Skip to content
VINscan

RECALLS — MAKE · MODEL · YEAR

2013 Hino XJC700 recalls

2 safety recall campaigns have been filed for the 2013 Hino XJC700 with Transport Canada and the U.S. NHTSA. Here is what both agencies say.

Canadian recalls
02
U.S. recalls
00
Total campaigns
02

Transport Canada recalls

02
  • Brakes#2014494

    3,316 units affected

    On certain vehicles, the software of the ABS control unit (ECU) is incomplete. The software required to initiate the illumination of the red "BRAKE" warning lamp during the check of lamp function, when the ignition switch is turned to the "ON" position, when the engine is not running, is not included. This could result in the driver not being aware that the lamp is inoperative, and the light not illuminating to notify the driver when the brake fluid pressure or fluid level is too low, which could increase the risk of a crash. Correction: Dealers will reprogram the ABS control unit.

  • Steering#2013464

    403 units affected

    On certain vehicles, the steering wheel fastener nut may have been insufficiently tightened during vehicle assembly. This could allow the steering wheel to become loose and slip in relation to the steering column shaft, increasing the risk of a crash causing injury and/or property damage. Correction: Dealers will re-torque the steering wheel nut.

Canadian data updated August 24, 2026

U.S. NHTSA recalls

00

No recalls found for this make, model, and year.

Does this recall apply to my vehicle?

Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.

What to do

Recall repairs are free at a franchised dealer in both countries. To confirm a recall applies to your specific vehicle, or to book the work, contact your manufacturer or dealer with your full VIN, or use the official channel:

Check a 2013 Hino XJC700 VIN

A VIN decode confirms your vehicle's exact model year, trim and assembly plant, then runs this same recall check against it.

Data sources and coverage limits