Does the 2010 BMW 6 Series have any recalls?

Transport Canada lists 3 campaigns and the U.S. NHTSA lists 2 for the 2010 BMW 6 Series. Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.

How do I know if a recall applies to my 2010 BMW 6 Series?

Recalls are matched by make, model and model year, but many cover only certain VIN ranges. Confirm with your manufacturer or dealer using your full VIN, or use the official Transport Canada or NHTSA lookup.

Are recall repairs free?

Yes. In both Canada and the United States the manufacturer must fix a recalled defect at no charge, through a franchised dealer.

RECALLS — MAKE · MODEL · YEAR

2010 BMW 6 Series recalls

5 safety recall campaigns have been filed for the 2010 BMW 6 Series with Transport Canada and the U.S. NHTSA. Here is what both agencies say.

Canadian recalls: 03
U.S. recalls: 02
Total campaigns: 05

Transport Canada recalls

Label#2024544August 15, 2024
587,250 units affected
Issue: On certain vehicles, the tire and loading information label does not list that there is no spare tire in both official languages. The label reads as "NONE" when it should read as "NONE / AUCUN". Canadian regulations require the information to be listed on the label in both English and French. Safety Risk: This error does not affect vehicle safety. Corrective Actions: This is not a recall. The company has corrected the tire and loading information label for all new vehicles.
Electrical#2012109March 23, 2012
16,748 units affected
On certain vehicles, the insulated bulkhead connector (used to join the two halves of the positive battery cable) may have been incorrectly installed during vehicle assembly. Over time, the bolt connection could loosen, which would increase electrical resistance. In addition, an incorrectly insulated bulkhead connector could allow humidity to accumulate at this location, causing current leakage. These issues could cause the cable connection to overheat, which could result in a vehicle fire causing property damage and/or personal injury. Correction: Dealers will inspect and, as necessary, secure the insulated bulkhead connector. In addition, protective grease will be added to the area and the plastic battery positive terminal cover will be replaced.
Brakes#2010328October 1, 2010
8,167 units affected
On certain vehicles, a check valve in the brake vacuum pump may leak a small amount of lubricating oil. Over time, this could result in contamination of the brake booster. Loss of brake power assist could occur which, in conjunction with traffic, road conditions, and driver's reactions, could increase the risk of a crash causing property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, replace the brake booster and master cylinder. Additionally, the brake vacuum line (including the check valve) will be replaced to eliminate the possibility of oil reaching the brake booster.

Canadian data updated August 24, 2026

U.S. NHTSA recalls

ELECTRICAL SYSTEM:12V/24V/48V BATTERY:CABLES#12V126000March 26, 2012
BMW IS RECALLING CERTAIN MODEL YEAR 2004-2010 5-SERIES, MODEL YEAR 2004-2010 6-SERIES, MODEL YEAR 2006-2010 M5, AND MODEL YEAR 2007-2010 M6 VEHICLES. THE INSULATED BULKHEAD CONNECTOR FOR THE POSITIVE BATTERY CABLE MAY HAVE BEEN INCORRECTLY ATTACHED TO THE TRUNK FLOOR PANEL, WHICH CAN LEAD TO A LOOSENING OF THE BOLT CONNECTION. AS IT LOOSENS, AN INCREASE IN ELECTRICAL RESISTANCE AT THIS CABLE CONNECTION IS POSSIBLE AND COULD CAUSE THE CABLE CONNECTION TO OVERHEAT.
Risk: OVERHEATING COULD LEAD TO A FIRE, EVEN WHILE THE VEHICLE IS NOT IN USE. AS A PRECAUTION, OWNERS ARE ADVISED TO PARK OUTSIDE UNTIL THE REMEDY HAS BEEN MADE.
Remedy: BMW WILL NOTIFY OWNERS, AND DEALERS WILL INSPECT AND SECURE THE BATTERY BOLT CABLE CONNECTION AS NECESSARY, FREE OF CHARGE. THE SAFETY RECALL BEGAN ON APRIL 30, 2012. OWNERS MAY CONTACT BMW CUSTOMER RELATIONS AND SERVICES AT 1-800-525-7417.
SERVICE BRAKES, HYDRAULIC:POWER ASSIST:VACUUM#10V446000October 1, 2010
BMW IS RECALLING CERTAIN MODEL YEAR 2004-2010 5-SERIES, 6-SERIES, AND MODEL YEAR 2002-2008 7-SERIES VEHICLES. A CHECK VALVE OF THE BRAKE VACUUM PUMP MAY LEAK A SMALL AMOUNT OF LUBRICATING OIL. OVER TIME THIS COULD RESULT IN CONTAMINATION OF THE BRAKE BOOSTER.
Risk: POWER ASSIST BRAKING PERFORMANCE COULD BE ADVERSELY AFFECTED. IN EXTREME CASES THERE COULD BE A COMPLETE LOSS OF POWER ASSIST BRAKING. AN UNEXPECTED REDUCTION OR LOSS IN POWER BRAKING ASSIST MAY INCREASE THE RISK OF A CRASH.
Remedy: BMW WILL NOTIFY OWNERS AND DEALERS WILL REPAIR THE VEHICLES FREE OF CHARGE. THE SAFETY RECALL BEGAN ON NOVEMBER 24, 2010. OWNERS MAY CONTACT BMW AT 1-800-525-7417.

Does this recall apply to my vehicle?

Matched by make, model, and model year. Many recalls affect only specific VIN ranges — confirm with your dealer using your full VIN.

What to do

Recall repairs are free at a franchised dealer in both countries. To confirm a recall applies to your specific vehicle, or to book the work, contact your manufacturer or dealer with your full VIN, or use the official channel:

NHTSA recall lookup (search by VIN) — U.S. National Highway Traffic Safety Administration
Defects and recalls database — Transport Canada

Check a 2010 BMW 6 Series VIN

A VIN decode confirms your vehicle's exact model year, trim and assembly plant, then runs this same recall check against it.

Data sources and coverage limits →