2013 Freightliner 114SD recalls

• Tires#2021706November 17, 2021

  948 units affected

  Issue: Certain trucks were built with tires that are not approved for use with the truck's wheels. As a result, the tires may not perform properly, or a tire could fail. Safety Risk: A tire failure could cause a loss of control and increase the risk of a crash. Corrective Actions: Daimler Trucks North America (DTNA) will notify owners by mail. The corrective actions for this recall are under development. You will be instructed to bring your truck to a DTNA authorized service facility when a repair is available.

• Lights And Instruments#2019336July 4, 2019

  1,280 units affected

  Issue: On certain trucks equipped with electronic stability control (ESC), the brake lights may turn on when the automatic traction control (ATC) activates. Canadian regulations do not allow brake lights to turn on when the automatic traction control activates. Safety Risk: Brake lights that turn on when a vehicle is not slowing could confuse other drivers. Corrective Actions: The company will notify owners by mail and instruct them to take their truck to a Daimler Trucks North America authorized service facility. The truck will either be reprogrammed or retrofitted so the brake lights do not turn on when the automatic traction control (ATC) activates.

• Brakes#2019237May 17, 2019

  110 units affected

  Issue: Certain trucks were built with air reservoir tanks that are too small in relation to the size of the air brake chambers. Canadian regulations require enough air reservoir capacity to ensure the brakes work even with heavy use or when there is a partial loss of the air system. Safety Risk: Reduced braking could cause extended stopping distances and increase the risk of a crash. Corrective Actions: The company will notify owners by mail and instruct them to take their truck to a Daimler Trucks North America authorized service facility to modify the truck to ensure it meets Canadian regulations.

• Engine#2015336July 24, 2015

  172 units affected

  On certain vehicles equipped with Cummins Westport ISL-G engines, excessive engine crankcase pressure could cause the vent tube assembly molded rubber adapter to detach from the breather. This could allow engine oil to come in contact with hot surfaces, increasing the risk of fire resulting in injury and/or damage to property. Correction: Dealers will install clamps at both ends of the adapter of the breather tube assembly and reprogram the Electronic Control Module (ECM) to improve diagnostic capabilities.

• Engine#2014050February 21, 2014

  113 units affected

  On certain vehicles equipped with Cummins ISL G or ISX12 G engines, incorrect engine ECU programming could cause the exhaust system temperature to become elevated during cold weather operation. This could also cause flames to be emitted from the exhaust. As a result, nearby combustible material could be ignited, increasing the risk of a fire, injury and/or damage to property. Correction: Authorized Cummins service facilities will update software programming.

• Seats And Restraints#2013427November 27, 2013

  2,888 units affected

  On certain trucks, the seat belts may not comply with Canada Motor Vehicle Safety Standard 209 - Seat Belt Assemblies. Due to a defect in manufacturing, the seat belt buckle may not release as required by the standard. This could hinder egress from the vehicle in an emergency, increasing the risk of injury. Correction: Dealers will inspect and, if necessary, replace affected seatbelt buckles.

• Electrical#2013088March 20, 2013

  56 units affected

  On certain trucks, the customizable SmartPlex switch hub module may experience intermittent electrical shorts. As a range of equipment may have been connected to the switch hub module by final stage vehicle manufacturers; depending on vehicle configuration and intended use, these electrical shorts could have varied consequences. These may include the erratic operation of emergency, warning and/or work lights, the unexpected activation of a remote engine starter or the intermittent and/or uncontrolled operation of other body equipment. These or other malfunctions may result in an increased risk to road users, operators or bystanders. Correction: Dealers will inspect and, if necessary, replace the switch hub module.

• Wheels#2012357October 19, 2012

  On certain vehicles, the wheel rims may have been manufactured incorrectly and could fail. A wheel separating from the vehicle could cause a loss of control and a crash. In addition, the errant wheel assembly could strike a vehicle, stationary object, or a bystander. These issues could result in property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, replace the wheel rims. Note: Further evaluation revealed that no Canadian vehicles are involved.

• Steering#2012119March 30, 2012

  256 units affected

  On certain vehicles, an incorrect steering wheel fastener may have been installed during vehicle assembly. The incorrect nut may not provide the clamp load required to fully seat the steering wheel onto the steering shaft. This could allow the steering wheel to wobble, which could hamper vehicle operation. If the problem is ignored, the nut could loosen completely, which could allow the steering wheel to detach from the steering shaft. These issues could result in a crash causing property damage and/or personal injury. Correction: Dealers will replace the steering wheel nut.

• Fuel System#2012080February 27, 2012

  11,923 units affected

  On certain trucks equipped with a Detroit Diesel DD13, DD15 or DD16 engine, the support system for the high pressure fuel line (between the fuel pump and the fuel delivery rail) may be damaged during a service repair procedure. Incorrect torque applied to the dampener "P" clip fasteners may damage the fasteners, which could allow the clips to loosen. This could result in a cracked fuel line and a diesel fuel leak. Diesel fuel leakage may ignite on a hot engine surface and cause a fire. As well, diesel fuel spilt on the roadway could endanger other road users by making the roadway unexpectedly slippery. These issues could result in property damage and/or personal injury. Correction: Dealers will replace the high pressure fuel line and install a more robust fuel line support system.

Canadian data updated August 24, 2026

• TIRES#21V896000November 17, 2021

  Daimler Trucks North America, LLC (DTNA) is recalling certain 2012-2021 Freightliner SD 108, Freightliner SD 114, 2016-2020 Freightliner Coronado, 2013 Western Star 6900, 2013-2022 Western Star 4700, Western Star 4900, and 2022 49X vehicles. The tires and rims are not approved and rated for these vehicles from the Tire and Rim Association or tire manufacturer. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 120, "Wheels and Rims-Other Than Passenger Cars."

  Risk: Unapproved tires that are not rated for the vehicle can cause tire performance issues, increasing the risk of a crash.

  Remedy: Dealer will inspect and replace, as necessary, tires and rims, free of charge. Interim owner notification letters were mailed January 14, 2022. Owner notification letters were mailed on April 22, 2022. Owners may contact DTNA customer service at 1-800-547-0712. DTNA's number for this recall FL-908.

• STEERING:LINKAGES:TIE ROD ASSEMBLY#18V503000July 31, 2018

  Daimler Trucks North America, LLC (DTNA) is recalling certain 2012-2015 Freightliner Cascadia, Coronado, Business Class M2, 114SD, and Western Star 4900 trucks. In certain front axle, brake lining, and brake spider combinations, braking may cause high vibrations, resulting in early failure of the tie-rod tube.

  Risk: A tie-rod failure would cause a disconnect between the front wheels, resulting in a loss of steering ability, thereby increasing the risk of a crash.

  Remedy: DTNA will notify owners, and dealers will replace the brake linings, brake spider, and tie-rod, free of charge. The recall began March 22, 2019. Owners may contact DTNA customer service at 1-800-547-0712. DTNA's number for this recall is FL782.

• SERVICE BRAKES, AIR:DISC:CALIPER#16V206000April 12, 2016

  Daimler Trucks North America LLC (DTNA) is recalling certain model year 2010-2017 Freightliner M2 Business Class, 108SD, 114SD, and Columbia trucks manufactured from January 6, 2010, through February 29, 2016, equipped with certain Bendix rear disk brakes and spring suspensions. The rear disk brake caliper may have been installed incorrectly, thus allowing the caliper to contact the suspension.

  Risk: Caliper contact with the spring suspension may reduce the braking effectiveness, increasing the risk of a crash.

  Remedy: DTNA will notify owners, and dealers will correct the orientation of the rear brake calipers, as necessary, free of charge. The recall began on June 8, 2016. Owners may contact DTNA customer service at 1-800-547-0712. DTNA's recall number for this campaign is FL-705.

• ENGINE AND ENGINE COOLING:ENGINE#15V343000June 3, 2015

  Daimler Trucks North America LLC (DTNA) is recalling certain model year 2007-2016 Freightliner 114SD and M2 Business Class trucks, 2008-2009 Sterling LT8500 trucks and Thomas Built Bus Saf-T-Liner HDX transit buses equipped with certain Cummins Westport ISL G engines. Excessive engine crankcase pressures may cause the 90-degree elbow of the vent tube assembly to detach from the crankcase ventilation breather, possibly allowing engine oil to come into contact with hot surfaces.

  Risk: If engine oil comes into contact with a hot surface, there is an increased risk of a fire.

  Remedy: Cummins will notify owners on behalf of DTNA, and dealers will secure the ends of the 90-degree elbow. In addition, the electronic control module (ECM) will be reprogrammed with software that can adjust the engine output under misfire conditions to limit crankcase pressures. These repairs will be performed free of charge. The recall began on June 12, 2015. Owners may contact DTNA customer service at 1-800-745-8000 or Cummins customer service at 1-800-343-7357. DTNA's number for this recall is FL-681.

• ENGINE AND ENGINE COOLING:ENGINE#14V080000February 21, 2014

  Daimler Trucks North America LLC (Daimler) is recalling certain model year 2008-2015 Freightliner 114SD, Cascadia, M2 Business Class, Sterling LT8500, and Thomas Built Buses Saf-T-Liner HDX vehicles manufactured February 19, 2008, through February 11, 2014, and equipped with Cummins Westport Model ISL G and Cummins Westport Model ISX12 G engines. Condensation in the intake manifold may freeze during cold weather conditions and interfere with the proper operation of the intake manifold pressure sensor.

  Risk: The sensor malfunction could induce elevated exhaust temperatures or flames from the exhaust pipe, increasing the risk of a vehicle fire or burn injury to a person near the exhaust pipe.

  Remedy: Cummins and Cummins Westport will notify owners, and authorized Cummins service facilities will upload a new ECM calibration, free of charge. The recall began on April 12, 2014. Customers may contact Daimler at 1-800-385-4357 or Cummins Inc. at 1-800-343-7357. Daimler's number for this recall is FL-660.

• ELECTRICAL SYSTEM#13V074000March 4, 2013

  Daimler Trucks North America (DTNA) is recalling certain model year 2012-2013 Business Class M2, 108SD, 114SD vehicle chassis, manufactured from December 3, 2011, through October 12, 2012 and equipped with a SmartPlex switch hub module. Residue left over in the manufacturing process of the switch hub module may lead to intermittent shorts and energizing of certain switch hub module outputs.

  Risk: If the module is energized, the module may inadvertently activate body equipment or features, increasing the risk of injury to the vehicle operator or increasing the risk of a crash.

  Remedy: DTNA will notify owners, and dealers will replace any of the affected modules free of charge. The recall began on April 29, 2013. Owners may contact DTNA at 1-800-547-0712.

• STEERING:COLUMN#12V137000April 2, 2012

  DAIMLER TRUCKS (DTNA) IS RECALLING ONE 2012 CASCADIA AND CERTAIN MODEL YEAR 2012 AND 2013 FREIGHTLINER BUSINESS CLASS M2 VEHICLES, AND MODEL YEAR 2013 108SD AND 114SD VEHICLES MANUFACTURED FROM JANUARY 20, 2012, THROUGH FEBRUARY 17, 2012. CERTAIN PROPERTY CLASS 04 (PC04) STEERING WHEEL NUTS WITH INCOMPLETELY FORMED THREADS WERE SUPPLIED TO DTNA IN LIEU OF THE SPECIFIED PROPERTY CLASS 05 NUTS. THE STEERING WHEEL NUTS SUPPLIED MAY NOT PROVIDE THE CLAMP LOAD REQUIRED TO FULLY SEAT THE STEERING WHEEL ON THE STEERING SHAFT WHEN TIGHTENED TO THE SPECIFIED TORQUE.

  Risk: A STEERING WHEEL THAT IS NOT FULLY SEATED ON THE STEERING SHAFT MAY WOBBLE AND MAKE IT DIFFICULT TO CONTROL THE VEHICLE, INCREASING THE RISK OF A CRASH.

  Remedy: DTNA WILL NOTIFY OWNERS, AND AFFECTED VEHICLES WILL HAVE A NEW STEERING WHEEL NUT INSTALLED BY DTNA AUTHORIZED SERVICE FACILITIES, FREE OF CHARGE. THE SAFETY RECALL BEGAN ON MAY 21, 2012. OWNERS MAY CONTACT DTNA AT 1-800-547-0712.

• ENGINE AND ENGINE COOLING:ENGINE:DIESEL#12V074000February 28, 2012

  DAIMLER TRUCKS (DTNA) IS RECALLING CERTAIN MODEL YEAR 2006-2013 FREIGHTLINER, STERLING, AND WESTERN STAR VEHICLES, EQUIPPED WITH DETROIT DIESEL EPA07 AND EPA10, DD13 AND DD15/16 ENGINES, MANUFACTURED FROM JANUARY 20, 2006, THROUGH FEBRUARY 20, 2012. THE PUMP TO RAIL HIGH PRESSURE FUEL LINE SUPPORT SYSTEM USED ON THESE ENGINES IS SENSITIVE TO ASSEMBLY TORQUE AND MAY BE DAMAGED DURING SERVICE WORK. AS A RESULT OF OTHER REPAIRS, THE LINE SUPPORTS MAY LOOSEN, POTENTIALLY LEADING TO FUEL LINE CRACKING AND A FUEL LEAK.

  Risk: A FUEL LEAK COULD CREATE A ROAD HAZARD, INCREASING THE RISK OF A CRASH. ALSO A FUEL LEAK IN THE PRESENCE OF AN IGNITION SOURCE CAN RESULT IN A FIRE.

  Remedy: DTNA WILL NOTIFY OWNERS, AND WHERE NECESSARY, THE HIGH PRESSURE FUEL LINE SUPPORT SYSTEM WILL BE REPLACED BY DTNA AUTHORIZED SERVICE FACILITIES, FREE OF CHARGE. THE SAFETY RECALL BEGAN ON APRIL 27, 2012. OWNERS MAY CONTACT DTNA AT 1-800-547-0712.