RECALLS — MAKE · MODEL · YEAR
2018 International Transtar recalls
4 safety recall campaigns have been filed for the 2018 International Transtar with Transport Canada and the U.S. NHTSA. Here is what both agencies say.
- Canadian recalls
- 02
- U.S. recalls
- 02
- Total campaigns
- 04
Transport Canada recalls
02- Powertrain#2018638
2,856 units affected
On certain vehicles equipped with an electronic clutch actuator (ECA), the clutch may have been manufactured improperly and could fail. If this occurs, the broken clutch components could prevent the transmission from disengaging or shifting to neutral. This could result in unintended vehicle movement, even if the parking brake is applied, increasing the risk of a crash causing injury and/or damage to property. Correction: Dealers will recalibrate the Transmission Control Module (TCM).
- Seats And Restraints#2018232
2,093 units affected
On certain vehicles, the seat belt D-ring mounting bolts may break due to a material defect. If this occurs, the seat belt may not properly restrain the seat occupant in a crash, increasing the risk of injury. Correction: Dealers will inspect the driver and passenger D-ring mounting bolts and replace them as necessary.
Canadian data updated August 24, 2026
U.S. NHTSA recalls
02- POWER TRAIN:CLUTCH ASSEMBLY#18V826000
Navistar, Inc. (Navistar) is recalling certain 2019 International HV, MV, 2018-2019 HX, LT, RH, LoneStar, ProStar, WorkStar, and 2018 TranStar automated manual transmission vehicles, equipped with certain Eaton ECA heavy-duty truck clutches. An internal component in the clutch assembly may fail, possibly resulting in unintended vehicle movement.
Risk: Unintended vehicle movement can increase the risk of a crash.
Remedy: Navistar will notify owners, and dealers will recalibrate the Transmission Control Module (TCM), free of charge. The recall began January 18, 2019. Owners may contact Navistar customer service at 1-800-448-7825. Navistar's number for this recall is 18518.
- SEAT BELTS:FRONT:ANCHORAGE#18V293000
Navistar, Inc. (Navistar) is recalling certain 2018-2019 International WorkStar, DuraStar, LoneStar, LT, ProStar, RH and IC Bus HC, 2018 International TranStar, 2019 International HV and MV trucks and transit buses. The front driver and passenger seat belt anchor D-ring bolt may break in the event of a crash. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 210, "Seat Belt Assembly Anchorages."
Risk: If the D-ring bolt breaks during a crash, the seat occupant may not be properly restrained, increasing their risk of injury.
Remedy: Navistar has notified owners, and dealers will replace the D-ring bolt depending on the information found on the seat belt label, free of charge. The recall began May 23, 2018. Owners may contact Navistar customer service at 1-800-448-7825. Navistar's number for this recall is 18505.
Does this recall apply to my vehicle?
Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.
What to do
Recall repairs are free at a franchised dealer in both countries. To confirm a recall applies to your specific vehicle, or to book the work, contact your manufacturer or dealer with your full VIN, or use the official channel:
- NHTSA recall lookup (search by VIN) — U.S. National Highway Traffic Safety Administration
- Defects and recalls database — Transport Canada
Check a 2018 International Transtar VIN
A VIN decode confirms your vehicle's exact model year, trim and assembly plant, then runs this same recall check against it.