Skip to content
VINscan

RECALLS — MAKE · MODEL · YEAR

2012 Isuzu NPR-HD recalls

4 safety recall campaigns have been filed for the 2012 Isuzu NPR-HD with Transport Canada and the U.S. NHTSA. Here is what both agencies say.

Canadian recalls
04
U.S. recalls
00
Total campaigns
04

Transport Canada recalls

04
  • Powertrain#2017265

    380 units affected

    On certain vehicles with gasoline powered engines, the accelerator pedal could move laterally, allowing the accelerator pedal bracket to be hung up on the stopper bolt on the floor panel bracket. This would cause the accelerator pedal to remain in the open position, increasing the risk of a crash causing injury and/or damage to property. Correction: Dealers will remove and replace the stopper bolt with a flanged plate that will be bolted to the floor bracket to prevent lateral movement of the accelerator pedal. Note: This recall is an expansion of recall 2016-545.

  • Suspension#2017173

    4,539 units affected

    On certain vehicles, the left rear wheel bearing hub locking bolts may not have been properly torqued during assembly. This could cause the bolts to loosen and break, which could allow the wheel assembly to move outwards from the axle housing. If this occurs, the vehicle could become more difficult to control and braking distances would increase which could result in a crash causing injury and/or damage to property. Correction: Dealers will inspect and tighten the rear left wheel bearing hub locking bolts as necessary.

  • Electrical#2013212

    743 units affected

    On certain vehicles equipped with an oil pan heater, over time, dust, dirt and moisture may collect at the contact point between the oil pan heater cord and the extension cord. As a result, the extension cord could overheat, which may melt the oil pan heater plug and/or block heater plug (if equipped). This could result in a fire causing property damage and/or personal injury. Correction: Dealers will inspect and clean the oil pan heater plug and the engine block heater plug (if equipped). Heat damaged plugs will be replaced. In addition, dealers will replace the extension cord and advise owners to store the cord indoors when not in use.

  • Electrical#2011321

    2 units affected

    On certain vehicles, the Electronic Control Module (ECM) software may not detect a brake pedal switch failure. If the brake pedal switch malfunctions, application of the brake pedal would fail to deactivate the cruise control. The driver would, however, be able to disengage the cruise control by other means such as; pressing the cruise control main switch located on the instrument panel, shifting the transmission into neutral or another gear, lowering the speed of the vehicle by more than 48 km/h (30 mph) through braking and/or shifting gears, or by turning the engine OFF. Failure or delay in disengaging the cruise control can increase the risk of a crash causing property damage and/or personal injury. Correction: Dealers will update the ECM software.

Canadian data updated August 24, 2026

U.S. NHTSA recalls

00

No recalls found for this make, model, and year.

Does this recall apply to my vehicle?

Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.

What to do

Recall repairs are free at a franchised dealer in both countries. To confirm a recall applies to your specific vehicle, or to book the work, contact your manufacturer or dealer with your full VIN, or use the official channel:

Check a 2012 Isuzu NPR-HD VIN

A VIN decode confirms your vehicle's exact model year, trim and assembly plant, then runs this same recall check against it.

Data sources and coverage limits