BMW Z4 recalls

• Engine#2026331July 8, 2026

  26,247 units affected

  Issue: On certain vehicles, the engine starter may not have been manufactured properly. As a result, the starter could overheat. Note: This recall is an expansion of Transport Canada recall no. 2026-040. Safety Risk: A starter that overheats can create the risk of a fire. Corrective Actions: To reduce the safety risk, BMW recommends not using the remote start function and not leaving the vehicle unattended with the engine running until the recall repairs have been completed. BMW will notify owners by mail and advise you to take your vehicle to a dealership to replace the engine starter.

• Lights And Instruments#2026285June 9, 2026

  25,552 units affected

  Issue: Under certain conditions, the windshield wiping system may not meet certain requirements of Canadian regulations. Safety Risk: This small error does not affect safety. Corrective Actions: This is not a recall. BMW has made changes to ensure that all new vehicles meet Canadian regulations.

• Engine#2026040January 30, 2026

  6,958 units affected

  Issue: On certain vehicles, the engine starter may not have been manufactured properly. As a result, the starter could overheat. Safety Risk: A starter that overheats can create the risk of a fire. Corrective Actions: To reduce the safety risk, BMW recommends not using the remote start function and not leaving the vehicle unattended with the engine running until the recall repairs have been completed. BMW will notify owners by mail and advise you to take your vehicle to a dealership to replace the engine starter.

• Electrical#2025499September 23, 2025

  17,761 units affected

  Issue: On certain vehicles, water could leak into the starter relay and cause it to corrode. If this happens, the relay could short circuit and the starter could overheat. Safety Risk: A short circuit and/or a starter that overheats can create a fire risk, even while the vehicle is parked and turned off. Corrective Actions: To reduce the safety risk, BMW advises that you should park your vehicle outdoors and away from other vehicles or structures until the recall repairs have been completed. BMW will notify owners by mail and advise you to take your vehicle to a dealership to replace the engine starter.

• Label#2024544August 15, 2024

  587,250 units affected

  Issue: On certain vehicles, the tire and loading information label does not list that there is no spare tire in both official languages. The label reads as "NONE" when it should read as "NONE / AUCUN". Canadian regulations require the information to be listed on the label in both English and French. Safety Risk: This error does not affect vehicle safety. Corrective Actions: This is not a recall. The company has corrected the tire and loading information label for all new vehicles.

• Engine#2024468August 13, 2024

  78,381 units affected

  Issue: On certain vehicles, fluid from the positive crankcase ventilation (PCV) system could leak on the intake air hose. As a result, the fluid could enter the electrical connector for the water pump and cause a short circuit. Safety Risk: A short circuit can create the risk of a fire, even while the vehicle is parked and turned off. Corrective Actions: To reduce the safety risk, BMW advises you to park your vehicle outdoors and away from other vehicles or structures until the recall repairs are completed. BMW will notify owners by mail and advise you to take your vehicle to a dealership to inspect and, if necessary, replace the water pump and electrical connector. The dealer will also install a shield on the connector.

• Powertrain#2023646December 6, 2023

  79 units affected

  Issue: On certain vehicles, the integrated transmission control unit (ITCU) may not be sealed properly. As a result, transmission oil could leak into the unit and cause the transmission gears to seize. If this happens, there could be a loss of power to the wheels. Safety Risk: A loss of power to the wheels could increase the risk of a crash. Corrective Actions: BMW will notify owners by mail and advise you to take your vehicle to a dealership to replace the ITCU. The dealer will also inspect the transmission fluid and replace it, if necessary.

• Engine#2023568October 20, 2023

  21,475 units affected

  Issue: On certain vehicles, the variable camshaft timing (VANOS) adjustment unit housing bolts could loosen or break. As a result, the camshaft could become incorrectly adjusted and cause the engine to enter a reduced power mode (limp mode) or to stall while driving. Safety Risk: A sudden loss of engine power could increase the risk of a crash. Corrective Actions: BMW will notify owners by mail and advise you to take your vehicle to a dealership to replace the VANOS bolts.

• Structure#2023075February 17, 2023

  527 units affected

  Issue: On certain vehicles, a software problem could allow you to close the windows and roof without the digital key inside the vehicle. Canadian regulations require a key to be in or near the vehicle when closing the windows or roof system. Safety Risk: A window or roof that can be closed without the digital key in or near the vehicle could create a risk of injury. Corrective Actions: BMW will notify owners by mail and instruct you to take your vehicle to a dealership to update the electronic control unit software. To reduce safety risk, BMW recommends that you shouldn't use the digital key, and that the vehicle should only be operated with the key fob until the recall repairs are completed.

• Engine#2022095March 2, 2022

  98,111 units affected

  Issue: On certain vehicles equipped with an N52 or N52K 6-cylinder engine, a manufacturing problem could cause the PCV valve heater (blow-by heater) to short circuit and overheat. Note: This replaces Transport Canada recalls 2017-470 and 2019-170. Only vehicles equipped with an N52 or N52K engine require this repair. Safety Risk: An overheated engine PCV valve heater could create the risk of a fire, even while the vehicle is parked and turned off. Corrective Actions: BMW will notify owners by mail and instruct you to take your vehicle to a dealer to install a wire harness repair kit. BMW recommends that you should park your vehicle outdoors until the recall repairs have been completed.

• Brakes#2021479August 3, 2021

  3,506 units affected

  Issue: On certain vehicles, a software problem could cause the vacuum pump to be damaged during engine starting. If this happens, there could be a loss of brake assist. This can cause an increase in brake pedal effort and increase the distance needed to stop the vehicle. Safety Risk: A sudden increase in brake pedal force could lead to an increased stopping distance. This could increase the risk of a crash. Corrective Actions: BMW will notify owners by mail and instruct you to take your vehicle to a dealer to update the engine management software.

• Seats And Restraints#2021448July 21, 2021

  1,615 units affected

  Issue: On certain vehicles, the passenger seat belt assemblies may contain defective automatic locking retractors (ALR). As a result, the seat belts may not properly lock to secure a child seat. Safety Risk: A seat belt that is not properly locked could increase the risk of injury in a crash. Corrective Actions: The company will notify owners by mail and instruct you to take your vehicle to a dealer to inspect the seat belts. They will be replaced, if necessary.

• Lights And Instruments#2020395August 27, 2020

  347 units affected

  Issue: On certain vehicles, the headlight adjustment plugs were not properly installed when the vehicle was assembled. As a result, the headlights may be adjusted horizontally. Canadian regulations do not allow for horizontal headlight adjustment unless the vehicle is equipped with a built-in aiming device. Safety Risk: Headlights that are not properly adjusted could cause reduced visibility or glare for oncoming drivers, and could increase the risk of a crash. Corrective Actions: BMW will notify owners by mail and instruct you to take your vehicle to a dealer to inspect the headlights. If an incorrect adjustment plug is found, it will be replaced with the correct plug.

• Steering#2020267June 16, 2020

  1,018 units affected

  Issue: On certain vehicles, high temperatures and excessive vibration could cause damage to the steering tie rods. If this happens, the tie rods could break. This could result in a loss of steering control. Safety Risk: A loss of steering control could create a risk of a crash. Corrective Actions: BMW will notify owners by mail and instruct you take your vehicle to a dealer to replace the steering tie rods.

• Visual System#2019480October 1, 2019

  14,323 units affected

  Issue: On certain vehicles, the rearview camera does not return to the default settings when it turns on. This could make the rearview image difficult to see if a driver had previously adjusted the camera display brightness at or near the lowest setting, and contrast at or near the highest setting. Canadian regulations require that the rearview display returns to the default view each time the camera is turned on. Safety Risk: Reduced rear visibility could increase the risk of a crash. Corrective Actions: The company will notify owners by mail and instruct them to take their vehicle to a dealer to update the software for the rearview camera. Drivers are recommended not to adjust the display brightness at or near the lowest setting, and contrast at or near the highest setting, until this recall is completed.

• Powertrain#2019069February 13, 2019

  9 units affected

  Issue: On certain vehicles, the accelerator pedal may interfere with a wiring harness. This could cause the accelerator pedal to get stuck. Safety Risk: A stuck accelerator pedal would lead to unintended acceleration of the vehicle, increasing the risk of a crash. Corrective Actions: Dealers will inspect the accelerator pedal module wiring harness. The wiring harness will be moved and secured if necessary. All vehicles will be repaired prior to sale.

• Engine#2017470September 28, 2017

  79,616 units affected

  On certain vehicles equipped with the N52 6-cylinder engine, an electrical short could occur in the PCV valve heater due to manufacturing irregularities. If this occurs, the surrounding plastics could overheat, melt and potentially cause a fire, which could increase the risk of injury and/or damage to property. Correction: Dealers will replace the PCV valve heater.

• Powertrain#2017242May 3, 2017

  869 units affected

  On certain vehicles, the rivet connections for the constant velocity (CV) joint of the rear driveshaft may have insufficient durability. Over time, this could cause the CV joint to break, resulting in a loss of propulsion which could increase the risk of a crash causing injury and/or property damage. Correction: Dealers will replace the CV joint. Note: This recall supersedes recall 2017-049

• Powertrain#2017049February 3, 2017

  869 units affected

  On certain vehicles, the rivet connections for the constant velocity (CV) joint of the rear driveshaft may have insufficient durability. Over time, this could cause the CV joint to break, resulting in a loss of propulsion which could increase the risk of a crash causing injury and/or property damage. Correction: Dealers will check the production date of the CV joint and, if necessary, replace the CV joint.

• Electrical#2015343July 30, 2015

  2,966 units affected

  Certain vehicles, which were parked at the port of entry in Halifax during the ice storms in February 2015, may have been exposed to excessive standing water and salt for an extended period due to this isolated environmental incident. Certain MINI models could have corrosion at the starter motor power supply cable connectors, which could lead to the inability to restart the engine following an engine shutdown by the start-stop (MSA) system, increasing the risk of crash causing injury in a traffic situation. On certain BMW models, the lubrication of some internal components within the steering rack may have been exposed to excessive water or salt which could result in higher than normal steering effort or steering binding, increasing the risk of a crash causing injury and/or damage to property. In addition, electrical wires and/or connectors in all affected vehicles may have been exposed to water or salt, which could lead to increased electrical system resistance, and increase the risk of fire causing injury and/or damage to property. Correction: Owners should contact their selling Retailer regarding this recall. Affected vehicles will be inspected. Some vehicles will be taken out of service immediately and owners will be provided with temporary transportation until a new replacement vehicle is available. All other vehicles are cleared of this safety concern and may continue to be driven until a new replacement vehicle is available. Due to potential concerns about long term vehicle quality, all affected vehicles will ultimately be removed from service.

• Powertrain#2014435October 3, 2014

  1,279 units affected

  On certain vehicles, a defect in manufacturing could result in a loss of oil supply to the vacuum pump. If this were to occur, the vacuum pump could fail, causing a loss of power assist to the braking system. This could cause increased stopping distances, possibly resulting in a crash causing injury and/or damage to property. Correction: Dealers will install a camshaft seal disk locking ring. Note: This is an expansion of recall 2013-330.

• Engine#2014170May 13, 2014

  21,811 units affected

  On certain vehicles, housing bolts for the variable camshaft timing system could break, allowing camshaft timing to deviate. If this occurs, the engine would revert to "limp home mode", limiting available engine power. In rare instances the engine could stall, increasing the risk of a collision causing injury and/or damage to property. Correction: Dealers will replace housing bolts that break and perform associated repairs for 10 years/unlimited mileage from the vehicle's in-service date. Note: This applies only to vehicles not covered by recall 2014-127.

• Engine#2014127April 10, 2014

  20,022 units affected

  On certain vehicles, housing bolts for the variable camshaft timing system could break, allowing camshaft timing to deviate. If this occurs, the engine would revert to "limp home mode", limiting available engine power. This could increase the risk of a collision causing injury and/or damage to property. Correction: Dealers will replace affected bolts.

• Brakes#2013330September 27, 2013

  9,406 units affected

  On certain vehicles, a defect in manufacturing could result in a loss of oil supply to the vacuum pump. If this were to occur, the vacuum pump could fail, causing a loss of power assist to the braking system. This could cause increased stopping distances, possibly resulting in a crash causing injury and/or damage to property. Correction: Dealers will install a camshaft seal disk locking ring.

• Electrical#2013048February 7, 2013

  65,685 units affected

  On certain vehicles, the positive battery cable connection to the fuse box could fail while the vehicle is being driven. This could interrupt the vehicle’s electrical system, resulting in engine stalling, loss of vehicle propulsion and a loss of function of various vehicle systems, such as lights. A loss of vehicle propulsion and electrical vehicle systems, in conjunction with traffic and road conditions, and the driver’s reactions, could increase the risk of a crash causing property damage and/or personal injury. Correction: Dealers will replace the positive battery cable connector with an updated version.

Canadian data updated August 24, 2026