2013 Hyundai Elantra recalls

• Brakes#2024080February 8, 2024

  353,849 units affected

  Issue: On certain vehicles, brake fluid could leak into the control module for the antilock brake system (ABS) and cause it to short circuit. Note: This recall replaces recall R0246 (Transport Canada recall number 2023-527). For the Sonata model, only the Sonata Hybrid model is affected by this recall. Safety Risk: A short circuit could create a fire risk, even while the vehicle is parked and turned off. Corrective Actions: Hyundai will notify owners by mail and advise you to take your vehicle to a dealership to replace the fuse for the ABS module. Hyundai recommends that you should park your vehicle outdoors and away from other vehicles or structures until the recall repairs have been completed.

• Brakes#2023527September 22, 2023

  326,942 units affected

  This recall was replaced by Transport Canada Recall No. 2024-080. Issue: On certain vehicles, brake fluid could leak into the control module for the antilock brake system (ABS) and cause it to short circuit. Safety Risk: A short circuit could create a fire risk, even while the vehicle is parked and turned off. Corrective Actions: Hyundai will notify owners by mail and advise you to take your vehicle to a dealership to replace the fuse for the ABS module. Hyundai recommends that you should park your vehicle outdoors and away from other vehicles or structures until the recall repairs have been completed.

• Brakes#2023125March 8, 2023

  404,543 units affected

  Issue: Hyundai is conducting a special service campaign that provides anti-corrosion treatment to certain underbody components. Over time, components under the vehicle, including brake lines could corrode. If this happens, a brake line could fail and leak. A brake fluid leak can result in reduced braking. Safety Risk: Reduced braking can cause an extended stopping distance and increase the risk of a crash. Corrective Actions: Hyundai will notify owners by mail and advise you to take your vehicle to a dealership to inspect the underbody, including the brake lines. The dealer will apply an anti-corrosion treatment to certain parts, and replace the brake lines if necessary.

• Other#2019420August 21, 2019

  5,327 units affected

  Issue: This recall is for aftermarket replacement rear window glass produced by Vitro Automotriz. Certain rear window glass may not have been properly tempered. If the window breaks, the glass may separate into large pieces instead of very small ones. Note: This is a voluntary recall that is not being conducted under the requirements of the Motor Vehicle Safety Act. Safety Risk: Glass that breaks in to large pieces could create a risk of injury. Corrective Actions: The company will notify consumers by mail and instruct them to inspect the designation code marked on the rear window glass. Products affected by this recall have the designation “DOT 287” along with the lettering “VMR” (Replacement Market) and a date code that is before July 2019. This information is printed on the bottom corner of the glass. Consumers should contact Vitro's customer service at 1-412-995-6457 or argbacklites@vitro.com to arrange for replacement of the glass.

• Brakes#2017614December 8, 2017

  103,556 units affected

  On certain vehicles, the brake pedal stopper pad material could deteriorate over time and allow the stop lamp switch plunger to remain extended when the brake pedal is released. This could result in the stop lamps illuminating continuously, which would result in following road users being unaware of the driver's intentions. Additionally, it could result in activation of the engine management system's brake pedal override feature, the illumination of the traction control warning lamp, and/or the ability to move the shift lever without depressing the brake pedal, which could result in unintended vehicle movement. These conditions could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will replace the brake pedal stopper pad.

Canadian data updated August 24, 2026

• SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP:CONTROL UNIT/MODULE#23V651000September 22, 2023

  Hyundai Motor America (Hyundai) is recalling certain 2011-2015 Elantra, Genesis Coupe, Sonata Hybrid, 2012-2015 Accent, Azera, Veloster, 2013-2015 Elantra Coupe, Santa Fe, 2014-2015 Equus, 2010-2012 Veracruz, 2010-2013 Tucson, 2015 Tucson Fuel Cell, and 2013 Santa Fe Sport vehicles. The Anti-Lock Brake System (ABS) module may leak brake fluid internally and cause an electrical short, which can result in an engine compartment fire while parked or driving.

  Risk: An engine compartment fire while parked or driving can increase the risk of injury.

  Remedy: Owners are advised to park outside and away from structures until the recall repair is complete. Dealers will replace the ABS fuse, free of charge. Owner notification letters were mailed April 10, 2024 through October 11, 2024. Owners may contact Hyundai customer service at 1-855-371-9460. Hyundai's number for this recall is 251.

• SERVICE BRAKES, HYDRAULIC:PEDALS AND LINKAGES#17V769000November 30, 2017

  Hyundai Motor Company (Hyundai) is recalling certain 2013-2014 Elantra sedan, coupe and GT vehicles. The brake pedal stopper pad can deteriorate allowing the brake light switch plunger to remain extended when the brake pedal is released. This will allow the brake lights to remain illuminated continuously. It can also allow the shift lever to be moved without depressing the brake pedal, or activate the engine management brake pedal override feature.

  Risk: If the brake light switch plunger does not retract as it should when the brake pedal is not being pressed, the brake lights may stay illuminated preventing accurate communication to following vehicles that the vehicle is slowing or stopping. Additionally, if the brake switch plunger is not retracted, then the transmission can be shifted out of PARK without depressing the brake pedal. Either condition increases the risk of a crash.

  Remedy: Hyundai will notify owners, and dealers will replace the brake pedal stopper pad, free of charge. The recall is expected to begin February 8, 2018. Owners may contact Hyundai customer service at 1-800-633-5151. Hyundai's number for this recall is 170. This campaign expands recall 16V574.

• EXTERIOR LIGHTING:BRAKE LIGHTS:SWITCH#16V574000August 2, 2016

  Hyundai Motor America (Hyundai) is recalling certain model 2013 Elantra vehicles manufactured December 1, 2012, to April 30, 2013. The brake pedal stopper pad can deteriorate allowing the brake light switch plunger to remain extended when the brake pedal is released.

  Risk: If the brake light switch plunger does not retract as it should when the brake pedal is not being pressed, the brake lights may stay illuminated preventing accurate communication to following vehicles that the vehicle is slowing or stopping. Additionally, if the brake switch plunger is not retracted, then the transmission can be shifted out of PARK without depressing the brake pedal. Either condition increases the risk of a crash.

  Remedy: Hyundai will notify owners, and dealers will replace the brake pedal stopper pad with an improved part, free of charge. The recall is expected to begin on September 30, 2016. Owners may contact Hyundai customer service at 1-855-371-9460. Hyundai's number for this recall is 146.

• AIR BAGS:SIDE/WINDOW#13V115000April 1, 2013

  Hyundai Motor Company is recalling certain model year 2011-2013 Elantra vehicles manufactured from November 12, 2010, through March 5, 2013. A support bracket attached to the headliner may become displaced during a side curtain airbag deployment.

  Risk: If the headliner support bracket makes contact with an occupant during a crash, it may cause a laceration injury.

  Remedy: Hyundai will notify owners, and dealers will apply adhesive strips to the headliner, free of charge. The safety recall began during April 2013. Owners may contact Hyundai at 1-800-633-5151. Hyundai's recall campaign number is 109.