RECALLS — MAKE · MODEL · YEAR
2014 BMW Z4 SDRIVE35IS recalls
4 safety recall campaigns have been filed for the 2014 BMW Z4 SDRIVE35IS with Transport Canada and the U.S. NHTSA. Here is what both agencies say.
- Canadian recalls
- 04
- U.S. recalls
- 00
- Total campaigns
- 04
Transport Canada recalls
04- Label#2024544
587,250 units affected
Issue: On certain vehicles, the tire and loading information label does not list that there is no spare tire in both official languages. The label reads as "NONE" when it should read as "NONE / AUCUN". Canadian regulations require the information to be listed on the label in both English and French. Safety Risk: This error does not affect vehicle safety. Corrective Actions: This is not a recall. The company has corrected the tire and loading information label for all new vehicles.
- Engine#2024468
78,381 units affected
Issue: On certain vehicles, fluid from the positive crankcase ventilation (PCV) system could leak on the intake air hose. As a result, the fluid could enter the electrical connector for the water pump and cause a short circuit. Safety Risk: A short circuit can create the risk of a fire, even while the vehicle is parked and turned off. Corrective Actions: To reduce the safety risk, BMW advises you to park your vehicle outdoors and away from other vehicles or structures until the recall repairs are completed. BMW will notify owners by mail and advise you to take your vehicle to a dealership to inspect and, if necessary, replace the water pump and electrical connector. The dealer will also install a shield on the connector.
- Powertrain#2014435
1,279 units affected
On certain vehicles, a defect in manufacturing could result in a loss of oil supply to the vacuum pump. If this were to occur, the vacuum pump could fail, causing a loss of power assist to the braking system. This could cause increased stopping distances, possibly resulting in a crash causing injury and/or damage to property. Correction: Dealers will install a camshaft seal disk locking ring. Note: This is an expansion of recall 2013-330.
- Brakes#2013330
9,406 units affected
On certain vehicles, a defect in manufacturing could result in a loss of oil supply to the vacuum pump. If this were to occur, the vacuum pump could fail, causing a loss of power assist to the braking system. This could cause increased stopping distances, possibly resulting in a crash causing injury and/or damage to property. Correction: Dealers will install a camshaft seal disk locking ring.
Canadian data updated August 24, 2026
U.S. NHTSA recalls
00No recalls found for this make, model, and year.
Does this recall apply to my vehicle?
Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.
What to do
Recall repairs are free at a franchised dealer in both countries. To confirm a recall applies to your specific vehicle, or to book the work, contact your manufacturer or dealer with your full VIN, or use the official channel:
- NHTSA recall lookup (search by VIN) — U.S. National Highway Traffic Safety Administration
- Defects and recalls database — Transport Canada
Check a 2014 BMW Z4 SDRIVE35IS VIN
A VIN decode confirms your vehicle's exact model year, trim and assembly plant, then runs this same recall check against it.