Rappels 2012 MCI D4000

• Moteur#201825614 mai 2018

  138 unités visées

  Sur certains autocars, la partie flexible du circuit d'échappement pourrait faire défaut prématurément et causer une fuite. Une fuite de gaz d'échappement pendant une régénération pourrait permettre la fuite de gaz chauds et augmenter les risques d'un incendie blessant quelqu'un ou endommageant des biens matériels. Correction : Les concessionnaires devront poser un nouveau tuyau d'échappement.

• Moteur#201728025 mai 2017

  35 unités visées

  Sur certains véhicules, le tuyau à soufflet (un composant du système d’échappement) pourrait avoir été mal monté et faire défaut. Dans un tel cas, de la combustion produite pendant le processus de regénération du filtre à particules diesel pourrait sortir du tuyau à soufflet défectueux au lieu d'être complètement contenue dans le système d’échappement. Dans une telle situation, les gaz de combustion chauds pourraient causer un incendie qui pourrait endommager des biens matériels ou blesser quelqu'un. Correction : les installations de service autorisées MCI inspecteront et, au besoin, remplaceront le tuyau à soufflet. Remarque : Le présent rappel s'ajoute au rappel 2013-121.

• Moteur#201312115 avril 2013

  18 unités visées

  Sur certains véhicules, le tuyau à soufflet (un composant du système d’échappement) pourrait avoir été mal monté et faire défaut. Dans un tel cas, de la combustion produite pendant le processus de regénération du filtre à particules diesel pourrait sortir du tuyau à soufflet défectueux au lieu d'être complètement contenue dans le système d’échappement. Dans une telle situation, les gaz de combustion chauds pourraient causer un incendie qui pourrait endommager des biens matériels ou blesser quelqu'un. Correction : les installations de service autorisées MCI inspecteront et, au besoin, remplaceront le tuyau à soufflet.

• Autres#201212510 avril 2012

  17 unités visées

  Sur certains autocars munis d'une porte d'accès de type berline, trente minutes après le serrage du frein de stationnement et l'arrêt du moteur, la porte d'accès se fermera sans avertissement. Cela pourrait blesser une personne se trouvant sur le pas de la porte. Correction : Des installations d'entretien MCI autorisées devront reprogrammer le dispositif de commande multiplex Actia.

• Autres#201137721 octobre 2011

  245 unités visées

  Sur certains véhicules, des conditions de fonctionnement spécifiques (comme des courbes serrées, successives et très relevées dans des directions opposées) pourraient déclencher le système de contrôle électronique de la stabilité. En conséquence, le système de contrôle pourraient serrer inutilement l'un des freins avant afin de corriger le survirage perçu. Cela pourrait faire dévier le véhicule de la trajectoire prévue, ce qui augmenterait les risques d'accident, endommagerait des biens matériels ou blesserait quelqu'un. Correction : Les concessionnaires devront remplacer le module du système de contrôle de la stabilité.

Données canadiennes mises à jour : 24 août 2026

• ENGINE AND ENGINE COOLING:EXHAUST SYSTEM:MANIFOLD/HEADER/MUFFLER/TAIL PIPE#18V309000en anglais seulement13 mai 2018

  Motor Coach Industries (MCI) is recalling certain 2011-2016 D4500, D4505, D4000, D4005, and D4000 ISTV motor coaches equipped with ISX engines. Due to vibrations, the exhaust bellow pipes develop a hole.

  Risque: If the pipe develops a hole, during a regeneration cycle, hot exhaust gases may leak out, increasing the risk of a fire.

  Correctif: MCI will notify owners, and dealers will replace the bellows pipe assembly with an improved part, free of charge. The recall began July 10, 2018. Owners may contact MCI customer service at 1-800-241-2947.

• ENGINE AND ENGINE COOLING:EXHAUST SYSTEM#17V337000en anglais seulement24 mai 2017

  Motor Coach Industries (MCI) is recalling certain 2011-2012 MCI D4000, D4005, D4500 and D4505 coaches equipped with Cummins ISX 12 liter engines. The vehicles may have an incorrectly installed exhaust bellow pipe, resulting in a bend in the pipe which can cause its premature failure.

  Risque: If the pipe fails and a diesel regeneration cycle occurs, the hot exhaust gases will increase the risk of a fire.

  Correctif: MCI will notify owners and dealers will inspect and replace any deformed or failed bellow pipes if necessary, free of charge. The recall began on June 15, 2017. Owners may contact Motor Industries at 1-800-241-2947. MCI's number for this recall is SB 397B.

• SEATS#16V020000en anglais seulement20 janvier 2016

  Motor Coach Industries (MCI) is recalling certain model year 2011-2013 and 2015 J4500 coaches manufactured November 18, 2011, to July 10, 2015, 2011-2012 and 2014-2015 D4000 coaches manufactured manufactured September 24, 2010, to September 5, 2015, 2011-2013 and 2015-2016 D4005 coaches manufactured January 17, 2011, to November 23, 2015, 2012-2014 and 2016 D4000ISTV coaches manufactured July 18, 2012, to December 2, 2015, 2010-2016 D4500 coaches manufactured April 15, 2010, to December 18, 2015 and 2011-2016 D4505 coaches manufactured December 15, 2010, to December 4, 2015. The affected buses are equipped with certain Recaro Ergo-M Commercial Bus Driver Seats that have J-Brackets that may be missing welds which could allow the seat belt anchorage assembly to separate from the J-Bracket.

  Risque: If the seatbelt anchorage assembly separates from the J-Bracket, the bus driver may not be properly restrained in the event of a crash increasing their risk of injury.

  Correctif: MCI will notify owners and dealers will inspect the seats and determined if welds are missing. Any J-Bracket that is missing welds will be removed and replaced, free of charge. The recall began on February 15, 2016. Owners may contact MCI at 1-800-241-2947. MCI's number for this recall is SB 431.

• ENGINE AND ENGINE COOLING:ENGINE#15V276000en anglais seulement12 mai 2015

  Motor Coach Industries (MCI) is recalling certain model year 2011-2012 D4000 motorcoaches manufactured November 12, 2011, to July 11, 2012, and 2014-2015 D4500 motorcoaches manufactured July 4, 2014, to April 30, 2015. Excessive engine crankcase pressures may cause the 90-degree elbow of the vent tube assembly to detach from the crankcase ventilation breather, possibly allowing engine oil to come into contact with hot surfaces.

  Risque: If the engine oil comes into contact with a hot surface, it can increase the risk of a vehicle fire.

  Correctif: MCI will notify owners, and Cummins service centers will administer the repairs which include securing the ends of the 90-degree elbow and reprogramming the electronic control module (ECM) with software that can adjust the engine output under misfire conditions to limit crankcase pressures. These repairs will be performed free of charge. The recall began on June 18, 2015. Owners may contact MCI customer service at 1-800-241-2947 or Cummins Inc. at 1-800-343-7357. MCI's number for this recall is SB 423.

• ENGINE AND ENGINE COOLING:ENGINE#14V085000en anglais seulement28 février 2014

  Motor Coach Industries, Inc. (MCI) is recalling certain model year 2011-2012 D4000 motorcoaches manufactured March 2011 through July 2012 and equipped with certain Cummins Westport model ISL G. Condensation in the intake manifold may freeze during cold weather conditions and interfere with the proper operation of the intake manifold pressure sensor.

  Risque: The improper operation of the sensor could induce elevated exhaust temperatures or flames from the exhaust pipe, increasing the risk of a vehicle fire or burn injury to a person near the exhaust pipe.

  Correctif: MCI will notify owners, and authorized Cummins service facilities will upload a new ECM calibration, free of charge. The recallbegan on April 16, 2014. Customers may contact MCI at 1-847-285-2090 or Cummins Inc. at 1-800-343-7357. MCI's number associated with this campaign is 405.

• ENGINE AND ENGINE COOLING:EXHAUST SYSTEM#13V142000en anglais seulement16 avril 2013

  Motor Coach Industries (MCI) is recalling certain model year 2012-2013 D4000, D4000ISTV, D4005, D4500, and D4505 motorcoaches manufactured from May 2012 through December 2012 and equipped with a Cummins ISX EPA 2010 engine. In the affected buses, the bellows pipe in the exhaust system may have been incorrectly assembled, which could result in a failure of the pipe during operation.

  Risque: During a regeneration process to clean exhaust emissions, if the bellows pipe has failed, the hot exhaust gases may not be contained, resulting in a fire.

  Correctif: MCI will notify owners and dealers will inspect and replace the bellows pipes, as necessary, free of charge. The recall began on April 29, 2013. Customers may contact MCI at 1-847-285-2000.

• ELECTRONIC STABILITY CONTROL (ESC)#11V524000en anglais seulement26 octobre 2011

  MOTOR COACH INDUSTRIES (MCI) IS RECALLING CERTAIN MODEL YEAR 2003, AND 2007-2012 E AND J MODELS ALONG WITH MODEL YEAR 2007-2012 D4000, D4005, D4500, D4505, D4000ISTV MOTOR COACHES EQUIPPED WITH MERITOR WABCO ELECTRONIC STABILITY CONTROL (ESC) MODULES, MANUFACTURED FROM OCTOBER 2002, THROUGH OCTOBER 2011. UNDER CERTAIN ROAD AND DRIVING CONDITIONS, VEHICLE BODY ROLL AND ROAD INCLINATION CHARACTERISTICS MAY ADVERSELY AFFECT THE SLIP ANGLE CALCULATION OF THE ELECTRONIC STABILITY CONTROL (ESC) SYSTEM. THIS MIGHT CAUSE THE ESC TO PERCEIVE AN OVER STEERING SITUATION AND THEREFORE APPLY THE OUTER WHEEL BRAKE ON THE FRONT AXLE UNTIL THE VEHICLE IS PERCEIVED TO BE STABLE.

  Risque: IF THE DRIVER IS SLOW TO REACT DURING THIS ESC INTERVENTION, THE VEHICLE MAY DEVIATE FROM THE INTENDED LINE OF TRAVEL, INCREASING THE RISK OF A CRASH.

  Correctif: MCI WILL NOTIFY OWNERS AND REPLACE THE CONTROL MODULE FREE OF CHARGE. THE SAFETY RECALL BEGAN ON JANUARY 4, 2012. OWNERS MAY CONTACT MCI CUSTOMER SERVICE AT 1-800-241-2947.