Ford F-250 recalls

• Other#2019420August 21, 2019

  5,327 units affected

  Issue: This recall is for aftermarket replacement rear window glass produced by Vitro Automotriz. Certain rear window glass may not have been properly tempered. If the window breaks, the glass may separate into large pieces instead of very small ones. Note: This is a voluntary recall that is not being conducted under the requirements of the Motor Vehicle Safety Act. Safety Risk: Glass that breaks in to large pieces could create a risk of injury. Corrective Actions: The company will notify consumers by mail and instruct them to inspect the designation code marked on the rear window glass. Products affected by this recall have the designation “DOT 287” along with the lettering “VMR” (Replacement Market) and a date code that is before July 2019. This information is printed on the bottom corner of the glass. Consumers should contact Vitro's customer service at 1-412-995-6457 or argbacklites@vitro.com to arrange for replacement of the glass.

• Accessories#2017276May 23, 2017

  304 units affected

  Certain decorative chrome door handle covers, sold as aftermarket accessories through Ford dealers, may affect compliance to Canada Motor Vehicle Safety Standard (CMVSS) 206 – Door Lock and Door Retention Components. These accessories may cause the door handles to fail to conform to the inertial load requirements of the standard. A door handle fitted with a chrome cover could unlatch due to inertial loads during a side impact crash if the door were unlocked, which would increase the risk of injury. Correction: Covers will be removed from vehicles and owners will be reimbursed for parts and labour.

• Powertrain#2017190April 3, 2017

  4,208 units affected

  Certain vehicles equipped with 6.2L gasoline engines and 6R100 transmissions may fail to conform to Canada Motor Vehicle Safety Standard (CMVSS) 102 - Transmission Control Functions and CMVSS 114 - Theft Protection and Rollaway Prevention. The park rod actuating plate may have been damaged during manufacturing, which could inhibit transmission parking pawl engagement. If the operator were to move the shift lever to park, the transmission may not achieve mechanical park, which if the parking brake is not applied, could result in unintended vehicle movement, increasing the risk of injury and/or property damage. Correction: Dealers will inspect the park rod actuating plate and replace as necessary. Note: In the interim, owners are advised to use the parking brake whenever the transmission shift lever is in the Park position until the vehicle is repaired.

• Tires#2016185April 26, 2016

  271 units affected

  On certain vehicles, the inner sidewall of the affected tires may have been damaged during vehicle assembly. This could result in a loss of air or, in some cases, a rupture during use. If this were to occur, a damaged tire that ruptures or rapidly loses air may result in a loss of vehicle control, increasing the risk of a crash causing injury and/or damage to property. Correction: Dealers will inspect the tires and replace if necessary.

• Steering#2015081February 24, 2015

  21 units affected

  On certain vehicles equipped with diesel engines, service replacement steering gears, installed after June 30, 2014, may not properly mount to the frame rail due to insufficient clearance. This could result in insufficient clamp load on the joints, which over time may cause fatigue of one or more of the steering gear retention bolts. If the steering gear bolts were to fatigue, one or more of the bolts could fracture, which could result in a loss of steering control, increasing the risk of a crash causing injury and/or damage to property. Correction: Dealers will install spacers between the gear and the frame rail to add clearance and ensure adequate clamp load to the joints.

Canadian data updated August 24, 2026