NHTSA. Here is what both agencies say.
- Canadian recalls
- 02
- U.S. recalls
- 02
- Total campaigns
- 04
Transport Canada recalls
02- Electrical#2012402
166 units affected
On certain motorhomes, incorrect fuses were installed in the refrigerator 12V circuits. A 5-amp fuse was installed in the lamp/fan circuit instead of a 3-amp fuse, and a 20-amp fuse was installed in the heating element circuit instead of a 15-amp fuse. These oversized fuses fail to provide proper circuit protection, which could result in a fire causing property damage and/or personal injury. Correction: Dealers will replace the affected fuses.
- Seats And Restraints#2010332
245 units affected
On certain motorhomes, the dinette area seatbelts may not conform to Canada Motor Vehicle Safety Standard 210 - Seatbelt Assembly Anchorages. Two seatbelt assemblies were placed side by side using three anchorage bolts rather than four bolts. During a crash, stress can cause the attachment to tear and allow the anchor to separate from the body of the vehicle. Failure of the seatbelt anchorage to restrain the occupant as intended would increase the risk of personal injuries during a crash. Correction: Dealers will install additional seatbelt anchorage bolts.
Canadian data updated August 24, 2026
U.S. NHTSA recalls
02- ELECTRICAL SYSTEM:WIRING:FUSES AND CIRCUIT BREAKERS#12V559000
Winnebago is recalling certain model year 2009-2013 model Era motorhomes, 2010-2013 Via and Itasca Reyo motorhomes, and 2011-2013 View and Itasca Navion motorhomes; manufactured November 13, 2007, through August 20, 2012. The proper fuses were not installed for the refrigerator circuits.
Risk: Without the proper fuse, heat can build which could lead to a vehicle fire.
Remedy: Winnebago will notify owners, and dealers will replace the fuses. The recall began on December 21, 2012. Consumers may contact Winnebago Industries owner relations at 1-641-585-6939.
- SEAT BELTS#10V470000
WINNEBAGO IS RECALLING CERTAIN MODEL YEAR 2006 THROUGH 2011 WINNEBAGO VIEW AND ITASCA NAVION MOTOR HOMES BECAUSE THE DINETTE AREA SEAT BELT RESTRAINTS ON THOSE VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 210, "SEAT BELT ASSEMBLY ANCHORAGES." IN A COLLISION, THE GENERATED CRASH FORCES CAN CAUSE THE RESTRAINT'S ATTACHMENT TO TEAR AND ALLOW THE ANCHOR TO SEPARATE FROM THE BODY OF THE VEHICLE.
Risk: IF THE RESTRAINT SEPARATES FROM THE VEHICLE DURING A CRASH, THE BELT WILL NOT PROPERLY RESTRAIN THE SEAT OCCUPANT, INCREASING THE RISK OF INJURY OR DEATH TO THE OCCUPANT.
Remedy: WINNEBAGO WILL ADD ADDITIONAL SEAT BELT ANCHORAGES FREE OF CHARGE. THE SAFETY RECALL BEGAN ON NOVEMBER 12, 2010. OWNERS MAY CONTACT WINNEBAGO AT 1-800-537-1885.
Does this recall apply to my vehicle?
Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.
What to do
Recall repairs are free at a franchised dealer in both countries. To confirm a recall applies to your specific vehicle, or to book the work, contact your manufacturer or dealer with your full VIN, or use the official channel:
- NHTSA recall lookup (search by VIN) — U.S. National Highway Traffic Safety Administration
- Defects and recalls database — Transport Canada
Check a 2011 Itasca Navion VIN
A VIN decode confirms your vehicle's exact model year, trim and assembly plant, then runs this same recall check against it.