Ford F-550 Chassis CAB recalls

• Visual System#2026161April 1, 2026

  31,510 units affected

  Issue: On certain trucks, the windshield wiper arms may not have been manufactured correctly. As a result, the wiper arm(s) could break or become detached and may not wipe the windshield properly. Safety Risk: Windshield wipers that do not work properly could affect a driver's visibility. Windshield wiper(s) that detach from the vehicle could create a road hazard for others. Both issues could increase the risk of a crash. Corrective Actions: Ford will notify owners by mail. The corrective actions for this recall are under development.

• Fuel System#2026122March 17, 2026

  564 units affected

  Issue: On certain vehicles, the recall repairs completed by a Ford dealer during recall 24S78 (Transport Canada recall no. 2024-780) may not have been done correctly. As a result, a second repair is required. On certain vehicles, the high-pressure fuel pump could fail. If this happens, the engine may run rough and the check engine light may turn on. This could also cause a sudden loss of engine power while driving. Note: This recall only affects certain vehicles equipped with a 6.7 L diesel engine. Safety Risk: A sudden loss of engine power could increase the risk of a crash. Corrective Actions: Ford will notify owners by mail and advise you to take your vehicle to a dealership to update the powertrain control module software.

• Visual System#2025449September 3, 2025

  122,125 units affected

  Issue: On certain vehicles, there could be a problem with the connections inside the rearview camera. As a result, the rearview camera image may not display correctly or at all when the transmission is shifted into reverse. Note: For certain models, this recall also affects incomplete vehicles. Safety Risk: A rearview camera image that doesn't display could reduce a driver's ability to see behind the vehicle while backing up. This could increase the risk of a crash. Corrective Actions: Ford will notify owners by mail and advise you to take your vehicle to a dealership to inspect and, if necessary, replace the rearview camera.

• Fuel System#2024780December 20, 2024

  24,495 units affected

  Issue: On certain vehicles, the high-pressure fuel pump could fail. If this happens, the engine may run rough and the check engine light may turn on. This could also cause a sudden loss of engine power while driving. Note: This recall only affects certain vehicles equipped with a 6.7 L diesel engine. Safety Risk: A sudden loss of engine power could increase the risk of a crash. Corrective Actions: Ford will notify owners by mail and advise you to take your vehicle to a dealership to update the powertrain control module software.

• Structure#2017502October 18, 2017

  222,408 units affected

  On certain vehicles, door latch shielding may not be sufficient. As a result, water could enter into the side door latch and freeze, causing the latch mechanism to bind after opening. In addition, latch actuation cables may have been bent or kinked during installation, and could result in latch binding. A frozen door latch, or bent or kinked actuation cable may result in a door that will not open or will not close. If a latch does not fully engage the door striker, there is a potential for a door to open while the vehicle is in motion, which could increase the risk of injury. Correction: Dealers will install water shields over the door latches and the door latch actuation cables will be inspected and repaired if needed.

• Accessories#2017276May 23, 2017

  304 units affected

  Certain decorative chrome door handle covers, sold as aftermarket accessories through Ford dealers, may affect compliance to Canada Motor Vehicle Safety Standard (CMVSS) 206 – Door Lock and Door Retention Components. These accessories may cause the door handles to fail to conform to the inertial load requirements of the standard. A door handle fitted with a chrome cover could unlatch due to inertial loads during a side impact crash if the door were unlocked, which would increase the risk of injury. Correction: Covers will be removed from vehicles and owners will be reimbursed for parts and labour.

• Seats And Restraints#2017275May 23, 2017

  175 units affected

  Certain vehicles equipped with a manual-recline driver seat may fail to conform to Canada Motor Vehicle Safety Standard (CMVSS) 202 - Head Restraints and CMVSS 207 - Anchorage of Seats. Due to a manufacturing error, the recliner mechanism may have been incorrectly welded to the seat-back frame, which would result in the seat failing to meet the requirements of the standards. This could increase the risk of injury to the seat occupant in the event of a crash. Correction: Dealers will inspect the front driver seat back frame build date and replace as necessary.

• Powertrain#2017182March 29, 2017

  39 units affected

  Certain vehicles equipped with a 6.8L gasoline engine, 4x4 drive, 205” wheel base and 4.88 axle ratio may experience a driveline vibration caused by a powertrain resonance at speeds above 120 km/h. Continued operation of a vehicle at these speeds could result in a resonance frequency that may fracture transmission and/or driveline components. If the transmission and or driveline components were to fracture, it could result in a loss of motive power while the vehicle is in motion, or unintended vehicle movement in Park if the parking brake is not applied, which would increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will replace the two-piece driveshaft with a new three-piece driveshaft and two center bearing brackets.

Canadian data updated August 24, 2026