2013 BMW X1 recalls

• Label#2024544August 15, 2024

  587,250 units affected

  Issue: On certain vehicles, the tire and loading information label does not list that there is no spare tire in both official languages. The label reads as "NONE" when it should read as "NONE / AUCUN". Canadian regulations require the information to be listed on the label in both English and French. Safety Risk: This error does not affect vehicle safety. Corrective Actions: This is not a recall. The company has corrected the tire and loading information label for all new vehicles.

• Engine#2024468August 13, 2024

  78,381 units affected

  Issue: On certain vehicles, fluid from the positive crankcase ventilation (PCV) system could leak on the intake air hose. As a result, the fluid could enter the electrical connector for the water pump and cause a short circuit. Safety Risk: A short circuit can create the risk of a fire, even while the vehicle is parked and turned off. Corrective Actions: To reduce the safety risk, BMW advises you to park your vehicle outdoors and away from other vehicles or structures until the recall repairs are completed. BMW will notify owners by mail and advise you to take your vehicle to a dealership to inspect and, if necessary, replace the water pump and electrical connector. The dealer will also install a shield on the connector.

• Airbag#2020008January 15, 2020

  47 units affected

  Issue: This recall is for certain vehicles that had an airbag inflator replaced as a part of an earlier recall campaign. This recall provides a final repair. Long-term exposure to high absolute humidity and temperature, combined with high temperature cycling, may eventually degrade the propellant contained in the driver-front airbag. This could cause the airbag to deploy with more force than normal. If the airbag inflator ruptures, fragments could be propelled toward vehicle occupants or cause damage to the airbag assembly, preventing its proper function. Safety Risk: If the vehicle is involved in a crash requiring an airbag deployment, the airbag inflator could rupture and create a risk of injury. Corrective Actions: Owners will be notified by mail and instructed to take their vehicle to a dealer to inspect the driver-front airbag inflator. The driver-front airbag module or inflator will be replaced as necessary. Note: The Canadian climate results in the propellant degrading slowly. This recall is being conducted as a precaution to address future risk. It is expected that all airbag inflators will be replaced before their function would be affected.

• Airbag#2019019January 15, 2019

  411 units affected

  Issue: On certain vehicles, long-term exposure to high absolute humidity and temperature, combined with high temperature cycling, may eventually degrade the propellant contained in the driver-front airbag. This could cause the airbag to deploy with more force than normal. If the airbag inflator ruptures, fragments could be propelled toward vehicle occupants or cause damage to the airbag assembly, preventing its proper function. Safety Risk: If the vehicle is involved in a crash requiring an airbag deployment, the airbag inflator could rupture and create a risk of injury. Corrective Action: Owners will be notified by mail and instructed to take their vehicle to a dealer to have the driver-front airbag module replaced. Note: The Canadian climate results in the propellant degrading slowly. This recall is being conducted as a precaution to address future risk. It is expected that all airbag inflators will be replaced before their function would be affected.

• Airbag#2016142March 31, 2016

  104,151 units affected

  On certain vehicles, the driver frontal airbag inflator could produce excessive internal pressure during airbag deployment. Increased pressure may cause the inflator to rupture, which could allow fragments to be propelled toward vehicle occupants, increasing the risk of injury. This could also damage the airbag module, which could prevent proper deployment. Failure of the airbag to fully deploy during a crash (where deployment is warranted) could increase the risk of personal injury to the seat occupant. Correction: Dealers will replace the front driver air bag inflator or air bag module, depending on the vehicle model.

• Powertrain#2014435October 3, 2014

  1,279 units affected

  On certain vehicles, a defect in manufacturing could result in a loss of oil supply to the vacuum pump. If this were to occur, the vacuum pump could fail, causing a loss of power assist to the braking system. This could cause increased stopping distances, possibly resulting in a crash causing injury and/or damage to property. Correction: Dealers will install a camshaft seal disk locking ring. Note: This is an expansion of recall 2013-330.

• Brakes#2013330September 27, 2013

  9,406 units affected

  On certain vehicles, a defect in manufacturing could result in a loss of oil supply to the vacuum pump. If this were to occur, the vacuum pump could fail, causing a loss of power assist to the braking system. This could cause increased stopping distances, possibly resulting in a crash causing injury and/or damage to property. Correction: Dealers will install a camshaft seal disk locking ring.

Canadian data updated August 24, 2026

• ENGINE AND ENGINE COOLING:COOLING SYSTEM:PUMP#24V608000August 13, 2024

  BMW of North America, LLC. (BMW) is recalling certain 2012-2015 X1 sDrive28i, X1 xDrive28i, 2012-2016 Z4 sDrive28i, 528i, 528i xDrive, 328i, 328xi, 2016-2018 X5 xdrive 40e, 2014-2016 228i, 228xi, 428i, 428i xDrive, 328xi Gran Turismo, 2013-2017 X3 sDrive28i, X3 xDrive28i, 2015-2018 X4 xDrive28i, 2015-2016 428xi vehicles. An improperly sealed electrical connector on the water pump may be exposed to water and short circuit.

  Risk: An electrical short increases the risk of a fire.

  Remedy: Dealers will inspect and replace the water pump and plug connector as necessary, and install a protective shield, free of charge. Owner notification letters were mailed on March 28, 2025. Owners may contact BMW customer service at 1-800-525-7417.

• AIR BAGS:FRONTAL:DRIVER SIDE:INFLATOR MODULE#20V017000January 15, 2020

  BMW of North America, LLC (BMW) is recalling certain 2008-2013 128i and 135i Convertibles, 128i, 135i, and M Coupes, 2007-2010 X3 30si and X3 xDrive30i, 2013-2015 X1 sDrive28i, X1 xDrive28i and X1 xDrive35i, 2007-2013 328i, 328i xDrive, 335i, 335is, 335i xDrive and M3 Coupes, 2006-2011 328i, 328xi, 328i xDrive, 325i, 325xi, 330i, 330xi, 335i, 335xi, 335i xDrive and M3, 2009-2011 335D, 2006-2012 325xi, 328i, 328xi and 328i xDrive, 2010-2011 X6 ActiveHybrid, 2007-2013 328i, 335i, 335is, M3 Coupes, X5 30si, X5 xDrive30i, X5 xDrive35i, X5 48i, X5 xDrive48i, X5 xDrive50i and X5 M, 2009-2013 X5 xDrive35d and 2008-2014 X6 xDrive35i, X6 xDrive50i and X6M vehicles equipped with non-desiccated driver frontal air bag inflators containing phase stabilized ammonium nitrate (PSAN) that were used as interim remedy parts for previous Takata recalls. These inflators may explode due to propellant degradation occurring after long-term exposure to high absolute humidity, high temperatures, and high temperature cycling.

  Risk: An inflator explosion may result in sharp metal fragments striking the driver or other occupants resulting in serious injury or death.

  Remedy: BMW will notify owners, and dealers will replace the driver air bag. On X5 and X6 vehicles, only the inflator will be replaced. All repairs will be performed free of charge. The recall began March 11, 2020. Owners may contact BMW customer service at 1-800-525-7417.