2016 Chevrolet Malibu ECO recalls

• Seats And Restraints#2021522August 20, 2021

  24 units affected

  Issue: On certain vehicles, a bolt that attaches the rear seat belt retractor(s) may be missing. As a result, the seat belt may not work as designed in a crash. Note: On Chevrolet Malibu models, the right rear seat belt could be affected. On Cadillac XT4 models, both the left and right rear seat belts could be affected. Safety Risk: A seat belt that does not work properly could increase the risk of injury in a crash. Corrective Actions: General Motors will notify owners by mail and instruct you to take your vehicle to check that the rear seat belt retractor bolts are properly installed. The dealer will replace or tighten the bolt(s), as required.

• Other#2019420August 21, 2019

  5,327 units affected

  Issue: This recall is for aftermarket replacement rear window glass produced by Vitro Automotriz. Certain rear window glass may not have been properly tempered. If the window breaks, the glass may separate into large pieces instead of very small ones. Note: This is a voluntary recall that is not being conducted under the requirements of the Motor Vehicle Safety Act. Safety Risk: Glass that breaks in to large pieces could create a risk of injury. Corrective Actions: The company will notify consumers by mail and instruct them to inspect the designation code marked on the rear window glass. Products affected by this recall have the designation “DOT 287” along with the lettering “VMR” (Replacement Market) and a date code that is before July 2019. This information is printed on the bottom corner of the glass. Consumers should contact Vitro's customer service at 1-412-995-6457 or argbacklites@vitro.com to arrange for replacement of the glass.

• Airbag#2018322June 15, 2018

  4 units affected

  On certain vehicles that had the front passenger presence system (PPS) replaced, the replacement parts may have been incorrectly calibrated. This could cause the PPS not to properly identify certain children and small adults seated in the front passenger seat. If the vehicle was involved in a crash, this could cause the airbag to deploy when it should not, or could cause the airbag not to deploy when it should. Either of these outcomes could increase the risk of injury to the seat occupant. Correction: Dealers will replace the front PPS.

• High Voltage#2016351July 7, 2016

  33 units affected

  On certain hybrid vehicles, the manual service disconnect (MSD) may not have been properly installed and may not be locked in position. This could cause the MSD to become loose and disconnect while driving, which could cut off all high-voltage power to the vehicle. The loss of high-voltage power could cause the vehicle to stall without warning, which would result in lost propulsion which, in conjunction with traffic and road conditions, and the driver's reactions, could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will inspect and seat the MSD connector properly. The dealer will also install an updated calibration to monitor if the high voltage interlock loop is incomplete.

• Powertrain#2016341June 30, 2016

  1,419 units affected

  Certain vehicles may fail to conform to Canada Motor Vehicle Safety Standard (CMVSS) 114 - Theft Protection and Rollaway Prevention. The Electronic Park Lock (EPL) lever in the steering column electrical assembly may have been damaged during manufacturing. As a result, the ignition key could be removed when the vehicle’s transmission is in a position other than park. This could cause unintended vehicle movement, increasing the risk of injury and/or property damage. Correction: Dealers will inspect the vehicle and, if necessary, replace the key cylinder lock housing.

• Brakes#2016199May 5, 2016

  56 units affected

  Certain vehicles fail to comply with the requirements of Canada Motor Vehicle Safety Standard (CMVSS) 126 - Electronic Stability Control Systems. The memory chip in the electronic brake control module (EBCM) may fail and cause the loss of electronically controlled brake systems, including anti-lock brakes (ABS) and electronic stability control (ESC). As a result, the vehicle could be more difficult to control in situations where these brake systems would normally be engaged, which could increase the risk of a crash causing injury and/or damage to property. Correction: Dealers will install a replacement EBCM. Note: This condition does not affect the primary braking system; the service brakes will operate normally.

• Structure#2016116March 11, 2016

  105 units affected

  Certain vehicles may not comply with the side impact protection requirements of United States Federal Motor Vehicle Safety Standard 214, which is voluntarily-adopted in Canada. The two weld studs that mount the front and rear side impact airbag (“SIAB”) inflators to the seat frame may fracture and separate during airbag deployment. If the vehicle is involved in a crash that warrants side airbag deployment, and both weld studs were to fracture, the inflated cushion may not remain in its intended position and may separate from the seat, increasing the risk of injury to vehicle occupants. Correction: Dealers will inspect and replace the affected side airbag modules as necessary, which may include any combination of left, right, front, and/or rear side airbag modules.

• Airbag#2016102March 2, 2016

  161 units affected

  On certain vehicles, the second stage of the driver frontal airbag may not deploy properly in certain high speed crashes. If the vehicle were to be involved in a high speed crash that triggers the second-stage deployment of the driver frontal airbag, the second stage of the inflator may not fill the airbag as completely and as quickly as designed, which could increase the risk of injury to the driver. Correction: Dealers will replace the driver frontal airbag module.

Canadian data updated August 24, 2026

No recalls found for this make, model, and year.