Does the 2014 Infiniti Q70 Hybrid have any recalls?

Transport Canada lists 3 campaigns and the U.S. NHTSA lists 5 for the 2014 Infiniti Q70 Hybrid. Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.

How do I know if a recall applies to my 2014 Infiniti Q70 Hybrid?

Recalls are matched by make, model and model year, but many cover only certain VIN ranges. Confirm with your manufacturer or dealer using your full VIN, or use the official Transport Canada or NHTSA lookup.

Are recall repairs free?

Yes. In both Canada and the United States the manufacturer must fix a recalled defect at no charge, through a franchised dealer.

RECALLS — MAKE · MODEL · YEAR

2014 Infiniti Q70 Hybrid recalls

8 safety recall campaigns have been filed for the 2014 Infiniti Q70 Hybrid with Transport Canada and the U.S. NHTSA. Here is what both agencies say.

Canadian recalls: 03
U.S. recalls: 05
Total campaigns: 08

Transport Canada recalls

Powertrain#2024362June 21, 2024
137 units affected
Issue: On certain vehicles, the driveshaft may not have been manufactured properly. As a result, the driveshaft could break and cause a loss of power to the wheels. Additionally, if the vehicle is parked and the parking brake isn't applied, the vehicle could roll away. Note: This recall only affects two-wheel-drive (2WD) models. Safety Risk: A loss of power to the wheels could increase the risk of a crash. A parked vehicle that rolls away could also create the risk of an injury or a crash. Corrective Actions: Nissan will notify owners by mail and advise you to take your vehicle to a dealership to replace the driveshaft.
Fuel System#2014539November 28, 2014
10,434 units affected
On certain vehicles, the fuel pressure sensor connected to the engine fuel delivery rail may not have been sufficiently tightened during vehicle assembly. Should the pressure sensor loosen, fuel could leak past a gasket used in the connection between the sensor and the rail. Fuel leakage, in the presence of an ignition source, could result in a fire causing property damage and/or personal injury. Correction: Dealers will inspect the pressure sensor and tighten to specification. Note: This is an expansion of recall 2012-074. Vehicles that were repaired under the previous campaign are not affected because that remedy would have corrected the subject condition.
Powertrain#2014415September 23, 2014
511 units affected
On certain hybrid vehicles, a defect in engine control module programming could cause a gradual throttle increase without driver input, which could cause vehicle speed to increase. This could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will update vehicle software. Note: Applying the brake would allow the vehicle to be slowed or stopped.

Canadian data updated August 24, 2026

U.S. NHTSA recalls

POWER TRAIN:DRIVELINE:DRIVESHAFT#24V470000June 21, 2024
Nissan North America, Inc. (INFINITI) is recalling certain 2011-2013 M56, 2012-2013 M35 Hybrid, 2014-2018 Q50, Q70 Hybrid, 2014-2019 Q70, and 2015-2019 Q70L two-wheel drive vehicles. The driveshaft can fatigue and break.
Risk: A broken driveshaft can result in a loss of drive power, or a vehicle roll away when the vehicle is in park without the parking brake applied. Both scenarios can increase the risk of a crash.
Remedy: Dealers will replace the driveshaft, free of charge. Owner notification letters were mailed August 13, 2024. Owners may contact INFINITI's customer service at 1-800-662-6200. INFINITI's numbers for this recall are R24A5 and R24A7.
POWER TRAIN:DRIVELINE:DRIVESHAFT#20V755000December 7, 2020
Nissan North America, Inc. (Nissan) is recalling certain 2011-2013 Infiniti M56, 2012-2013 M35 Hybrid, and 2014 Q70 and Q70 Hybrid vehicles. These models, equipped with 2WD and with a hybrid or VK56 powertrain, have a driveshaft that may break.
Risk: A broken driveshaft can cause a loss of propulsion, increasing the risk of a crash, or may disable the parking brake, increasing the risk of a rollaway and injury.
Remedy: Infiniti will notify owners, and dealers will replace the driveshaft, free of charge. The recall began February 5, 2021. Owners may contact Infiniti customer service at 1-800-662-6200.
ENGINE AND ENGINE COOLING:ENGINE#14V583000September 22, 2014
Nissan North America, Inc. (Nissan) is recalling certain model year 2013-2014 Infiniti M35 hybrid vehicles manufactured April 7, 2012, to September 9, 2013, 2014 Infiniti Q50 hybrid vehicles manufactured December 10, 2012, to July 15, 2014, and 2014-2015 Infiniti Q70 hybrid vehicles manufactured April 9, 2010, to May 7, 2014. Due to a software error, In the affected vehicles, if the signal is lost from one of the two throttle position sensors (TPS), the engine control module (ECM) will go into a fail-safe mode, partially closing the throttle chamber. Should the lost signal be restored, the throttle chamber may open, regardless of the position signal from the TPS.
Risk: The vehicle may gradually accelerate due to the throttle chamber reopening. This unexpected acceleration may increase the risk of a crash.
Remedy: Nissan will notify owners, and dealers will reprogram the ECM, free of charge. The recall began on November 10, 2014. Owners may contact Nissan customer service at 1-800-647-7261.
POWER TRAIN:AUTOMATIC TRANSMISSION#14V582000September 22, 2014
Nissan North America, Inc. (Nissan) is recalling certain model year 2014 Infiniti Q50 hybrid vehicles manufactured October 16, 2013, to January 27, 2014, and Infiniti Q70 hybrid vehicles manufactured November 7, 2013, to December 10, 2013. The affected vehicles may have been assembled with transmissions whose housings were damaged during their manufacturing.
Risk: The damaged housings could crack and fracture, creating road debris and disabling the vehicle, increasing the risk of a crash.
Remedy: Nissan will notify owners, and dealers will inspect the transmission assembly and replace it if cracks are found, free of charge. The recall began on November 10, 2014. Owners may contact Nissan customer service at 1- 800-647-7261.
HYBRID PROPULSION SYSTEM#14V581000September 22, 2014
Nissan North America, Inc. (Nissan) is recalling certain model year 2014 Infiniti Q50 hybrid vehicles manufactured December 10, 2012, to June 25, 2014, and Infiniti Q70 hybrid vehicles manufactured November 7, 2013, to May 7, 2014. Due to a software error, the electric motor may stop working while the vehicle is being driven using the electric motor only.
Risk: The stall-like condition that occurs when the electric motor stops working may increase the risk of a crash.
Remedy: Nissan will notify owners, and dealers will reprogram the motor inverter software, free of charge. The recall began on November1, 2014. Owners may contact Nissan customer service at 1-800-647-7261.

Does this recall apply to my vehicle?

Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.

What to do

Recall repairs are free at a franchised dealer in both countries. To confirm a recall applies to your specific vehicle, or to book the work, contact your manufacturer or dealer with your full VIN, or use the official channel:

NHTSA recall lookup (search by VIN) — U.S. National Highway Traffic Safety Administration
Defects and recalls database — Transport Canada

Check a 2014 Infiniti Q70 Hybrid VIN

A VIN decode confirms your vehicle's exact model year, trim and assembly plant, then runs this same recall check against it.

Data sources and coverage limits →