Does the 2016 International Workstar have any recalls?

Transport Canada lists 4 campaigns and the U.S. NHTSA lists 4 for the 2016 International Workstar. Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.

How do I know if a recall applies to my 2016 International Workstar?

Recalls are matched by make, model and model year, but many cover only certain VIN ranges. Confirm with your manufacturer or dealer using your full VIN, or use the official Transport Canada or NHTSA lookup.

Are recall repairs free?

Yes. In both Canada and the United States the manufacturer must fix a recalled defect at no charge, through a franchised dealer.

RECALLS — MAKE · MODEL · YEAR

2016 International Workstar recalls

8 safety recall campaigns have been filed for the 2016 International Workstar with Transport Canada and the U.S. NHTSA. Here is what both agencies say.

Canadian recalls: 04
U.S. recalls: 04
Total campaigns: 08

Transport Canada recalls

Powertrain#2020643December 23, 2020
3,178 units affected
Issue: On certain trucks equipped with an automatic transmission, when the engine RPM increases for the stationary power take off (PTO), it can overcome the parking brake if the transmission is in drive or reverse gear. As a result, the truck may move suddenly. Safety Risk: Sudden and unexpected movement of the truck could increase the risk of a crash. Corrective Actions: The company will notify owners by mail and instruct you to take your truck to a dealer to update the engine control module software to enable the PTO neutral interlock.
Steering#2017456September 20, 2017
181 units affected
On certain vehicles, the castellated nut and cotter pin on the steer axle may not have been tightened to specification. This could cause the tie rod to become loose in the steer axle, which would result in audible noise and/or looseness in steering. If the vehicle were continued to be operated in this condition, the tie rod could disconnect from the knuckle, resulting in a complete loss of control of a vehicle wheel, which would increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will inspect the torque of the castellated nuts on the tie rod, and replace the tie rod stud and knuckle as necessary.
Lights And Instruments#2016367July 19, 2016
206 units affected
Certain vehicles may not comply with the requirements of Canada Motor Vehicle Safety Standard (CMVSS) 108 - Lighting System and Retroreflective Devices. For vehicles built with the snow plow option, the necessary body controller programming for the snow plow’s Day Time Running Lights (DRLs) may not have been installed during assembly. This could cause the snow plow DRLs to not illuminate when the headlight switch is off, which is contrary to the requirements of the standard. This could reduce vehicle conspicuity during daylight hours, which could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will recalibrate the body control module.
Brakes#2015120March 18, 2015
493 units affected
On certain vehicles, brake chamber diaphragm(s) may not be properly seated. This could lead to brake drag, causing brake overheating or unintended spring brake application. These issues could increase the risk of a crash causing injury and/or property damage. Correction: Dealers will replace the brake chambers. Note: This is an expansion of recall 2014-573.

Canadian data updated August 24, 2026

U.S. NHTSA recalls

ENGINE AND ENGINE COOLING:ENGINE:ENGINE CONTROL MODULE (ECU/ECM):SOFTWARE#20V810000December 23, 2020
Navistar, Inc. (Navistar) is recalling certain 2019-2021 International MV, 2020-2021 International HV, 2014-2020 International DuraStar and 2015-2018 International WorkStar vehicles. When the parking brake is applied and the automatic transmission is still in the drive or reverse position and the stationary PTO switch is engaged by the operator, the engine may rev and overcome the parking brake's ability to keep the vehicle from moving.
Risk: Unexpected Vehicle movement can increase the risk of a crash or injury.
Remedy: Navistar will notify owners, and dealers will update the parameters in the Cummins ECM for feature codes 12VXT or 12VXU that enables the PTO neutral interlock, free of charge. The recall began February 17, 2021. Owners may contact Navistar customer service at 1-800-448-7825. Navistar's number for this recall is 20510.
STEERING:LINKAGES:TIE ROD ASSEMBLY#17V575000September 20, 2017
Navistar, Inc. (Navistar) is recalling certain 2016 International DuraStar, LoneStar, ProStar, TerraStar, TranStar, WorkStar, 9900i, and IC Bus HC vehicles equipped with certain Spicer D or E series steer axles. The castellated nut on the steer axles may not be properly torqued, allowing the tie rod to loosen.
Risk: If the tie rod loosens, it may disconnect from the steering knuckle, causing a complete loss of steering, increasing the risk of a crash.
Remedy: Navistar will notify owners, and dealers will inspect the torque of the castellated nut and tie rod, tightening it as necessary, free of charge. The recall began on November 8, 2017. Owners may contact Navistar customer service at 1-331-332-1590. Navistar's number for this recall is 17507.
POWER TRAIN:AXLE ASSEMBLY#15V254000April 29, 2015
Navistar, Inc. (Navistar) is recalling certain model year 2016 International PayStar trucks manufactured January 19, 2015, to January 20, 2015, and 2016 International WorkStar trucks manufactured on January 19, 2015. The affected vehicles are equipped with Meritor MT-40-14X rear drive axles that may circulate an inadequate amount of lubricant to the wheel end hub assembly.
Risk: Without adequate lubrication to the wheel end hub assembly, the bearings may fail prematurely, increasing the risk of a crash.
Remedy: Navistar has already repaired the affected vehicles, free of charge. The recall was completed in April 2015. Owners may contact Navistar customer service at 1-800-448-7825.
SERVICE BRAKES, AIR#15V165000March 23, 2015
Navistar, Inc. (Navistar) is recalling certain model year 2015-2016 International 9900, DuraStar, LoneStar, PayStar, ProStar, WorkStar and 2015 International TranStar and IC Bus CE vehicles equipped with a Haldex air braking system. The affected brake actuators may have been manufactured with an incomplete attachment of the internal rubber diaphragm to the actuation mechanism. This could cause dragging or overheated brakes.
Risk: If the brakes drag and overheat there is an increased risk of a wheel end fire.
Remedy: Navistar will notify owners, and dealers will replace the Haldex Life Seal Brake chambers, free of charge. The recall began on June 19, 2015. Owners may contact Navistar customer service at 1-800-448-7825. Navistar's number for this recall is 15504. Note: This recall supersedes recall 14V-806.

Does this recall apply to my vehicle?

Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.

What to do

Recall repairs are free at a franchised dealer in both countries. To confirm a recall applies to your specific vehicle, or to book the work, contact your manufacturer or dealer with your full VIN, or use the official channel:

NHTSA recall lookup (search by VIN) — U.S. National Highway Traffic Safety Administration
Defects and recalls database — Transport Canada

Check a 2016 International Workstar VIN

A VIN decode confirms your vehicle's exact model year, trim and assembly plant, then runs this same recall check against it.

Data sources and coverage limits →