2012 Freightliner Business Class M2 106 recalls

• Tires#2021706November 17, 2021

  948 units affected

  Issue: Certain trucks were built with tires that are not approved for use with the truck's wheels. As a result, the tires may not perform properly, or a tire could fail. Safety Risk: A tire failure could cause a loss of control and increase the risk of a crash. Corrective Actions: Daimler Trucks North America (DTNA) will notify owners by mail. The corrective actions for this recall are under development. You will be instructed to bring your truck to a DTNA authorized service facility when a repair is available.

• Lights And Instruments#2020158April 14, 2020

  873 units affected

  Issue: On certain trucks equipped with "Fleet Engineer" mud flaps, the bracket for the mud flaps may partially cover the rear reflective tape. Canadian regulations require that reflective tape must be visible on the rear of the truck. Safety Risk: Reflective tape that is covered may make the truck less visible to others and could create an increased risk of a crash. Corrective Actions: Daimler Trucks of North America (DTNA) will notify owners by mail and instruct you to take your truck to an authorized DTNA Service Facility to inspect the reflective tape. It will be moved as necessary to meet the regulations.

• Lights And Instruments#2019336July 4, 2019

  1,280 units affected

  Issue: On certain trucks equipped with electronic stability control (ESC), the brake lights may turn on when the automatic traction control (ATC) activates. Canadian regulations do not allow brake lights to turn on when the automatic traction control activates. Safety Risk: Brake lights that turn on when a vehicle is not slowing could confuse other drivers. Corrective Actions: The company will notify owners by mail and instruct them to take their truck to a Daimler Trucks North America authorized service facility. The truck will either be reprogrammed or retrofitted so the brake lights do not turn on when the automatic traction control (ATC) activates.

• Brakes#2019237May 17, 2019

  110 units affected

  Issue: Certain trucks were built with air reservoir tanks that are too small in relation to the size of the air brake chambers. Canadian regulations require enough air reservoir capacity to ensure the brakes work even with heavy use or when there is a partial loss of the air system. Safety Risk: Reduced braking could cause extended stopping distances and increase the risk of a crash. Corrective Actions: The company will notify owners by mail and instruct them to take their truck to a Daimler Trucks North America authorized service facility to modify the truck to ensure it meets Canadian regulations.

• Suspension#2018395July 30, 2018

  32 units affected

  On certain trucks, a combination of brake vibrations and corrosion could cause the tie-rod tube to fatigue and break. This may lead to a disconnect between the front wheels and reduce the ability to steer the vehicle, which could increase the risk of a crash causing injury and/or damage to property. Correction: Daimler Trucks of North America Service Facilities will replace brake linings, brake spiders and tie rods as necessary.

• Accessories#2017636December 18, 2017

  16,510 units affected

  On certain vehicles equipped with Kidde fire extinguishers with black plastic handles and valves, the fire extinguishers may become clogged or require excessive force to activate. Also, the nozzle may detach from the valve assembly with enough force that it could cause injury, and fail to discharge. In case of fire, failure of the extinguisher to function could result in injury and/or property damage. Correction: Owners will be provided with instructions on how to inspect the fire extinguisher to see if it is recalled. Replacement fire extinguishers will be supplied by Kidde directly. Note: For more information about recalled fire extinguishers, please visit <a href="https://inmarmarketaction.com/kidde/Kidde284CA/">www.kidde.com</a>.

• Brakes#2016176April 22, 2016

  22 units affected

  On certain vehicles, the rear disk brake calipers may contact the spring suspension due to incorrect caliper orientation. This could reduce rear brake effectiveness which would result in increased stopping distances, increasing the risk of a crash causing injury and/or damage to property. Correction: Dealers will correct the orientation of the rear calipers.

• Engine#2015336July 24, 2015

  172 units affected

  On certain vehicles equipped with Cummins Westport ISL-G engines, excessive engine crankcase pressure could cause the vent tube assembly molded rubber adapter to detach from the breather. This could allow engine oil to come in contact with hot surfaces, increasing the risk of fire resulting in injury and/or damage to property. Correction: Dealers will install clamps at both ends of the adapter of the breather tube assembly and reprogram the Electronic Control Module (ECM) to improve diagnostic capabilities.

• Accessories#2015276June 19, 2015

  8 units affected

  On certain mobile document shredder vehicles, installation of the shredding equipment combined with the increased weight of additional emissions components may have caused the vehicle weight to exceed the front gross axle weight rating (GAWR). This would result in vehicle being overloaded, potentially affecting vehicle handling characteristics, which could result in a crash causing injury and/or property damage. Correction: For vehicles built on the Freightliner M2 106 chassis, dealers will provide a new compliance label to reflect an increased GAWR (to 9000 lbs from 8000 lbs), and upgrade the front axle as necessary. For vehicles built on the Hino 258LP chassis, dealers will provide a new compliance label to reflect an increased GAWR (to 8500 lbs from 8000 lbs).

• Fuel System#2014547December 3, 2014

  3 units affected

  On certain trucks fuelled by compressed natural gas, the exhaust tailpipe may terminate under the fuel tank cabinet. Over time, the continued heating of the fuel tank by exhaust gases could increase the risk of a fire, causing injury and/or damage to property. Correction: Dealers will install an exhaust pipe extension to relocate the tailpipe.

• Engine#2014050February 21, 2014

  113 units affected

  On certain vehicles equipped with Cummins ISL G or ISX12 G engines, incorrect engine ECU programming could cause the exhaust system temperature to become elevated during cold weather operation. This could also cause flames to be emitted from the exhaust. As a result, nearby combustible material could be ignited, increasing the risk of a fire, injury and/or damage to property. Correction: Authorized Cummins service facilities will update software programming.

• Powertrain#2013448December 18, 2013

  5 units affected

  On certain trucks equipped with Eaton Hybrid transmissions, a software defect could result in unintended acceleration while downshifting. This could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will update transmission control software.

• Electrical#2013088March 20, 2013

  56 units affected

  On certain trucks, the customizable SmartPlex switch hub module may experience intermittent electrical shorts. As a range of equipment may have been connected to the switch hub module by final stage vehicle manufacturers; depending on vehicle configuration and intended use, these electrical shorts could have varied consequences. These may include the erratic operation of emergency, warning and/or work lights, the unexpected activation of a remote engine starter or the intermittent and/or uncontrolled operation of other body equipment. These or other malfunctions may result in an increased risk to road users, operators or bystanders. Correction: Dealers will inspect and, if necessary, replace the switch hub module.

• Brakes#2012281August 15, 2012

  147 units affected

  On certain trucks, the air tank mounting brackets may crack, which could allow the tank to detach from the vehicle. An air tank separating from the vehicle could strike another vehicle, a stationary object, or a bystander. As well, loss of an air tank would cause a loss of service brakes, which could increase stopping distances, possibly causing a crash. These issues could result in property damage and/or personal injury. Correction: Dealers will replace the air tank mounting brackets.

• Brakes#2012139April 23, 2012

  179 units affected

  On certain trucks, the quick release valve (QRV) cover may not have been welded correctly during manufacturing process and may become loose or separate from the valve body. If this occurs, air pressure may not be supplied to the front brakes during brake application. The rear brakes will continue to function. Reduction in braking efficiency could increase stopping distances, possibly resulting in a crash causing property damage and/or personal injury. Correction: Daimler authorized repair facilities will inspect and if necessary replace the quick release valve.

• Steering#2012119March 30, 2012

  256 units affected

  On certain vehicles, an incorrect steering wheel fastener may have been installed during vehicle assembly. The incorrect nut may not provide the clamp load required to fully seat the steering wheel onto the steering shaft. This could allow the steering wheel to wobble, which could hamper vehicle operation. If the problem is ignored, the nut could loosen completely, which could allow the steering wheel to detach from the steering shaft. These issues could result in a crash causing property damage and/or personal injury. Correction: Dealers will replace the steering wheel nut.

• Fuel System#2012080February 27, 2012

  11,923 units affected

  On certain trucks equipped with a Detroit Diesel DD13, DD15 or DD16 engine, the support system for the high pressure fuel line (between the fuel pump and the fuel delivery rail) may be damaged during a service repair procedure. Incorrect torque applied to the dampener "P" clip fasteners may damage the fasteners, which could allow the clips to loosen. This could result in a cracked fuel line and a diesel fuel leak. Diesel fuel leakage may ignite on a hot engine surface and cause a fire. As well, diesel fuel spilt on the roadway could endanger other road users by making the roadway unexpectedly slippery. These issues could result in property damage and/or personal injury. Correction: Dealers will replace the high pressure fuel line and install a more robust fuel line support system.

• Engine#2011439December 22, 2011

  50 units affected

  On certain emergency vehicles, the engine shutdown system (normally provided to protect the engine in case of malfunction) may not have been disabled during vehicle assembly. Unexpected emergency vehicle engine shutdown, under certain conditions, could hamper rescue operations and place the public at risk. Correction: Authorized service facilities will disable the engine shutdown system.

• Other#2011346September 19, 2011

  1,027 units affected

  On certain vehicles, specific operating conditions (such as tight, successive, highly banked curves in opposite directions), could trigger unintended Electronic Stability Control (ESC) system intervention. As a result, the ESC may unnecessarily apply one of the front brakes in order to correct the perceived oversteer condition. This may cause the vehicle to deviate from the intended path, thereby increasing the risk of a crash causing property damage and/or personal injury. Correction: Dealers will replace the ESC module.

• Engine#2011337September 13, 2011

  580 units affected

  On certain vehicles equipped with a Cummins engine, the V-band clamps used to connect the inlet and outlet cone sections to the Diesel Oxidation Catalyst (DOC) / Diesel Particulate Filter (DPF) include a T-bolt which can fracture and fail when subjected to stress or load. A fracture or failure of the T-bolt may cause the clamp to loosen and the inlet or outlet sections attached to the DOC/DPF housing to disconnect. Should this occur, hot exhaust gases can vent prior to exiting the tailpipe, creating a risk of combustion or damage to adjacent materials, which could result in a vehicle fire. If both clamps fail, the DOC/DPF housing could detach completely, separate from the vehicle, and strike another vehicle, stationary object, or bystander. These issues could result in property damage and/or personal injury. Correction: Cummins will install updated V-band clamps.

• Powertrain#2011172April 27, 2011

  81 units affected

  On certain trucks, the driveshaft may not have been welded correctly during the manufacturing process. This could allow the driveshaft to fracture along the length of the tube seam weld when torque is applied. The fractured tube can twist or sever, which could result in additional damage to the driveline, the vehicle to which it is attached, and any additional nearby components. Should the brake air lines become damaged, it could allow spring brake application, causing immediate brake lock-up. If this occurs while the vehicle is in motion, it could result in a crash. Also, failure of the driveshaft would result in lost vehicle propulsion which, in conjunction with traffic and road conditions, and the driver's reactions, could increase the risk of a crash. Either condition could result in property damage and/or personal injury. Correction: Dealers will replace the driveshaft assembly.

Canadian data updated August 24, 2026

No recalls found for this make, model, and year.